무료 열람 · 무료 계정으로 기여Anticars(2000)의 후속

BMW X7

2018– · 결함 10건 · 5개 시장

기술 서비스 공지(TSB)는 제조사가 알려진 문제에 대해 딜러에게 보내는 수리 지침입니다. 안전 리콜은 아니지만 결함을 확인해 주는 경우가 많습니다.

연식
시장전체NA
공지보통기타NA

공지

차량이 이전에 HVAC 시스템을 수리한 후 난방 및 냉방(HVAC) 시스템에서 물이 카펫 위로 새는 현상이 발생합니다.

NHTSA · 제조사 공지11039090연식 2026자동 번역 · 원문: 영어자세히 보기 →
공지보통기타NA

공지

A small number of vehicles were produced without the evaporator condensate drain hose being installed.This is not immediately apparent to the customer. However, condensation water that has drained into thefront footwell can cause subsequent damage.

NHTSA · 제조사 공지11037846연식 2026원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지보통브레이크NA

공지

After replacement of the Integrated Braking system (IB)/Power Brake the total distance covered might belower than when handed over to the workshop for the repair.

NHTSA · 제조사 공지11036380연식 2024원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지보통전장NA

공지

Due to an implementation error in various OBD diagnostics in the vehicle's control units, in very rare cases itmay happen that stored fault memory codes (DTCs) and the MIL (warning light) are not automaticallydeleted even though the underlying malfunction has already been rectified. This does not comply with the statutory OBD specifications.

NHTSA · 제조사 공지11034449연식 2025원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지보통서스펜션NA

공지

When turning the steering wheel while stationary or when driving on uneven roads; cracking, creaking, or knocking noises may be heard.

NHTSA · 제조사 공지11031574연식 2024원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지보통브레이크NA

공지

It was determined that your vehicle was fitted with a brake booster that potentially has a faulty hydraulic valve. This may result in a modified pedal feel and a sporadic red Check Control message. The brake booster should be replaced.

NHTSA · 제조사 공지11030319연식 2025원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지보통기타NA

공지

Various external influences can cause premature aging of the tension strut hydro-mount elastomer; which can lead to cracks in the material, and leakage.

NHTSA · 제조사 공지11029047연식 2024원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지보통브레이크NA

공지

The wheel bearing and the brake disc are not correctly aligned; are not concentric (circled). When applicable work is being performed, it is therefore difficult to remove the wheel bolts from, or fasten them into the wheel bearing hub.

NHTSA · 제조사 공지11025672연식 2026원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지보통서스펜션NA

공지

When turning the steering wheel while stationary or when driving on uneven roads; cracking, creaking, or knocking noises may be heard.

NHTSA · 제조사 공지11021817연식 2024원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지보통서스펜션NA

공지

The seat lumbar system Massage will not function if the module needs to be initialized. This can occur toeither the drivers and/or passenger side seat. Here is a list of possible faults: Seat pneumatics module front right SPNM _ VR 025908 - SPNMVR: Control unit is not coded 02590B - SPNMVR: Control unit is not encoded for the vehicle 806927 - SPNMVR: Installation location not taught in Seat pneumatics module front left SPNM _ VL 025308 - SPNMVL: Control unit is not coded 02530B - SPNMVL: Control unit is not encoded for the vehicle 8067A7 - SPNMVL: Installation location not taught in Seat Module Driver FAS SMFA 80301E - No seat adjustment because of engine start conditions Seat Module Passenger BFS SMBF 802C1E - No seat adjustment because of engine start conditions Seat Module Drivers Side Rear FAH SMFAH 802E1E - No seat adjustment because of engine start conditions Seat Module Passenger Side Rear BFH SMBFH 802A1E - No seat adjustment because of engine start conditions

NHTSA · 제조사 공지11020931연식 2024원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지보통브레이크NA

공지

After programming from the I-Levels between 24-03-505 and lower than 24-03-540 to I-Level 24-11-530 or higher, the following CCM may be displayed: CCM-2525: Brake system. Drive at moderate speed

NHTSA · 제조사 공지11020910연식 2024원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지보통전장NA

공지

When navigation is selected, only the start animation with the text Starting navigation system... isdisplayed. The Navigation application does not start. This only applies to vehicles where Navigation hasbeen enabled and has been verified to work previously.

