조향: 스티어링 휠/핸들바
상부 조향 칼럼 샤프트 커플링 볼트에 아연 도금 작업이 이루어져 수소 취성과 볼트 파손이 발생했습니다.
🔔 무료 계정을 만들고 Dodge Daytona (모든 세대) 이메일 알림 받기
상부 조향 칼럼 샤프트 커플링 볼트에 아연 도금 작업이 이루어져 수소 취성과 볼트 파손이 발생했습니다.
Air bag inflator modules may not contain diffuser holes between the ignitor and propellant chambers.
엔진 밸브 커버 가스켓이 이탈(위치 이탈)하여 가스켓 부위에서 엔진 오일이 새는 현상이 발생할 수 있습니다.
연료 누출은 저온 환경에서 운전할 때 엔진룸 연료 공급 호스와 압력 조절기 및 연료 레일의 연결부에서 발생할 수 있습니다.
On certain vehicles equipped with a 2.2 Litre turbo engine, an inadequately tightened fuel hose clamp at the fuel system pressure regulator could result in fuel leakage and provide the potential for an engine compartment fire.
An engine compartment fuel hose routed to the fuel system pressure regulator may have an inadequately tightened hose clamp. Consequence of defect: The fuel hose could leak and result in an engine compartment fire.
Inadequate weld attachment of the front frame rails to the dash panel may result in cracking of the dash panel around the shock tower and floor pan area. This may compromise the vehicle's impact protection capability. Correction: Dash panel will be secured to the frame rails by adding additional fasteners (nuts and bolts).
The welding attachments of the front frame rails to the floor pan sheet metal may not be properly welded.
The bonded disc brake linings may separate from the shoes due to a bonding deficiency which may allow corrosion degradation of the bond attachment.
Mismatched parking brake cable lengths to the rear wheels reduces braking ability of one of the rear wheels, in violation of fmvss 105.
전륜 디스크 브레이크 캘리퍼 가이드 핀 볼트가 충분한 토크로 체결되지 않았을 수 있으며, 풀릴 가능성이 있습니다.
차량에 전동 조절식 버킷 시트가 장착된 경우, 운전석 시트 프레임이 네 개의 고정부 중 한 곳에서 파손될 수 있습니다. 이로 인해 시트가 앞뒤 방향 또는 좌우 방향으로 움직일 수 있습니다. 이는 차량 조종 능력 상실과 차량 충돌로 이어질 수 있습니다. 시정 조치: 운전석 시트 프레임을 보강된 제품으로 교체합니다. 또한 전동 조절장치 크로스멤버를 보강합니다.
Drivers seat frame may experience fatigue failure at one (front/outboard) of its four attachments.
These vehicles do not comply with c.M.V.S.S. 1103 - exhaust emissions. Plugged choke vacuum delay valve. Note: Vehicles equipped with 2.2 litre carbureted engines.
Battery cap vents may be partially or completely blocked with plastic flashing. Consequence of defect: A build up of internal gas pressure could occur which could result in case rupture, particularly during post charging. Should a person be in the vicinity of the battery when the case ruptures, they may be injured by the released gases and/or acid.
Vehicles may have been built with a potential for the separation of the hood panel from the latch system mechanism. An improper assembly plant repair procedure may have resulted in inadequate structural integrity of the hood latch system attachment to the hood panel. Under certain driving conditions this could result in hood fly-up.
Some hood latch assemblies may have been improperly repaired at the factory, or incorrect fasteners were used. Hood latch attachment will not be strong enough and will likely weaken the inner hood panel.
The owner's manual incorrectly states that the front passenger door cannot be opened from the inside if the door is locked until the lock control handle has been pulled up. On these vehicles, the front passenger door can be opened by the inside door handle even if the door is locked.
Certain Daytona and Daytona Shelby vehicles do not comply with CMVSS 110 - tire selection and rims. (incorrect tire placard)
Incorrect tire pressure placard was installed on cars; does not comply with fmvss 110.
출처: NHTSA(미국, 퍼블릭 도메인), 캐나다 교통부(Open Government Licence – Canada), DVSA(영국, Open Government Licence v3.0), RappelConso 및 EU Safety Gate(프랑스, Licence Ouverte 2.0), 일본 국토교통성(공공데이터 이용약관 1.0), 한국 국토교통부(자동차리콜센터 car.go.kr).