Fuel system, gasoline:Storage
On certain vehicles, variations in the manufacturing process or exposure to high ambient temperatures may lead to fracture of the fuel tank inlet check valve (icv).
🔔 무료 계정을 만들고 Chevrolet 벤처 (모든 세대) 이메일 알림 받기
On certain vehicles, variations in the manufacturing process or exposure to high ambient temperatures may lead to fracture of the fuel tank inlet check valve (icv).
On certain mini vans, passenger and sport utility vehicles, some of these vehicles have a driver's side air bag that may not deploy as designed. In addition, the air bag inflator could rupture.
특정 승용차, 미니밴 및 스포츠 유틸리티 차량(SUV)의 운전석 에어백 인플레이터가 전개 시 용접부에서 파열될 수 있습니다.
Vehicle description: Passenger, sport utility vehicles and minivans. The passenger air bag inflator modules were built without the correct amount of generant, which produces the gas that fills the air bag. Some were built with a double load of generant and some were built without generant.
Vehicle description: Mini vans with extended wheelbase. Some of these vehicles have inoperative fuel tank rollover valves and fuel leakage would exceed the permissible amount in a rollover test. This does not comply with the requirements of fmvss no. 301, "fuel system integrity."
On certain vehicles, ice may accumulate on the rear brake pipes located approximately under the driver's side floor mat. If a large amount of ice accumulates on the brake pipes, the weight of the buildup may pull the pipes away from the underbody of the vehicle which could cause the pipes to drag on the ground and be damaged. Damaged brake pipes could result in loss of brake fluid and reduced brake effectiveness. Correction: A brake pipe retainer clip will be installed to the underbody.
On certain Aztek (AWD), Montana (AWD), Relay (AWD), RendezVous (AWD), RendezVous (FWD), Silhouette (AWD), Terraza (AWD), Terraza (FWD), Uplander (AWD) and Venture (AWD) vehicles equipped with independent rear suspension, when operated in extreme cold temperature and on rough roads, water and salt can intrude past the ball joint seal. The combination of theses conditions may then lead to premature wear of the ball joint. If the ball joint wear progresses to the point of separation from the lower control arm, a loss of vehicle control may occur. Correction: Dealers will replace both ball joints with new ball joints which have a revised boot and ball stud to improve the seal to the ball stud shaft.
On certain minivans equipped with second-row bucket seats or captain's chairs and a power sliding door on the passenger side of the vehicle, a passenger using the interior handle to open the power sliding door could be injured.
On certain passenger, sport utility vehicles and mini vans, some of these vehicles have a passenger air bag that was manufactured without a check valve pin. An air bag without the check valve pin could produce increased pressure at the onset of the air bag deployment and reduced pressure afterward.
특정 승용차 및 미니밴의 파워 랙 앤 피니언 조립체에 있는 하단 피니언 베어링은 리테이너 탭이 제대로 압착되지 않은 상태로 장착되어 있습니다. 이 제품과 1996년 1월 1일부터 1997년 10월 31일 사이에 조립된 차량에 사용된 일부 다른 리테이너는 고장 나서 볼 베어링이 이탈할 수 있습니다.
Vehicle description: Certain mini vans built with second row 50/50 split bench seats or captain's chairs, fail to comply with the requirements of fmvss no. 225, "child restraint anchorage systems." the seat latch anchor wire diameter is greater than 6.1 mm.
Certain vehicles have an improperly programmed vehicle theft deterrent system. Correction: dealers will reprogram the system.
Vehicle description: 1997-2001 chevrolet venture, pontiac montana/transport, and oldsmobile silhouette mini vans equipped with passenger side power sliding doors that were serviced in campaign 01013 (01v-067) from april to august 2001. Also 2001 chevrolet venture, pontiac montana, and oldsmobile silhouette mini vans equipped with passenger side power sliding doors assembled in january through april 2001. These vehicles have inadequate front welds. If a front weld fails, the actuator can jam in the unlatched position and, when the sliding door closes, it will not be latched.
Vehicle description: Minivans equipped with passenger side power sliding doors. The door closes but may not be latched. If this happens, the power sliding door can open while the vehicle is in motion, particularly when the vehicle ascends a hill, makes a turn, or travels over a rough road surface.