NHTSA · 제조사 공지11019572연식 2025원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지보통서스펜션NA

공지

The air line on the air suspension supply system may not be properly installed. In the event of a fault, residual pressure is maintained in the struts and corresponding check control message.

NHTSA · 제조사 공지11019565연식 2025원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지보통서스펜션NA

공지

The air line on the air suspension supply system may not be properly installed. In the event of a fault, residual pressure is maintained in the struts and corresponding check control message.

NHTSA · 제조사 공지11018563연식 2025원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지보통전장NA

공지

There is a jerking or shuddering during either or both of the following: Cornering or accelerating from low speeds Driving with low to medium loads There are no warning lights or Check Control messages.

NHTSA · 제조사 공지11016472연식 2020원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지보통브레이크NA

공지

After replacement of the Integrated Braking system (IB)/Power Brake the total distance covered might be lower than when handed over to the workshop for the repair.

NHTSA · 제조사 공지11013438연식 2024원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지보통브레이크NA

공지

After replacement of the Integrated Braking system (IB)/Power Brake the total distance covered might be lower than when handed over to the workshop for the repair.

NHTSA · 제조사 공지11013040연식 2024원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지보통브레이크NA

공지

Improved diagnostic software for the brake system.

NHTSA · 제조사 공지11008992연식 2024원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지보통브레이크NA

공지

Improved diagnostic software for the brake system.

NHTSA · 제조사 공지11008107연식 2024원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지보통전장NA

공지

Due to an installation error, the crankshaft sensor connector may not have been properly locked. In very rare cases, the plug connection may become disconnected. If no signal is sent by the crankshaftsensor, the engine will switch to emergency operation and a Check Control message will occur.

NHTSA · 제조사 공지11008104연식 2024원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지보통전장NA

공지

There is a jerking or shuddering during either or both of the following: Cornering or accelerating from low speeds Driving with low to medium loads There are no warning lights or Check Control messages.

NHTSA · 제조사 공지11006766연식 2023원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지보통전장NA

공지

Please have the starter motor checked and, if necessary, replaced in the vehicles concerned (according tothe vehicle identification number selection) if possible before vehicle delivery. If vehicles have already been delivered, please have the measure carried out the next time the vehiclesenter the workshop. A bolting fault on the long bolt screws can cause the magnets in the starter motor to twist. As a result, thepower of the starter motor decreases. As a result, the engine does not start.

NHTSA · 제조사 공지11006719연식 2024원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지보통전장NA

공지

There is a jerking or shuddering during either or both of the following: Cornering or accelerating from low speeds Driving with low to medium loads There are no warning lights or Check Control messages.

NHTSA · 제조사 공지11002858연식 2023원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지보통서스펜션NA

공지

Incorrect adjustment of the front and rear axles may result in steering wheel drift or increased tire wear onthe vehicle.

NHTSA · 제조사 공지11000635연식 2024원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지보통서스펜션NA

공지

At low outside temperatures (below 40 degrees F) and slow driving speeds (i.e. when parking, maneuvering)with a large steering angle, the front end can be slightly axially misaligned.

NHTSA · 제조사 공지11000563연식 2024원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
이전 →

출처: NHTSA(미국, 퍼블릭 도메인), 캐나다 교통부(Open Government Licence – Canada), DVSA(영국, Open Government Licence v3.0), RappelConso 및 EU Safety Gate(프랑스, Licence Ouverte 2.0), 일본 국토교통성(공공데이터 이용약관 1.0), 한국 국토교통부(자동차리콜센터 car.go.kr).