閲覧無料 · 投稿は無料アカウントでAnticars(2000年)の後継

Smart ツー III

2014–2019 · 不具合4件 · 2市場

このファイルには、Smart ツー IIIで知られている不具合を、コミュニティが出典付きでまとめています。閲覧は無料、投稿には無料アカウントが必要です。信頼できる投稿者が十分に確認した不具合にはシールが付きます。

この車ではengineの問題がよく報告されています(苦情15件)が、原因はまだ誰も説明していません。ご存じですか?項目を書く
この車ではelectrical systemの問題がよく報告されています(苦情15件)が、原因はまだ誰も説明していません。ご存じですか?項目を書く

重大な不具合

すべて表示 (4) →
m
重大エンジンNA

Engine: problems reported by owners

15 owners in the United States reported problems with the engine of this car to NHTSA (model years 2014–2017), typically at around 12,000 miles. Reported consequences: 1 crash, 2 fires, 6 injuries.

✓ 公的データに基づくMecafileの分析2014–2017原文(英語)で表示中 · 翻訳待ち詳細を見る →
m
重大電装NA

Electrical system: problems reported by owners

15 owners in the United States reported problems with the electrical system of this car to NHTSA (model years 2014–2019), typically at around 6,000 miles. Reported consequences: 1 crash, 1 fire, 5 injuries.

✓ 公的データに基づくMecafileの分析2014–2019原文(英語)で表示中 · 翻訳待ち詳細を見る →

最新の公式リコール

すべて表示 (32) →
リコール中程度ボディEU

La liaison adhésive entre la section du toit et le cadre du toit peut devenir faible au fil du temps

La liaison adhésive entre la section du toit et le cadre du toit peut devenir faible au fil du temps. en conséquence, le toit pourrait se détacher complètement du véhicule, augmentant ainsi le risque d’accidents et de blessures pour les autres usagers de la route.

Safety Gate · EU · RappelConso · フランス2023年8月7日a12/01071/21モデルイヤー 2020原文(フランス語)で表示中 · 翻訳待ち詳細を見る →
リコール重大ボディEU

Le pare-brise peut être mal collé et se détacher du corps de la voiture en cas d’accident

Le pare-brise peut être mal collé et se détacher du corps de la voiture en cas d’accident. l’airbag passager déployé dans ce cas ne pouvait pas être soutenu par le pare-brise comme prévu. par conséquent, l’effet de retenue de l’airbag passager pourrait être altéré, ce qui augmente le risque de blessures.

Safety Gate · EU · RappelConso · フランス2023年8月7日a12/01245/21モデルイヤー 2020原文(フランス語)で表示中 · 翻訳待ち詳細を見る →

最新の技術サービス通報

すべて表示 (61) →
技術通報軽微ボディNA

技術通報

Complaint Clanking noise from the area of the speakers in the doors. Cause Under analysis. Remedy To narrow down the cause, first of all remove the door trim. If the noise continues to occur even with the door trim removed, then continue the diagnosis working towards the speaker and if necessary, create a TIPS case with an informative video as an attachment. Note: Please refer to this document in the warranty claim and, once diagnosis is completed, select the damage code depending on the component part that is causing the issue. If the noise stops when the door trim is removed, please proceed in accordance with LI72.10P067691. Information: In this case, do not use a damage code for the speakers in the warranty claim!

NHTSA · メーカー通報11038217モデルイヤー 2017原文(英語)で表示中 · 翻訳待ち詳細を見る →
技術通報中程度ブレーキNA

技術通報

Complaint Repeat workshop visit for vehicle vibration while braking from 60MPH. NOTE: Although the symptom is similar to a tire or wheel vibration, it is usually readily noticeable that it is distinctly different if it happens at all times or only while braking. Cause Although the cause of the vibration is most likely due to excessive lateral runout on the rotor or hub/wheel bearing, the system as a whole needs to be checked for other possible contributors. 1. Prior collision damage. 2. Excessive vehicle sitting times without rotating components. 3. Wheel bearing/hub lateral runout. 4. Wheel mating interface has been overtightened (did not follow WIS torque procedures). 5. Mating interfaces have been excessively modified (painted, gouged, bent, etc...). Remedy Read through the entire attached worksheet prior to performing. After performing, please review the final page and perform work accordingly. NOTE: This document is not preauthorization or otherwise dealing with warranty. This is intended for diagnostic purposes only. If there are any questions on how to proceed OR The work sheet has been performed and the vehicle has returned with the same concern. Please perform the measurements as seen in the worksheet again and open a TIPS case to the Body, Chassis, and Entertainment team.

NHTSA · メーカー通報11038186モデルイヤー 2017原文(英語)で表示中 · 翻訳待ち詳細を見る →
技術通報中程度サスペンションNA

技術通報

Complaint Noises in the steering column area when steering. See example file in the attachments area: "MRSMSchleifgerusch_SCCMGrindingNoises. MOV". Cause Under analysis. Remedy Check which area of the steering column the noises occur in. Do the noises tend to occur at the bottom in the driver footwell or do they tend to occur in the area of the steering column switch module (MRSM/SCCM)? If the noises occur in the area of the MRSM/SCCM, work through the following points: Loosen screws of the MRSM/SCCM and steering wheel, realign the MRSM/SCCM, and refasten the screws (see WIS). Sometimes there is stress at the MRSM/SCCM and noises occur. If noises continue to occur, swap the MRSM/SCCM into a vehicle without any (noise) complaints. If the noises occur with the MRSM/SCCM complained about when it is in the vehicle without a complaint (donor vehicle), the MRSM/SCCM can be replaced. If noises also occur in the customer vehicle with the MRSM/SCCM from the reference vehicle, the MRSM/SCCM is not the cause and must not be replaced. Notes: When installing the MRSM/SCCM, make sure that no damage occurs! If the noise is due to the steering wheel (see attachment "LenkradSchleifgerusch_SteeringWheelGrindingNoises.mp4"), please use LI46.10P077313. Only disassemble and mount all component parts in the "straightahead position" (see also WIS). Please refer to this LI in the "Notes" section of the warranty claim!

NHTSA · メーカー通報11038183モデルイヤー 2019原文(英語)で表示中 · 翻訳待ち詳細を見る →

出典:NHTSA(米国、パブリックドメイン)、カナダ運輸省(Open Government Licence – Canada)、DVSA(英国、Open Government Licence v3.0)、RappelConso および EU Safety Gate(フランス、Licence Ouverte 2.0)。