Vehicle description: Passenger vehicles, light duty trucks, sport utility vehicles, and mini vans equipped with trw seat belt buckle assemblies. The buckle base of these seat belt assemblies were not properly heat treated and therefore do not pass the load bearing requirement of federal motor vehicle safety standard no. 209, "seat belt assemblies."
차량 중 염화칼슘(제설용 소금)을 많이 사용하는 지역에서 운행되는 일부 차량의 경우, 스페어 타이어 호이스트 케이블이 부식되어 결국 끊어질 수 있습니다. 이 경우 스페어 타이어가 차량에서 떨어져 다른 차량에 도로 위험 요소가 될 수 있습니다. 시정 조치: 해당 차량의 소유자에게 스페어 타이어 호이스트 케이블 조립체의 정비 및 점검 방법을 안내하는 서한이 발송됩니다. 또한 서한에는 점검 중 케이블이 끊어지는 경우 딜러가 해당 조립체를 수리해 준다는 내용이 포함됩니다. 이 정책은 2002년 12월 31일까지 시행됩니다.
Vehicle description: Passenger mini vans. The left and/or right front lower insulator to cradle center metal sleeve is collapsed, which can result in loss of clamp load in the joint. If the clamp load is reduced or lost, the bolt can be lost or broken and the joint can separate.
Note: Vehicles equipped with bucket seats or a split bench seat in the middle or back row. The seat latch release mechanisms on bucket seats and on the 40% portion of the split bench seat in the second and third rows do not have protective covers. When activating the release mechanism to roll a bucket seat forward, an operator's fingers may be severely injured or severed if they are not kept clear of the mechanism. Correction: Dealers will install a protective cover over the release mechanism.
Vehicle description: Passenger mini vans equipped with bucket seats or a split bench seat in the second (middle) or third (back) row. The seat latch mechanisms on bucket seats and on the 40% portion of the split bench seat in the second and third rows do not have protective covers.
Vehicle description: Mini vans. These vehicles may have (1) a broken shift cable fitting or (2) loose shift linkage. Consequently, moving the shift lever to a 'park' position may not shift the transmission to 'park'.
These vehicles may not comply with c.M.V.S.S. 102 - transmission shift control sequence. Vehicles may have a broken shift cable fitting or loose shift linkage swivel tubes. With either condition, moving the shift lever to "park" may not shift the transmission to "park". This could result in vehicle roll away and a possible crash without prior warning. Correction: Dealers will inspect and, if necessary, replace the automatic transaxle range selector cable.
Note: Vehicles equipped with traction control. When the windshield wipers are turned on, the windshield wiper linkage arm may contact a brake line connected to the traction control system (tcs) modulator. This could result in brake fluid leakage, reduced braking effectiveness and increased stopping distances. Correction: A brake line clip will be installed which will assure proper clearance. Additionally, vehicles will be inspected for brake line damage caused by this condition and damaged brake lines will be replaced.
Vehicle description: Passenger mini vans equipped with traction control systems. The windshield wiper linkage arm can contact a brake line which is connected to the traction control system modulator valve. This contact can chafe the brake line resulting in a brake fluid leak.
Note: Vehicles equipped with a 3.4 litre engine. Water may be drawn into the evaporative emission canister when the vehicle is driven in slushy snow conditions. The water is then delivered to the engine which can result in setting an mil (malfunction indicator lamp), misfire, rough idle, lack of power and eventually engine stall if driveability and mil are ignored. Correction: Evaporative emission canister vent solenoid valve assembly will be relocated to a protected area. Rear heater, ventilation and air conditioning equipped vehicles will have a shield installed under the assembly.
Certain minivans fail to conform to the requirements of federal motor vehicle safety standard no. 213, "child restraint systems." these vehicles do not have text and formatting on the warning label attached to the available second-row integral child restraint as specified by amendments to the standard.
출처: NHTSA(미국, 퍼블릭 도메인), 캐나다 교통부(Open Government Licence – Canada), DVSA(영국, Open Government Licence v3.0), RappelConso 및 EU Safety Gate(프랑스, Licence Ouverte 2.0), 일본 국토교통성(공공데이터 이용약관 1.0), 한국 국토교통부(자동차리콜센터 car.go.kr).