무료 열람 · 무료 계정으로 기여Anticars(2000)의 후속

Mazda CX-3

2014– · 1 세대 · 결함 13건 · 3개 시장
세대
모든 세대CX-32014–1330207

Mazda CX-3의 모든 세대를 한곳에: 결함, 리콜, 서비스 회보, 토론. 세대를 선택해 범위를 좁히세요.

가장 심각한 결함

전체 보기 (13) →
m
심각엔진JP

エンジン:オーナーから寄せられた不具合

日本の国土交通省「自動車不具合情報ホットライン」に、この車の「エンジン」についての不具合がオーナーから40件寄せられています(初度登録 2015〜2022年)。走行距離は26,000km前後が多くなっています。報告のうち、火災・発煙に関する記述 2件、ブレーキや操舵が効かなくなったとする記述 1件。

✓ 공식 데이터에 대한 Mecafile 분석2015–2022원문(일본어)으로 표시 중 · 번역 대기자세히 보기 →
m
심각전장JP

電気装置:オーナーから寄せられた不具合

日本の国土交通省「自動車不具合情報ホットライン」に、この車の「電気装置」についての不具合がオーナーから6件寄せられています(初度登録 2015〜2021年)。走行距離は45,000km前後が多くなっています。報告のうち、火災・発煙に関する記述 1件。

✓ 공식 데이터에 대한 Mecafile 분석2015–2021원문(일본어)으로 표시 중 · 번역 대기자세히 보기 →
m
보통전장NA

Electrical system: problems reported by owners

26 owners in the United States reported problems with the electrical system of this car to NHTSA (model years 2014–2021), typically at around 22,000 miles.

✓ 공식 데이터에 대한 Mecafile 분석2014–2021원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
m
보통엔진NA

Fuel system: problems reported by owners

20 owners in the United States reported problems with the fuel system of this car to NHTSA (model years 2016–2019), typically at around 55,000 miles.

✓ 공식 데이터에 대한 Mecafile 분석2016–2019원문(영어)으로 표시 중 · 번역 대기자세히 보기 →

최신 공식 리콜

전체 보기 (30) →
리콜보통엔진JP

연료 펌프

가솔린 엔진 차량의 저압 연료 펌프 임펠러(수지제 날개차)에서, 성형 조건이 부적절하여 수지 밀도가 낮아지고, 연료에 의해 팽윤되어 변형되는 경우가 있다. 그 결과 임펠러가 펌프 케이스와 접촉하여 저압 연료 펌프가 작동 불량을 일으킬 수 있으며, 최악의 경우 주행 중 엔진 정지(엔진 스톨)에 이를 우려가 있다.

jp2024년 1월 26일1154360연식 2017–2020자동 번역 · 원문: 일본어자세히 보기 →
리콜보통전장JP

装置その他

バックカメラにおいて、電気配線の固定が不適切なため、リアゲートを閉めた時や走行中の車体振動などで振れ、バックカメラと電気配線間の接続端子が摺動することがある。そのため、そのまま使用を続けると、接続端子の表面被膜が摩耗して剥がれ、腐食することで電気抵抗が増加し、最悪の場合、バックカメラの映像が乱れ、車両後方が確認しにくくなるおそれがある。

jp2023년 7월 14일2106740연식 2014–2020원문(일본어)으로 표시 중 · 번역 대기자세히 보기 →
리콜보통전장NA

Prevention 항목의 이어지는 내용입니다: 센싱 시스템: 카메라 Wait, I should give only the translation as instructed. Correcting: 센싱 시스템: 카메라

Mazda North American Operations(Mazda)는 2014~2018년식 Mazda3 및 2016~2021년식 CX-3 일부 차량을 리콜합니다. 후방 카메라 화면이 깜빡이거나 왜곡된 영상으로 표시되어 제대로 나타나지 않을 수 있습니다.

NHTSA · 미국2023년 7월 14일23V487000연식 2016–2021자동 번역 · 원문: 영어자세히 보기 →

최신 기술 서비스 공지

전체 보기 (207) →
공지보통차체NA

공지

This bulletin supersedes the previously issued bulletin(s) listed below. The changes are noted in Red. 09-012/21 12/13/21, 06/10/21 and 04/27/21 DESCRIPTION Some customers may experience all of following symptoms: The door lock/unlock operation will not work using the remote transmitter button. 1. The door lock/unlock operation will not work using the door lock/release touch sensor. 2. The engine will not start using the ignition switch. 3. The transmitter operates by itself. 4. The key battery drains faster than usual. 5. Symptoms 1-3: This may be caused when excess load is applied to the remote transmitter, deforming the electrical terminals and creating poor contact with the battery. To eliminate this concern, the structure in the remote transmitter has been modified to reduce the deformation of the electrical terminals. Symptom 4-5: This may be caused when excessive load is applied to the remote transmitter, creating a gap around the gasket where moisture enters and corrodes the circuit board which in turn drains the key battery faster than usual. To eliminate this concern, the thickness of the case wall on the gasket mounting surface has been increased and the bonding strength of the components has been improved to prevent deformation. REPAIR PROCEDURE If the battery is bad or installed incorrectly, replace the battery and/or install it correctly. If the remote power saving function is off and the battery is good and installed correctly, replace the defective remote transmitter with a modified one according to the instructions on MGSS (IMMOBILIZER SYSTEM-RELATED PARTS PROGRAMMING). NOTE: DO NOT replace other remote transmitter(s) for the vehicle if they not experiencing an issue.

NHTSA · 제조사 공지11034436연식 2021원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지경미엔진NA

공지

A tapping/rattling noise may be noticed from the valve train area. This operating condition can occur on new vehicles which have been delivered to Mazda dealers (due to loading and unloading from transport trucks or customers moving their vehicles in and out of their garages to wash the vehicle, etc.). This condition may also occur if the engine is not allowed to warm up after multiple cold starts.

NHTSA · 제조사 공지11020037연식 2021원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지보통전장NA

공지

Some customers may experience the following symptoms of the wireless charger (Qi), even when the mobile device (smartphone etc.) is placed in the proper position on the wireless charger (Qi). It does not start charging. It stops charging with the indicator flashing in red after starting. It stops charging without any visible sign after starting. For CX-50, some customers may experience that despite placing the MagSafe-equipped iPhone at the center of the wireless charger, charging stops after about ten seconds. MagSafe-equipped iPhones use magnets to align the charger and the device. When charging MagSafe-equipped iPhones with a non-MagSafe compatible charger, improper alignment can cause the magnetic field required for charging to be disrupted by the magnets, significantly reducing charging efficiency.

NHTSA · 제조사 공지11012342연식 2021원문(영어)으로 표시 중 · 번역 대기자세히 보기 →

최신 포럼 글

아직 토론이 없습니다.

결함과 토론은 세대별로 정리됩니다. 글을 올리려면 위에서 세대를 선택하세요.

출처: NHTSA(미국, 퍼블릭 도메인), 캐나다 교통부(Open Government Licence – Canada), DVSA(영국, Open Government Licence v3.0), RappelConso 및 EU Safety Gate(프랑스, Licence Ouverte 2.0).