Em determinados veículos de passageiros equipados com motores 3800 V6 (L36) e com certos reguladores de pressão de combustível Delphi, os reguladores apresentam uma taxa de vazamento de combustível bem superior ao normal. Um vazamento pode permitir que o combustível entre no coletor de admissão por meio de uma linha de vácuo. Se o motor não pegar ao ser acionado no arranque, o combustível proveniente do regulador com vazamento e uma ignição fora de tempo podem causar um retorno de chama (backfire).
NHTSA · Estados Unidos24 de fev. de 200404V090000Anos-modelo 1998–2000Traduzido automaticamente · original: inglêsVer detalhes →
Certos veículos de passageiros, minivans e utilitários esportivos têm um inflador de airbag no lado do motorista que pode fraturar em uma solda durante a implantação.
NHTSA · Estados Unidos9 de ago. de 200202V222000Anos-modelo 2002–2003Traduzido automaticamente · original: inglêsVer detalhes →
These vehicles may exhibit a backfire during engine starting that can cause breakage of the upper intake manifold. This can cause a no-start condition and possibly an engine compartment fire. Also, if a person was in the vicinity of the intake manifold when the hood was open, and this backfire condition occurred, it could result in personal injury. Correction: The pcm (powertrain control module) will be reflashed with new programming software.
Transport Canada11 de jul. de 19961996099Anos-modelo 1996–1997Exibido no inglês original · tradução pendenteVer detalhes →
The upper transaxle oil cooler hose could pull out of the crimped coupling at the transaxle end of the line assembly. If this coupling were to separate, transaxle oil would spill into the engine compartment and, in the presence of an ignition source, a fire could occur. Correction: Dealers will install a new upper transaxle oil cooler line on all involved vehicles.
Transport Canada14 de mar. de 19941994051Anos-modelo 1992–1993Exibido no inglês original · tradução pendenteVer detalhes →
The brake hydraulic unit mounting bolts on these vehicles may have been undertorqued. This condition could cause increased brake pedal travel and/or poor pedal feel if the attachment loosens. In addition, this condition could eventually lead to separation of the brake hydraulic unit from its mounting brackets resulting in brake loss and a possible vehicle crash. Correction: Hydraulic unit mounting bolts will be replaced on involved vehicles.
Transport Canada19 de abr. de 19881988056Anos-modelo 1987–1988Exibido no inglês original · tradução pendenteVer detalhes →
Under a high resistance load, the in-line fuseable link located in the area of the plastic windshield washer bottle bracket, may melt down and ignite the bracket. This could result in an engine compartment fire without prior warning. Correction: Windshield washer bottle bracket will be replaced on affected vehicles.
Transport Canada26 de ago. de 19871987096Anos-modelo 1987Exibido no inglês original · tradução pendenteVer detalhes →
Vehicles may have been assembled with a rubber fuel return hose which could allow a slow fuel leak while the engine is running. Under certain conditions this could result in a fire which could spread to the passenger compartment and cause burn unjuries to occupants.
Transport Canada6 de set. de 19841984099Anos-modelo 1984Exibido no inglês original · tradução pendenteVer detalhes →
The power brake vacuum hoses may fail to conform to federal motor vehicle safety standard no. 106, "brake hoses". The material used in the hoses will not perform according to specifications. The purpose of this regulation is stated as, "to reduce death and injuries occurring as a result of brake system failure from pressure or vacuum loss due to hose assembly rupture".
NHTSA · Estados Unidos23 de mar. de 198181V037000Anos-modelo 1981Exibido no inglês original · tradução pendenteVer detalhes →
Vehicle description: Passenger vehicles. These vehicles do not conform to the requirements of fmvss no. 108, "lamps, reflective devices, and associated equipment." the head lamp adjustment device horizontal adjuster may not move the head lamp reflector when the shaft is rotated in a normal manner during aiming.
NHTSA · Estados Unidos17 de dez. de 199999V355000Anos-modelo 2000Exibido no inglês original · tradução pendenteVer detalhes →
On certain vehicles, the inner tie rod nuts may be loose, which could result in separation of a tie rod. Separation of a tie rod could cause unexpected steering input in some maneuvers and could cause a crash without prior warning. Correction: Dealers will check the torque of the inner tie rod nuts and if necessary, adjust the vehicle toe-in and tighten the inner tie rod nuts to the specified torque.
Transport Canada15 de nov. de 19991999213Anos-modelo 2000Exibido no inglês original · tradução pendenteVer detalhes →
Certain vehicles do not comply with the requirements of CMVSS 102 - Transmission Shift Control Sequence. A retaining clip which secures the manual valve to the linkage of the transmission detent lever, may become loose and allow the link to become disconnected from the manual valve. If the link disconnects, the driver's indicated 'PRNDL' state may differ from the hydraulic state of the transmission. This does not affect the 'PARK' position, but if a driver selects 'DRIVE' and the transmission is actually in 'REVERSE', a crash could occur without warning. Correction: Dealers will replace the manual valve/link assembly with a replacement manual valve/link kit, featuring a spring-type fastener.
Transport Canada6 de mai. de 19991999080Anos-modelo 1999Exibido no inglês original · tradução pendenteVer detalhes →
Vehicle description: Passenger vehicles equipped with 4t65e automatic transmissions. These vehicles fail to conform to the requirements of fmvss no. 102, "transmission shift lever sequence." a retaining clip, which secures the manual valve to the linkage of the transmission detent lever, can become loose under a combination of possible driver shifting maneuvers and allow the link to become disconnected from the manual valve.
NHTSA · Estados Unidos26 de abr. de 199999V089000Anos-modelo 1999Exibido no inglês original · tradução pendenteVer detalhes →
These vehicles do not comply with c.M.V.S.S. 1101 - emission device. Improper calibration of the powertrain control module (pcm) can result in uncontrolled spark knock, setting an mil (malfunction indicator lamp), misfire, rough idle, audible knock and/or possible engine damage. Correction: Vehicle pcm will be reflashed with new calibration softwear.
Transport Canada20 de fev. de 19981998034Anos-modelo 1998Exibido no inglês original · tradução pendenteVer detalhes →
Certain vehicles may not comply with CMVSS 209 - Seatbelt Assemblies. Vehicles may have been assembled with one or more incorrect seat belt and/or seat belt buckle ends. If an incorrect part is used, the belt may not latch properly, increasing the risk of injury to the occupant should a vehicle crash occur. Correction: Vehicles will be inspected and incorrect parts replaced.
Transport Canada7 de mar. de 19961996045Anos-modelo 1997Exibido no inglês original · tradução pendenteVer detalhes →
These vehicles were assembled with one or more incorrect safety belt and/or safety belt buckle ends. This does not conform with the requirements of fmvss no. 209, "seat belt assemblies."
NHTSA · Estados Unidos5 de mar. de 199696V044000Anos-modelo 1997Exibido no inglês original · tradução pendenteVer detalhes →
Vehicle description: Passenger vehicles manufactured from august 1991 through july 1995. The transmission oil cooler line can separate when the vehicle is operated in low temperatures in combination with high transmission loads.
NHTSA · Estados Unidos23 de jan. de 199696V015000Anos-modelo 1992–1993Exibido no inglês original · tradução pendenteVer detalhes →
Fontes: NHTSA (Estados Unidos, domínio público), Transport Canada (Open Government Licence – Canada), DVSA (Reino Unido, Open Government Licence v3.0), RappelConso e Safety Gate da UE (França, Licence Ouverte 2.0), MLIT (Japão, Licença de Dados Públicos 1.0) e MOLIT (Coreia do Sul, car.go.kr).