特定のイグニッションスイッチでは、一部の接点部分に過剰なグリスが塗布されていました。
一部のイグニッションスイッチでは、一部の接点に過剰な量のグリスが塗布されていました。このような状態で使用された車両の場合、グリスが炭化し、その結果として火災のリスクが高まるおそれがあります。
🔔 無料アカウントを作成して Mazda 626 (すべての世代) のメール通知を受け取る
一部のイグニッションスイッチでは、一部の接点に過剰な量のグリスが塗布されていました。このような状態で使用された車両の場合、グリスが炭化し、その結果として火災のリスクが高まるおそれがあります。
over time, the contact points inside the ignition switch may become carbonized and become conductive to electricity. Translation in Japanese: 時間の経過とともに、イグニッションスイッチ内部の接点が炭化し、電気を通しやすくなる場合があります。その結果、イグニッションスイッチが過熱し、火災の危険につながるおそれがあります。
点火スイッチの接点間に炭化グリースがたまり、スイッチ内部の絶縁性能が低下することがあります。この状態でスイッチは熱を発生させ、煙が発生し、最悪の場合は火災につながる可能性があります。
電気接点の過剰なグリースが炭化してイグニッションスイッチが閉じてしまうこと。
Fuel tank fixing band retention is not sufficient, allowing the band to rub against the fuel tank by vehicle vibrations.
カムシャフト駆動ベルトが切れ、エンジンが突然停止することがあります。
On certain vehicles, an external spring in the timing belt auto tensioner may break. The broken spring may get caught in the timing belt, resulting in possible engine stalling. Correction: Dealers will inspect the tensioner on affected vehicles and replace if necessary.
Vehicle description: Passenger vehicles. An external spring in the timing belt tensioner could break.
Certain vehicles do not comply with the requirements of CMVSS. 1103 - Exhaust Emissions. The average CO of the subject vehicles may exceed the standard due to insufficient robustness of emission control logic, and calibration of emission parts with extended usage. Correction: Dealers will install an engine intake kit, which will allow additional air to enter the engine, improving combustion efficiency and lowering the levels of carbon monoxide.
Certain vehicles do not comply with the requirements of CMVSS 1105 - Evaporative Emissions. Fuel vapour may leak from between the fuel cap and the fuel filler pipe. The gap could be generated by improper dimensions between the top ends of the inner and outer pipe of the fuel filler pipe. In some cases, raw fuel would be released into the atmosphere. Correction: Dealers will install a modified fuel cap o-ring.
On certain vehicles, an external spring in the timing belt auto tensioner may break. The broken spring may get caught in the timing belt, resulting in possible engine stalling. Correction: Vehicles will be inspected and affected tensioners will be replaced.
Vehicle description: Passenger vehicles. An external spring in the timing belt tensioner can break and get caught in the timing belt.
The engine may stop while driving and can not be restarted. The strength of the inner part of the spill valve on the fuel injection pump is insufficient and may fail as a result of repeated injection pressure. As a result fuel can not be injected into the combustion chambers.
Note: Vehicles equipped with 2.0 litre engine. The powertrain control module (pcm) may trigger a shift in air-fuel ratio to an over-lean condition resulting in an engine stall. This could lead to loss of vehicle control and a possible vehicle crash. Correction: Pcm will be reprogrammed with the correct engine control logic.
Vehicle description: Passenger vehicles. Due to a programming error, the powertrain control module (pcm) installed can, under certain driving conditions, trigger a shift in air-fuel ratio to an overlean condition.
At ambient temperatures below -18 degrees celsius, frost may accumulate within the throttle body under conditions of extended constant speed operation. This could result in a heavy accelerator pedal and cause uneven throttle valve return. Correction: The single stage engine coolant thermostat will be replaced with a dual stage thermostat equipped with a subvalve to increase the temperature within the throttle body. V.I.N. Range: Jm1gd3120j1500014 to jm1gd2226j1573252.
These vehicles may not comply with c.M.V.S.S. 124 -accelerator control systems. Vehicles equipped with electronic fuel injection.
出典:NHTSA(米国、パブリックドメイン)、カナダ運輸省(Open Government Licence – Canada)、DVSA(英国、Open Government Licence v3.0)、RappelConso および EU Safety Gate(フランス、Licence Ouverte 2.0)、国土交通省(日本、公共データ利用規約1.0)、韓国国土交通部(car.go.kr)。