閲覧無料 · 投稿は無料アカウントでAnticars(2000年)の後継

Nissan パトロール

1960– · 7 世代 · 不具合9件 · 9市場
世代

Nissan パトロール のすべての世代をまとめて:不具合、リコール、サービス情報、ディスカッション。世代を選ぶと絞り込めます。

重大な不具合

すべて表示 (9) →
m

Automatic emergency braking: problems reported by owners

28 owners in the United States reported problems with the automatic emergency braking of this car to NHTSA (model years 2010–2022), typically at around 40,000 miles. Most often named: automatic emergency braking (57%), warnings (46%). Reported consequences: 4 crashes, 4 injuries.

✓ 公的データに基づくMecafileの分析2010–2022原文(英語)で表示中 · 翻訳待ち詳細を見る →

最新の公式リコール

すべて表示 (52) →
パトロール VI · 2010–2026パトロール VII · 2024–
リコール軽微サスペンションNA

Label

Issue: On certain vehicles, the compliance label may list the wrong gross axle weight rating (GAWR) information. This could lead you to overload the vehicle and cause poor handling or a tire failure. Note: This recall only affects models equipped with 22-inch wheels. Safety Risk: Poor handling or a tire failure could cause a loss of vehicle control and result in a crash. Corrective Action: The company will notify owners by mail and provide you with a new compliance label. If you'd like help to install it, you can contact a dealer to have it installed free of charge.

カナダ運輸省2026年7月15日2026344モデルイヤー 2021–2026原文(英語)で表示中 · 翻訳待ち詳細を見る →
パトロール VI · 2010–2026パトロール VII · 2024–
リコール軽微サスペンションNA

Equipment:Other:Labels

Nissan North America, Inc. (Nissan) is recalling certain 2020-2026 Nissan Armada, 2011-2013 Infiniti QX56, and 2014-2027 QX80 vehicles equipped with 22" wheels. The Gross Axle Weight Rating (GAWR) listed on the certification label is incorrect, which can allow the vehicle to be overloaded. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 110, "Tire Selection and Rims."

NHTSA · 米国2026年7月15日26V455000モデルイヤー 2020–2026原文(英語)で表示中 · 翻訳待ち詳細を見る →
パトロール VII · 2024–
リコール軽微トランスミッションNA

Visual System

Issue: On certain vehicles, a software problem could cause infotainment system display to remain blank when the vehicle is started. As a result, when the transmission is shifted into reverse gear, the rearview camera image would not appear on the display. Note: This recall only affects certain trim levels. Safety Risk: A rearview camera image that doesn't display could reduce a driver's ability to see behind the vehicle while backing up. This could increase the risk of a crash. Corrective Actions: The company will notify owners by mail and advise you to take your vehicle to a dealership to update the infotainment system software.

カナダ運輸省2025年11月26日2025656モデルイヤー 2025–2026原文(英語)で表示中 · 翻訳待ち詳細を見る →

最新の技術サービス通報

すべて表示 (89) →
パトロール VII · 2024–
技術通報軽微電装NA

技術通報

AEB WARNING WITH U2752-88 STORED IN ADAS CONTROL UNIT 2 AND/OR U275F-88 STORED IN THE DISTANCE SENSOR CONTROL UNIT IF YOU CONFIRM The AEB warning was displayed, and one or more of the following DTCs are stored as Current: U2752-88 for Ethernet circuit stored in the ADAS control unit 2. U275F-88 for Ethernet circuit stored in the Distance Sensor control unit. HINT: The ESM shows U275F-88 as being stored in the LASER/RADAR control unit and in CONSULT 4 it is displayed as Distance Sensor. ACTION 1. Confirm the current Distance Sensor control unit part number. 2. Reprogram the Distance Sensor control unit, if applicable.

NHTSA · メーカー通報11024398モデルイヤー 2025原文(英語)で表示中 · 翻訳待ち詳細を見る →
パトロール VII · 2024–
技術通報中程度ボディNA

技術通報

ECM REPLACEMENT PROCEDURE REQUIRED FOR RES EQUIPPED VEHICLES SERVICE INFORMATION If any of the APPLIED VEHICLES equipped with Remote Engine Start (RES) requires Engine Control Module (ECM) replacement, the Body Control Module (BCM) must be replaced also at the same time. If you are not familiar with the Re/programming, Configuration procedure, refer to the Electronic Service Manual (ESM) and the CONSULT Operation Manual to reprogram the Electronic Control Unit (ECU). Follow all precautions in both manuals to prevent possible personal injury or death and/or damage to the ECU. This procedure will go back and forth between the ECM and BCM steps as found in the ESM. Damage will occur requiring the ECM and the BCM to be replaced a second time if the following SERVICE PROCEDURE is not followed. Perform the following steps from the Electronic Service Manual (ESM) in this order: A. Perform Work Procedure (Before Replacing ECM) to save the ECM data. B. Remove the ECM. C. Remove the BCM. D. Install the new BCM and then perform Additional Service When Replacing BCM - Work Procedure up to and including Register of Vehicle Identification Number. E. Install the new ECM and then perform Additional Service When Replacing ECM - Work Procedure (After Replacing ECM) up to and including Writing MAC Key for ECM. F. Complete the Additional Service When Replacing BCM - Work Procedure. G. Complete the Additional Service When Replacing ECM - Work Procedure (After Replacing ECM).

NHTSA · メーカー通報11015916モデルイヤー 2025原文(英語)で表示中 · 翻訳待ち詳細を見る →
パトロール VI · 2010–2026
技術通報中程度電装NA

技術通報

3G TELEMATICS HARDWARE DEACTIVATION SERVICE INFORMATION The APPLIED VEHICLES that come equipped with a factory installed SOS switch, located near the overhead map lamp, also come equipped with a wireless communication device called a Telematics Communication Unit (TCU). AT&T discontinued its U.S. 3G network coverage on February 22, 2022. As a result, automakers that utilize AT&Ts 3G network connection, including Nissan Group, have had connectivity services affected. NissanConnect Services are no longer available on the APPLIED VEHICLES listed above.

NHTSA · メーカー通報10227267モデルイヤー 2018原文(英語)で表示中 · 翻訳待ち詳細を見る →

最新のフォーラム

まだディスカッションはありません。

不具合とディスカッションは世代ごとに整理されています。投稿するには上で世代を選んでください。

出典:NHTSA(米国、パブリックドメイン)、カナダ運輸省(Open Government Licence – Canada)、DVSA(英国、Open Government Licence v3.0)、RappelConso および EU Safety Gate(フランス、Licence Ouverte 2.0)。