SERVICE INFORMATION If one or more of these EVAP leak DTCs are stored (P0442, P0455, P0456) on a 2007 through 2011 Nissan vehicle, a loose fuel fill cap may be the cause. Use the following resources to perform diagnostics and confirm the cause of stored DTCs. ASIST: - Appropriate Service Manual diagnostic procedures - Applicable Technical Service Bulletins (TSB). Leak Test: - With CONSULT-III plus - WORK SUPPORT >> EVAP SYSTEM CLOSE. NOTE: Use Essential Tool J-42909 or equivalent to pressurize the EVAP system. - With a "Smoke" leak detection machine. Refer to the machine's Operator's Manual for proper use. Make sure the customer is informed of the proper fuel filler cap installation.
IF YOU CONFIRM: There is a noise (clunking, popping, or bumping) when the steering wheel is turned AND the noise is coming from the top of either front strut assembly. NOTE: The location of the noise can be determined by using Essential Tool J39570 (Chassis Ear), positioning a clamp on each front strut spring, and then turning the steering wheel back and forth. ACTION: Install a spacer in both the left front and right front strut assemblies where shown in this bulletin. - Refer to the Electronic Service Manual (ESM), section FSU- Front Suspension for removal and installation instructions. See this bulletin for further detail.
Nissan: A loose fuel fill cap is the cause of evap leak dtcs (p0442, p0455, p0456) stored on some vehicles. Model years 2007-2011. Model not listed. *pe
Nissan: Navigation map data update matrix. Affecting all vehicles 2003-11 except leaf, equipped with navigation system. Customer is mailed update disc(s) or sd card and installs data; dealership is mailed update disc(s) and the dealership installs data when vehicle is brought in. *pe
2015 Juke; MIL on with DTC for rear oxygen sensor
Wait, I need to translate the text, not repeat it. Here is the translation:
2015年式 Juke; rear oxygen sensorのDTCにより MIL点灯
NISSAN CONNECT NAVIGATION SYSTEM SOFTWARE UPDATE This bulletin has been amended. See AMENDMENT HISTORY on page 9. Please discard previous versions of this bulletin.
IF YOU CONFIRM If all of these conditions are met: * Vehicle is push-button Intelligent Key (I-Key) equipped * Vehicle is 6speed Manual transmission model * Vehicle falls within VIN range * Vehicle has DTC B261F stored in the Body Control Module (BCM) * Amber (Yellow) I-Key indicator is on And **** Customer "may" indicate that the ignition switch is not responsive ACTION If the conditions under "IF YOU CONFIRM" are met, replace BCM with the part listed in this bulletin. Please see this bulletin for further details.
SERVICE INFORMATION When the headlamp switch is set to the AUTO position, AND the fog lamp switch is turned ON, ... the fog lamps and headlamps are designed to come on, regardless of ambient lighting. If the customer would prefer that both the headlamps and fog lamps not come on during daylight conditions while in AUTO mode, perform the steps in this bulletin to disable the fog lamp override feature. See this bulletin for more detail.
IF YOU CONFIRM One or more of the following DTCs has set: * P0037 - HO2 HTR (B1) (Heated oxygen sensor 2 heater control circuit low) * P0038 - HO2 HTR (B1) (Heated oxygen sensor 2 heater control circuit high) * P0137 - HO2S2 (B1) (Heated oxygen sensor 2 circuit low voltage) * P0138 - HO2S2 (B1) (Heated oxygen sensor 2 circuit high voltage) * P0139 - HO2S2 (B1) (Heated oxygen sensor 2 circuit slow response) * P2096 - POST CAT FUEL TRIM SYS B1 (Post catalyst fuel trim system too leanbank 1) * P2097 - POST CAT FUEL TRIM SYS B1 (Post catalyst fuel trim system too rich bank 1) ACTION 1. Refer to step 6 in the SERVICE PROCEDURE to confirm this bulletin applies to the vehicle you are working on. If this bulletin applies: 2. Replace the rear O2 sensor. 3. Reprogram the ECM See this bulletin for further detail.
