공지
On some Model 3 and Model Y vehicles, the upper steering column bolt may not be installed according to internal specifications, which could cause excessive play between the steering wheel and steering column.
🔔 무료 계정을 만들고 Tesla 3 이메일 알림 받기
기술 서비스 공지(TSB)는 제조사가 알려진 문제에 대해 딜러에게 보내는 수리 지침입니다. 안전 리콜은 아니지만 결함을 확인해 주는 경우가 많습니다.
On some Model 3 and Model Y vehicles, the upper steering column bolt may not be installed according to internal specifications, which could cause excessive play between the steering wheel and steering column.
On some Model 3 and Model Y vehicles, the brake caliper bolts may not have been torqued to internal specifications.
On some Model 3 and Model Y vehicles, the brake caliper bolts may not have been torqued to internal specifications.
Certain Model 3 vehicles might have too few HV battery positive contactor mounting nuts installed, which can allow movement that might affect the conductivity of the contactor terminals.
Certain Model 3 vehicles might have too few HV battery positive contactor mounting nuts installed, which can allow movement that might affect the conductivity of the contactor terminals.
Certain Model 3 vehicles might have too few HV battery positive contactor mounting nuts installed, which can allow movement that might affect the conductivity of the contactor terminals.
Certain Model 3 vehicles might have too few HV battery positive contactor mounting nuts installed, which can allow movement that might affect the conductivity of the contactor terminals.
On a certain few Model 3 vehicles, the steering shaft sleeve diameter is too large, and might preload the steering shaft boot bearing so as to cause a squeaking noise to come from the steering shaft boot when the steering wheel is turned. The squeaking noise is most prevalent at lower ambient temperatures, and might diminish as the temperature rises. This is exclusively an NVH issue and does not affect steering functionality.
On some Model 3 vehicles, the push rivets, nuts, and bolts that attach the underbody aero panels might have been improperly installed. Consequently, fasteners might be missing, and underbody panels might be damaged or missing.
Certain Model 3 vehicles might have too few HV battery positive contactor mounting nuts installed. Too few mounting nuts allow movement that might affect the conductivity of the contactor terminals.
On certain Model 3 vehicles, coolant might leak from the rear drive unit inverter 55 degree fluid coupling. This could result in a low coolant alert in the vehicle.
On some Model 3 vehicles, water might leak inside the motors of both front window motor/regulator assemblies. This might cause the motors to fail and potentially make the front windows inoperable.
On some Model 3 vehicles, water might leak inside the motors of both front window motor/regulator assemblies. This might cause the motors to fail and potentially making the front windows inoperable.
On some Model 3 vehicles, one of the bolts that helps to secure the rear drive unit inverter coolant manifold to the inverter housing might not have been installed. Consequently, coolant might leak from the manifold.
On certain Model 3 vehicles, the rear drive unit gearbox fluid might leak into the printed circuit board cavity of the oil pump, causing the vehicle to go into limp mode.
On some Model 3 vehicles, the brake booster clevis pin might make a knock or rattle sound when the brakes are used. Vehicle braking is not affected.
On some Model 3 vehicles, a pre-production LH upper trough plug is installed. The pre-production plug is completely functional, however, it does not cosmetically match the grommet on the RH upper trough.
On certain Model 3 and Model Y vehicles, the tire pressure monitoring system (TPMS) sensor battery may drain at an accelerated rate. Identify and replace the affected TPMS sensor.
Certain Model 3 and Model Y vehicles were manufactured with High Voltage (HV) batteries containing cell modules that do not meet Teslas internal quality standards, potentially resulting in a reduction of range.
On some Model 3 vehicles, the RH front Wheel Speed Sensor (WSS) might have been misrouted, which may cause damage to the WSS harness.
Some Performance Model 3 vehicles might experience minor oil loss through the Rear Drive Unit (RDU) breather during high lateral acceleration cornering maneuvers.
On some Model 3 vehicles, the RH front Wheel Speed Sensor (WSS) might have been misrouted, which may cause damage to the WSS harness.
On some 2024+ Model 3 vehicles built at Fremont, a rattling noise may be noticed from the driver and/or front passenger instrument panel air vent while the face-level air vents are directed to straight ahead air flow.
On some 2024+ Model 3 built at Fremont, a rattling noise may be noticed from the driver and/or front passenger instrument panel air vent while the face-level air vents are directed to straight ahead air flow.
On certain Model 3 vehicles, the rear drive unit HV header bolts and the positive contactor bolt within the High Voltage (HV) battery ancillary bay were insufficiently torqued to internal specifications during manufacturing.
출처: NHTSA(미국, 퍼블릭 도메인), 캐나다 교통부(Open Government Licence – Canada), DVSA(영국, Open Government Licence v3.0), RappelConso 및 EU Safety Gate(프랑스, Licence Ouverte 2.0), 일본 국토교통성(공공데이터 이용약관 1.0), 한국 국토교통부(자동차리콜센터 car.go.kr).