Vehicle description: Mini vans equipped with 2-spoke luxury wheels manufactured july 1992 through june 1993; or equipped with 4-spoke sport wheels manufactured from july 1992 through september 1993. The steering wheel armature stamping can crack and separate from the center hub attachment to the steering column.
NHTSA · 미국2000년 10월 12일00V305000연식 1993–1994원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
스티어링 휠 골격(아마튜어) 스탬핑 부품에 균열이 생겨 스티어링 칼럼의 중앙 허브에서 분리될 수 있습니다. 이로 인해 조향 제어에 악영향을 미칠 수 있으며, 사전 경고 없이 충돌 사고가 발생할 가능성이 있습니다.
시정 조치: 균열이 확인된 스티어링 휠은 교체됩니다. 해당되는 기타 차량에는 스티어링 휠이 스티어링 칼럼에서 분리되는 것을 방지하기 위해 분리 방지 플레이트(anti-separation plate)가 설치됩니다.
캐나다 교통부1996년 12월 9일1996198연식 1991–1992자동 번역 · 원문: 영어자세히 보기 →
Improper stamping of the fuel tank flanges could result in damage to the fuel tank mounting straps and/or the fuel lines which in turn could result in fuel tank separation or fuel leakage. Correction: Vehicles will be inspected for proper fuel tank flange bends and if necessary the flange will be bent to the specified angle. Damaged mounting straps and fuel lines will be replaced as required.
캐나다 교통부1992년 11월 19일1992147연식 1992원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
On certain vehicles equipped with an anti-lock brake system (ABS), the high pressure hose may leak or detach due to inadequate crimping of the hose-to-end fittings. This condition could result in loss of brake power assist and a possible increase in stopping distances. Correction:(526) ABS high pressure hose will be replaced with a hose of different design and construction. (527) four hundred and twenty six of the identified mini vans will also have the ABS pump casting inspected for porosity. Leaking pumps, if found, will be replaced.
캐나다 교통부1991년 11월 20일1991157연식 1991원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Continued flexing of the inboard front seat belt buckle assembly straps can result in eventual strap failure near the anchor location. This could result in the increased risk of front seat occupant injury during a sudden stop or vehicle crash. Correction: Straps will be inspected and reinforced or replaced with a strengthened version as required.
캐나다 교통부1991년 4월 18일1991065연식 1990원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Vehicle description: Mini vans. The bolts used to attach the strut to the body and the rear liftgate can accumulate fatigue damage if three factors combine. If the bolt is loose, the gas strut is over-pressurized, and the frequency of opening and closing cycles is higher than for the average customer, the bolt can fail.
NHTSA · 미국1999년 9월 2일99V213000연식 1991–1994원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Vehicle description: Mini vans. The wiring that initiates the driver and/or passenger air bag could electrically short circuit to ground. A short circuit to ground that exists immediately after turning the ignition key to the "on" or "start" position can cause the air bag(s) to inadvertently deploy.
NHTSA · 미국1999년 5월 6일99V113000연식 1993–1995원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
The first row rear seat outboard side seat belt anchor hook can become unattached from the body anchor position. Also, the covers on solid stalk mounted seat belt buckles may become dislodged. Should a cover become dislodged, the release button may stick inside the cover creating the potential for the buckle to become partially latched. In the event of a vehicle crash, either of these conditions could result in the occupant not being properly restrained. Correction: Anchor hook retaining clip will be replace with a revised profile clip and cover plate. Dealers will also install a cover retaining clip to the stalk mounted buckle cover to prevent dislocation of the buckle cover.
캐나다 교통부1997년 9월 29일1997162연식 1991–1993원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Vehicle description: Passenger mini-vans. The center rear seat, right outboard side, safety belt anchor hook can become unattached from the body anchor position.
NHTSA · 미국1997년 9월 9일97V149000연식 1991–1993원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Vehicle description: Passenger mini-vans. Covers on the solid stalk mounted seat belt buckles can become dislodged causing the release button to stick inside the cover. The buckle would then be only partially latched.
NHTSA · 미국1997년 9월 9일97V148000연식 1991–1993원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
The bolts used to attach the strut to the body and the rear liftgate can accumulate fatigue damage if three factors combine. If the bolt is loose, the gas strut is over-pressurized, and the frequency of opening and closing cycles is higher than for the average customer, the bolt can fail.
NHTSA · 미국1997년 5월 16일97V079000연식 1992원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Wheels with misformed lug nut seats were installed on these vehicles. This causes reduced nut to wheel contact area and limits the wheel self-centering capability during installation. This results in loss of wheel lug nut torque retention.
NHTSA · 미국1993년 12월 14일93V215000연식 1994원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Vehicles equipped with 15" stamped road wheels or spare wheel may have a misformed wheel lug nut seat configuration. This could cause a reduced nut to wheel contact area and limit the wheel self centering capability during installation. This could result in loosening of the wheel lug nuts and possible wheel loss. Correction: Suspect wheels will be replaced and installed with new lug nuts.
캐나다 교통부1993년 6월 8일1993086연식 1993원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
출처: NHTSA(미국, 퍼블릭 도메인), 캐나다 교통부(Open Government Licence – Canada), DVSA(영국, Open Government Licence v3.0), RappelConso 및 EU Safety Gate(프랑스, Licence Ouverte 2.0), 일본 국토교통성(공공데이터 이용약관 1.0), 한국 국토교통부(자동차리콜센터 car.go.kr).