무료 열람 · 무료 계정으로 기여Anticars(2000)의 후속

Mercedes-BenzMercedes-Benz E 클래스 V213

2016–2023 · 결함 22건 · 3개 시장

이 파일은 Mercedes-Benz E 클래스 V213의 알려진 결함을 커뮤니티가 출처와 함께 정리한 것입니다. 누구나 무료로 읽을 수 있고, 무료 계정으로 기여할 수 있습니다. 신뢰할 수 있는 기여자가 충분히 검증하면 결함에 인증 마크가 붙습니다.

소유자들이 이 차의 engine 문제를 자주 보고하지만(93건) 아직 아무도 원인을 설명하지 않았습니다. 알고 계신가요?항목 작성
소유자들이 이 차의 electrical system 문제를 자주 보고하지만(84건) 아직 아무도 원인을 설명하지 않았습니다. 알고 계신가요?항목 작성

가장 심각한 결함

전체 보기 (22) →
m
심각엔진NA

Engine: problems reported by owners

93 owners in the United States reported problems with the engine of this car to NHTSA (model years 2016–2023), typically at around 23,000 miles. Reported consequences: 10 fires, 1 injury.

✓ 공식 데이터에 대한 Mecafile 분석2016–2023원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
m
심각전장NA

Electrical system: problems reported by owners

84 owners in the United States reported problems with the electrical system of this car to NHTSA (model years 2016–2023), typically at around 18,000 miles. Reported consequences: 6 fires, 3 injuries.

✓ 공식 데이터에 대한 Mecafile 분석2016–2023원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
m
심각실내NA

Airbags: problems reported by owners

57 owners in the United States reported problems with the airbags of this car to NHTSA (model years 2016–2019), typically at around 10,000 miles. Reported consequences: 7 crashes, 6 injuries.

✓ 공식 데이터에 대한 Mecafile 분석2016–2019원문(영어)으로 표시 중 · 번역 대기자세히 보기 →

최신 공식 리콜

전체 보기 (540) →
리콜보통변속기KR

동력전달장치 기타

공급업체의 생산 공정의 편차로 인해 시간이 지남에 따라 드라이브 샤프트의 유니버셜 조인트가 마모될 수 있으며, 이로 인해 유니버셜 조인트에서 윤활유 손실이 발생하여 유니버셜 조인트가 파손될 수 있음. 그 결과로 트랜스퍼 케이스와 전륜 구동 장치 간의 연결이 끊어져 추진력을 잃을 수 있고 충돌 위험이 증가할 수 있음이 확인됨에 따른 리콜 <대상차량별 생산일자> S 450 4MATIC: 2018.01.25~2019.11.14 S 560 4MATIC: 2019.08.30~2019.09.12 CLS 400 d 4MATIC: 2019.02.25~2019.04.11 S 350 d 4MATIC: 2019.04.09 E 450 4MATIC: 2019.02.05 S 400 d 4MATIC: 2017.12.11

국토교통부 · 한국2026년 9월 30일6389연식 2017–2019자세히 보기 →
리콜보통변속기UK

SRPC2603 - Drive Shaft Joint

Mercedes-Benz AG has determined that on certain 4MATIC E-Class (213 platform) S-Class Coupé (217 platform) S-Class (222 platform) E-Class Coupe/Convertible (238 platform) GLC (253 platform) and CLS (257 platform) vehicles increased wear of the universal joint on the drive shaft might occur.

DVSA · 영국2026년 9월 21일R/2026/148연식 2019원문(영어)으로 표시 중 · 번역 대기자세히 보기 →

최신 기술 서비스 공지

전체 보기 (488) →
공지보통서스펜션NA

공지

Complaint Diverse functional limitations in the vehicle in combination with various warning and fault messages in the instrument cluster display. Cause Communication timeouts mean that communication errors may occur in the onboard electrical system, which can result in various fault messages being displayed in the instrument cluster. This could be down to delayed feedback from the drivetrain control unit (N127) (CPC) to other control units networked to the CAN bus. Information: Only valid for vehicles through production period 10/2025. Not valid for vehicles with control unit CDCC (N125, central controller charging and driving) It may not be possible to attribute any communication errors stored in the control units on the CAN bus to a specific cause In rare instances, there may be a brief activation of the yellow warning lamp for engine diagnosis or there may be a sporadic delay with the start enable. There may not be any specific fault codes present that indicate a specific component. Example image: Fault messages in instrument cluster: The reason for this could be down to delayed feedback from the control unit CPC3 to other control units networked on the CAN bus. Remedy Do not replace any components!!! ******************************************************************************************************* 1. Connect charger (see AR54.10P1127WT). Note: An adequate voltage from the onboard electrical system battery must be guaranteed for the entire duration of the work procedure. Otherwise, the control units could be damaged if an undervoltage occurs. Information: Observe the operating instructions of the charger. Information: Use the charger to ensure an adequate voltage (at least 12.5 V) from the onboard electrical system battery. 2. Connect diagnostic system (see AD00.00P200006FR). Note: Always use the latest XENTRY Diagnostics software release. Information: Strict compliance with the operation steps in XENTRY Diagnostics is absolutely essential. 3. Select control unit N127 (CPC) via the direct link using XENTRY Diagnosis. Information: To do so, select the following menu items: Control units view Drive systems N127 "Drivetrain" control unit (CPC) 4. Update software for control unit N127 (CPC) (see AR54.21P001401Y). Info: To do so, select the following menu items: Adaptations Control unit update Update control unit software. Information: You are then automatically guided through the steps "Update of control unit software" and "SCN coding". Always observe the following operation steps at all times 5. Disconnect diagnostic device from vehicle (see AD00.00P200006FR). 6. Disconnect charger from vehicle (see AR54.10P1127WT).

NHTSA · 제조사 공지11038925연식 2023원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지경미차체NA

공지

**고객 불만:** 도어 내 스피커 부근에서 덜컹거리는 소음이 발생함. **원인:** 분석 중. **조치:** 원인을 좁히기 위해 먼저 도어 트림을 분리하십시오. 도어 트림을 분리한 상태에서도 소음이 계속 발생하면 스피커 쪽으로 진단을 계속 진행하고, 필요한 경우 유용한 동영상을 첨부하여 TIPS 케이스를 생성하십시오. **참고:** 보증 클레임에서 이 문서를 참조하고, 진단이 완료되면 문제를 일으키는 부품에 따라 손상 코드를 선택하십시오. 도어 트림을 분리했을 때 소음이 멈추면 LI72.10P067691에 따라 진행하십시오. **정보:** 이 경우 보증 클레임에서 스피커에 대한 손상 코드를 사용하지 마십시오!

NHTSA · 제조사 공지11038217연식 2018–2023자동 번역 · 원문: 영어자세히 보기 →
공지보통서스펜션NA

공지

Complaint Slight creaking noises when steering. Cause Noises may come from one or more sleeves of the horn contact plate. Remedy Remove the horn contact plate and check the sleeves for noise; see attached video. If necessary, apply lubricant to the sleeves.

NHTSA · 제조사 공지11038188연식 2017–2023원문(영어)으로 표시 중 · 번역 대기자세히 보기 →

출처: NHTSA(미국, 퍼블릭 도메인), 캐나다 교통부(Open Government Licence – Canada), DVSA(영국, Open Government Licence v3.0), RappelConso 및 EU Safety Gate(프랑스, Licence Ouverte 2.0), 일본 국토교통성(공공데이터 이용약관 1.0), 한국 국토교통부(자동차리콜센터 car.go.kr).