스타터 본체가 양극 배터리 케이블과 접촉할 수 있는데, 그 이유가...
시동 본체가 케이블 보호가 부족해 양극 배터리 케이블과 접촉할 수 있습니다. 이로 인해 전기 아크나 단락이 발생해 엔진룸 연기와 화재가 발생할 수 있습니다.
🔔 무료 계정을 만들고 Citroën Jumpy (모든 세대) 이메일 알림 받기
시동 본체가 케이블 보호가 부족해 양극 배터리 케이블과 접촉할 수 있습니다. 이로 인해 전기 아크나 단락이 발생해 엔진룸 연기와 화재가 발생할 수 있습니다.
라디오 디스플레이가 제대로 고정되지 않을 수 있습니다. 사고 발생 시 디스플레이가 느슨해져 탑승자가 부상을 입거나, 에어백이 전개될 때 에어백이 손상될 수 있습니다.
수소 누출은 외부 탱크 커버와 보호 라이너 사이에서 발생할 수 있습니다. 차량의 수소 센서가 주행 중 누출을 감지하면 연료전지 시스템이 정지합니다. 이후 차량은 배터리 기반 전기 모드로만 작동하며, 주행 가능 거리는 약 30km로 매우 제한되고 차량 내 수소 재충전 기능은 없습니다. 차량이 주차되어 있을 때는 수소 센서가 작동하지 않습니다. 이 경우 수소가 차량 하부에 축적될 수 있으며, 이로 인해 수소 화재 위험이 높아집니다.
충전 케이블의 안전 기능(충전 핀 온도 센서)이 고장 나서 케이블이 과열되는 것을 막지 못할 수 있으며, 이로 인해 화재 위험이 발생합니다.
Possible non-compliance of an internal component of the starter control relay could cause damage by overheating. This could cause unintended operation of the starter motor and in extreme instances; there is a risk of fire.
A possible nonconformity of an internal component of the starter motor relay could affect the control of the starter motor. This could adversely affect the starting operation and damage the starter motor due to overheating and in extreme cases there is a risk of fire.
It has been identified that some ground connections of the cabin wiring harness and the fixings of the airbag control unit may not be to specification. This issue or non-compliance could cause erratic malfunctions of certain electrical equipment even in very rare cases causing the engine to cut-off or airbags malfunction.
엔진이 갑자기 멈추지 않도록 방지하고 고객 서비스에 데이터를 전송하는 소프트웨어를 제대로 작동하지 않습니다. 이로 인해 차량 시동 후 '준비' 모드가 작동하지 않거나, 가속력이 떨어지거나, 주행 중 엔진이 갑자기 꺼지는 일이 발생할 수 있습니다. 이로 인해 사고와 부상 위험이 증가합니다.
엔진 제어 장치의 소프트웨어 오류로 인해, 요소 인젝터가 작동을 멈추더라도 고장 표시등(MIL)이 점등되지 않습니다. 이로 인해 배출가스가 증가할 수 있으며 환경에 위험을 초래할 수 있습니다.
Une erreur logicielle dans l’unité de commande du moteur empêche le voyant de dysfonctionnement (mil) de s’allumer si l’injecteur d’urée cesse de fonctionner. cela peut entraîner des émissions plus élevées et présenter un risque pour l’environnement.
Affected vehicle may face a black screen on the Instrument Panel Cluster with several functions not available to view.
On affected vehicles there is an issue with the Engine Control Module (ECM) calibration which may lead to non-compliance with regulatory emission requirements.
Une erreur logicielle dans l’unité de commande du moteur empêche le voyant de dysfonctionnement (mil) de s’allumer si l’injecteur d’urée cesse de fonctionner. cela peut entraîner des émissions plus élevées et présenter un risque pour l’environnement.
Affected vehicles may face an error in the Battery Monitoring Unit software.
On affected vehicles there could be a loss of ground connections for some electrical harnesses which could result in a worst-case scenario in the loss of several vehicle functions with safety impacts and a risk of erratic behaviour of the vehicle.
The High Voltage Harness might not be to the correct specification.
뒷창문 전기 하네스가 원래 위치에서 밀려나 열 문제를 일으킬 수 있습니다.
La fourgonnette a une version incorrecte du logiciel du moteur, ce qui entraîne des erreurs dans la stratégie de refroidissement et un mauvais fonctionnement du système d’avertissement «haute température» du moteur.
The positioning of the starter supply terminal may be incorrect. This may allow it to foul other components and cause a short circuit.
An internal fault with the wiper motor could cause it to stop working. In some rare cases the windscreen wipers may stop working while in operation.
외장 조명 제어 링의 위치를 조명 관리 시스템이 감지하지 못할 수 있으며, 이로 인해 경고 없이 조명이 꺼질 수 있다는 사실이 확인되었습니다.
It has been identified that due to incorrect positioning of the exterior lighting control ring by the lighting management system the lights may switch off unexpectedly.
On affected vehicles the radio display fixing screws may be missing allowing a potential detachment of the display during a collision.
출처: NHTSA(미국, 퍼블릭 도메인), 캐나다 교통부(Open Government Licence – Canada), DVSA(영국, Open Government Licence v3.0), RappelConso 및 EU Safety Gate(프랑스, Licence Ouverte 2.0).