IF YOU CONFIRM On an Applied Vehicle, one or more of the following is occurring: * A status message "Update Failed !" is displayed with a direction to "Insert update media" while a countdown from 60 is displayed. The audio system then reboots (Nissan Logo appears), and then will restart the countdown. * The center display screen (navigation screen) intermittently goes blank (nothing is displayed) for a few seconds or longer and then returns to normal display. * Continuously reboots (Nissan Logo appears after a loss of soundor freeze condition). * XM channel selection is sometimes not working as normal or shows "XM loading" for long periods of time. * Audio sometimes is not working. * Soundlevels for balance, fader, treble,or bass do not correspond to what is displayed by the audio unit after the ignition is cycled. * Connected iPod freezes after using "Source" button or changing tracks. * Audio preset buttons do not respond when selected. * Calls unintentionally change from "hands free" to "handset". And * The Software version has been confirmed as "not current" (refer to page 3). See this bulletin for further details.
NISSAN CONNECT NAVIGATION SYSTEM SOFTWARE UPDATE This bulletin applies only to vehicles equipped with a navigation system. This bulletin has been amended. See AMENDMENT HISTORY on page 9. Please discard previous versions of this bulletin.
2016-2018 NISSAN CONNECT NAVIGATION SYSTEM SOFTWARE UPDATE TO RESOLVE SEVERAL ISSUES This bulletin has been amended. The IF YOU CONFIRM section and software number has changed. No other changes have been made. Please discard previous versions of this bulletin.
2016-2017 NISSAN CONNECT NAVIGATION SYSTEM SOFTWARE UPDATE This bulletin applies only to vehicles equipped with navigation system. This bulletin has been superseded to NTB18-031. Please discard all previous versions of this bulletin.
BLUETOOTH, USB, AND AUX FUNCTION DIAGNOSTIC TOOL SERVICE INFORMATION The Enhanced Multi-Media Interface Tester (EMMIT) J-51922 is a new special tool that tests the functionality of the following features: Bluetooth o Pairing/Connecting o Phonebook Access Profile o Hands Free Profile (for calls) o Bluetooth Audio test o Message Access Profile (for text messages, if so equipped) USB o Tests USB music playback o Tests USB music browsing capability AUX o Tests AUX Jack playback Use EMMIT to diagnose symptoms related to Bluetooth, USB, and AUX. If EMMIT passes diagnostic tests, the symptom is caused by the customer?s phone and not caused by the AV control unit. DO NOT replace the AV control unit. NOTE: If an AV control unit is replaced for multi-media issues that can be tested with EMMIT, a printed copy of the EMMIT diagnostic results must be included with the returned unit. See page 2 for more information about the EMMIT tool.
20172016-2017 NISSAN CONNECT NAVIGATION SYSTEM SOFTWARE UPDATE This bulletin applies only to vehicles equipped with navigation system. This bulletin has been amended. The APPLIED VEHICLES section has been revised. No other changes have been made. Please discard previous versions of this bulletin.
20172016-2017 NISSAN CONNECT NAVIGATION SYSTEM SOFTWARE UPDATE This bulletin only applies to vehciles equipped with navigation system. This bulletin has been amended. The APPLIED VEHICLES section has been revised. No other changes have been made. Please discard previous versions of this bulletin.
2015 JUKE; MIL ON WITH DTC FOR REAR OXYGEN SENSOR This bulletin has been amended. Additional information has been included in Step 19. No other changes have been made. Please discard previous versions of this bulletin.
"2015 juke; engine turns off or hesitates when accelerating from a stop during hot ambient temperatures (+100f) if you confirm the engine turns off or hesitates when accelerating from a stop during hot ambient temperatures (+100f), and the engine is able to be restarted. Action 1. Refer to step 6 in the service procedure to see if this bulletin applies to the vehicle you are working on. 2. If this bulletin applies, reprogram the ecm."
Nissan: See document search button for owner letter. On some model year vehicles, the door handle latch assembly on the front outside, needs special grease and seals to prevent from freezing. *pe updated 7/27/12. *pe
Nissan: Information regarding the front door internals side satellite sensor and pre existing side air bag satellite sensor in pillars in some vehicles. *pe
Nissan: Affecting all nissan with abs or abs/vdc. Depending on the vehicles, there would be noise coming from the engine, such as clicking, clunking, buzzing thumping or knocking, when ignition cycle is off and then on. The noise is brief and can happen on acceleration. *pe
出典:NHTSA(米国、パブリックドメイン)、カナダ運輸省(Open Government Licence – Canada)、DVSA(英国、Open Government Licence v3.0)、RappelConso および EU Safety Gate(フランス、Licence Ouverte 2.0)、国土交通省(日本、公共データ利用規約1.0)、韓国国土交通部(car.go.kr)。