The friction material used on the Evora GT front and rear brake pads no longer meet the legislation requirements in certain USA States. This legislation affects vehicles with the current brake pads fitted built after the 1st January 2021. New brake pads that meet the latest legislation requirements are available for Evora GT vehicles. Replace front and rear brake pad sets as stated on Service Bulletin 2023/06
A limited VIN range of vehicles have left the factory without the latest level .crp programs being installed within the ECU (Electronic Control) and TCU (Transmission Control) units.
On a small number of Evora 400 vehicles, when activated at the same time, the turn indicator function is not overriding the brake lamp illumination. This has resulted in the brake lamp still being illuminated at a lower intensity (instead of being extinguished) during the turn indicators "off" cycle
Revised fault code generation strategies issued for certain O2 sensor and Coolant Temp Sensor diagnostics. Currently a fault code may not be immediately generated or the MIL illuminated in the event that a fault has occurred. In extreme instances this may result in drivability issues such as: - Vehicle poor starting or non-starting. - Excessive engine rpm at idle. - Vehicle unable to re-start if the engine is stopped with the fault still present. - Unable to select D ? Drive or R ? Reverse if the engine idle speed is above 2000 rpm (automatic models only). - An increase in the brake pedal effort required to slow or stop the vehicle (automatic models only). The revised diagnostic strategy for this issue is now more robust, ensuring that potential issues are more promptly detected, hence reducing the risk of the driveability issues described above from occurring.
Lotus: Some vehicles, under warranty, have illumination of the anti[lock braking system (abs) accompanied by generation of diagnostic code c0340, even though some brake light switches exhibited sticking plungers. Model elise/evora, exige s. No years listed. *pe
Lotus: Potential causes of deactivation of cruise control, without driver's intervention: Brake pedal is depressed, clutch pedal is depressed, or cruise control on;off/cancel button is pressed. Model. Evora, elise, exige. No model years. *pe
Lotus: Due to fault code c0460 (pressure sensor failure) tail lamp of abs (antilock braking system) will illuminate and a potential cause is brake light switch plunger incorrectly set. Model elixe, exige, evora. No model years. *pe
An ECU.crp program update is now available for all Federal Evora 2021 model year vehicles to ensure that they meet the current emissions diagnostic requirements.
Because of the revised electrical systems and subsequent increased demands placed on the vehicle battery on the Evora 400 as compared to the previous Evora N/A & S models, the 100 Amp rated alternator originally fitted has been replaced with an uprated 150 amp version as a production running change to ensure consistent battery performance.
To increase its durability, the single piece steel vvt pipe originally fitted as a production running change to all evora s and s-ips models from 12my vin ch_10159 is now further retained to the engine assembly by the use of an additional fixing.
To increase its durability, the single piece steel vvt pipe originally fitted as a production running change to all evora s and s-ips models from 12my vin ch_10159 is now further retained to the engine assembly by the use of an additional fixing.
To increase its durability, the single piece steel vvt pipe originally fitted as a production running change to all evora s and s-ips models from 12my vin ch_10159 is now further retained to the engine assembly by the use of an additional fixing.
To increase its durability, the single piece steel vvt pipe originally fitted as a production running change to all evora s and s-ips models from 12my vin ch_10159 is now further retained to the engine assembly by the use of an additional fixing.
Lotus: Srs has incorrect data information and depending on nature of srs situation, fault finding and diagnosis problem may be difficult to achieve. *pe
Lotus: With running changes implemented, the bulkhead is retained mechanically by using existing fixings and addition of m6 washers for c level carpet. *pe
Lotus: Information on assembly drain tubes modification for water ingressed exit via inlet duct and restricting airflow and dirt from entering hvac unit through same tubing. *pe
出典:NHTSA(米国、パブリックドメイン)、カナダ運輸省(Open Government Licence – Canada)、DVSA(英国、Open Government Licence v3.0)、RappelConso および EU Safety Gate(フランス、Licence Ouverte 2.0)、国土交通省(日本、公共データ利用規約1.0)、韓国国土交通部(car.go.kr)。