On certain vehicles, the driver frontal airbag inflator could produce excessive internal pressure during airbag deployment. Increased pressure may cause the inflator to rupture, which could allow fragments to be propelled toward vehicle occupants, increasing the risk of injury. This could also damage the airbag module, which could prevent proper deployment. Failure of the airbag to fully deploy during a crash (where deployment is warranted) could increase the risk of personal injury to the seat occupant. Correction: Dealers will replace the driver airbag inflator on Saab 9-3 and 9-5 vehicles and replace the driver airbag module on Saturn Astra vehicles.
Certain passenger vehicles equipped with b308 6-cylinder gasoline engines may experience overheating and burnout of the isolated gated bipolar transistor (igbt) within the ignition discharge module (idm) due to increased susceptibility to electrical loads.
Certain 2000-2002 Saab 9-3 and 9-5 model vehicles equipped with 4-cylinder gasoline engines, and 2001-2003 9-5 models equipped with 6-cylinder gasoline engines may experience overheating and burnout of the Isolated Gated Bipolar Transistor (IGBT) within the Ignition Discharge Module (IDM) due to increased susceptibility to electrical loads. Overheating of the IGBT occurs most often at engine start-up but may also occur while the engine is running. When the IDM fails on a 4-cylinder while it is running, the engine may stall without warning, with no ability to be restarted. When the IDM fails on a 6-cylinder engine while it is running, the driver will initially experience reduced power and rough operation because the engine will only be running on three cylinders. The check engine light will flash. If the driver continues, unburnt fuel in the exhaust can cause thermal damage to the catalytic converter. The engine may stall and not restart. Correction: Dealers will inspect and, if required, replace the IDM.
Certain passenger vehicles equipped with b205/b235 4-cylinder gasoline engines and b308 6-cylinder gasoline engines may experience overheating and burnout of the isolated gated bipolar transistor (igbt) within the ignition discharge module (idm) due to increased susceptibility to electrical loads.
On certain passenger vehicles, if an owner changes their wheels/tires between summer and winter using a steel wheel in the winter and an alloy wheel in the summer, it is possible for rust and contamination to build up on the wheel hub during the steel wheel usage. If this occurs and the contamination is not removed, it is possible that after the tire change service, some of this contamination could flake or grind away resulting in reduced clamping force of the wheel to the hub. Over several seasons, it is possible that this reduced force could result in fractures developing in the wheel bolts due to wheel to hub movement.
Saab is recalling 57,389 my 2002-2008 9-5 series vehicles for failing to comply with the requirements of federal motor vehicle safety standard no. 201, "occupant protection in interior impact." during compliance testing, one of the upper interior occupant protection test points exceeded the standard's requirements.
On certain vehicles, when changing back and forth between alloy and steel wheels (as for winter tires), rust and other contaminates may build up on the mating surface of the wheel hubs. If this surface is not cleaned between wheel changes, uneven torque forces may cause wheel bolts to fracture. Although this is most likely to happen during wheel change service, it is possible that the bolts may break later while the vehicle is being driven. Correction: Dealer will clean the hub and reinstall the wheel with improved bolts and attached washers that will eliminate the clamping force reduction.
出典:NHTSA(米国、パブリックドメイン)、カナダ運輸省(Open Government Licence – Canada)、DVSA(英国、Open Government Licence v3.0)、RappelConso および EU Safety Gate(フランス、Licence Ouverte 2.0)、国土交通省(日本、公共データ利用規約1.0)、韓国国土交通部(car.go.kr)。