Boletim
Inspeção de Vazamento de Fluido de Arrefecimento na Bomba d'Água do Motor Hemi
🔔 Crie uma conta gratuita para receber alertas por e-mail sobre Dodge Challenger
Os boletins técnicos (TSB) são instruções de reparação que os fabricantes enviam aos concessionários sobre problemas conhecidos. Não são recalls de segurança, mas muitas vezes confirmam um defeito.
Inspeção de Vazamento de Fluido de Arrefecimento na Bomba d'Água do Motor Hemi
MIL/CEL is on with Excessive Vibration / Lack or Loss of Power / Engine Misfire.
Descrição da peça: Bloco longo 5.7L Descrição do problema: Este conjunto de bloco longo 5.7L é compatível com aplicações EGR e não EGR. Uma placa de bloqueio EGR (53032739AA) deve ser encomendada ao instalar este conjunto de bloco longo em uma aplicação não EGR. A menos que a placa de bloqueio EGR seja transferida do motor antigo.
Customer Satisfaction Notification T12 VECI Label The Vehicle Emission Control Information (VECI) label on about 120,000 of the above vehicles may be missing emission control information. The VECI label is often used during in-use Inspection and Maintenance (I/M) testing to verify proper emissions related components. Incorrect VECI label information could result in denial of vehicle registration for the vehicle in the state of California. A new VECI label must be installed.
Service - Four Piece Oil Pan Gasket All Cummins Equipped Vehicles ONLY - The replacement oil pan gasket can be a four piece gasket rather than a single piece gasket. This applies to Cummins 5.9L and 6.7L engines only. Installation: 1. Clean the oil pan T-joints.~ 2. Fill the T-joint between the pan rail/gear housing and pan rail/rear seal retainer with sealant. Use Mopar Silicone Rubber Adhesive Sealant or equivalent. 3. Apply a 2-mm [0.063-in] bead of Mopar Engine Sealant RTV Silicone Rubber Adhesive, to the oil pan flange.~ 4. The four piece gasket will need to be assembled to make a complete oil pan gasket. 5. Lay the oil pan gasket(s) onto the oil pan flange.~ 6. Ensure the oil pan gasket segment joints are properly aligned. 7. Apply a 2-mm [0.063-in] bead of Mopar Engine Sealant RTV Silicone Rubber Adhesive, to the top of the oil pan gasket.~ 8. Install the oil pan. Starting from the center and working outward, tighten the oil pan bolts to 28 Nm [21 ft. lbs.].
Replace Vehicle Emission Certification Information Label This bulletin involves replacing the Vehicle Emission Certification Information (VECI) Label.Owner may be turned away from Inspection and Maintenance (IM) station or fail IM testing because of missing emission components on VECI label. The customer may notice that some info is missing on their VECI labels.is missing. If information is shown in this area, do not replace the label.All vehicles were built with the correct emission components installed and there is no impact on emission performance or drivability.
Descrição da peça: Bloco Longo 5.7L Descrição do problema: Este conjunto de Bloco Longo 5.7L é compatível com aplicações com e sem EGR. Uma Placa de Bloqueio do EGR (53032739AA) deve ser encomendada ao instalar este Conjunto de Bloco Longo em uma aplicação sem EGR. A menos que a Placa de Bloqueio do EGR seja transferida do motor antigo.
SEAL, Crankshaft Oil, Front Front crankshaft oil seal leak: For concern of front crankshaft seal leak please send an email to brenton.swank@fcagroup.com with VIN, Mileage, Photos and indicate where the leak is identified using dye such as: 1. Leak between the outer diameter of the seal to front cover? 2. Leak between the seal and damper 3. Leak through the damper bolt This will help in determining root cause and corrective action. For additional questions, please contact: Brenton Swank: Cell (248) 804-9386 or brenton.swank@fcagroup.com If no response in 15 minutes, proceed with repair.
Right Side Engine Cover Missing With Shaker Package This bulletin involves installing the right side engine cover if missing. The customer may notice the right side engine cover is missing. Only the right side engine cover was missed during vehicle assembly, the left side of the engine does not get an engine cover and is not part of this service action.
Replace Vehicle Emission Certification Information Label This bulletin involves replacing the Vehicle Emission Certification Information (VECI) Label.Owner may be turned away from Inspection and Maintenance (IM) station or fail IM testing because of missing emission components on VECI label. The customer may notice that some info is missing on their VECI labels.is missing. If information is shown in this area, do not replace the label.All vehicles were built with the correct emission components installed and there is no impact on emission performance or drivability.
"pentastar oil filter adapter before replacing this part, please call any one of the following people. Engineering is seeking information regarding this part.~ dye must be used to determine where the leak is coming from before replacing. Also please check the recently updated service bulletin number 09-008-15. ~ first: Nick morand cell (248) 410-5078 - nick.Morand@fcagroup.Com second: Bob jackson cell (248) 944-0466 - bob.Jackson@fcagroup.Com third: Joe lovell cell (734 309-6467 - joe.Lovell@fcagroup.Com if a response is not received within 15 mins, then proceed with the necessary repair."
Various vehicles are experiencing loss of oil, and possibly an oil leakage pooling in engine valley and possibly need replacing oil filter housing. Model 2014. *pe
NOTIFICAÇÃO DE SATISFAÇÃO DO CLIENTE AMÉRICA DO NORTE Amortecedor do virabrequim C6C Os fixadores internos do amortecedor de vibração do virabrequim em cerca de 345 dos veículos acima podem soltar-se, o que pode causar ruído no compartimento do motor e danos na tampa da corrente de distribuição dianteira, que, se ignorados, podem resultar em falha do motor.
Emission Recall 83A Sales Code Alignment
DRIER Receiver,COMPRESSOR Air Conditioning Engineering is seeking more information about AC Compressor noise issues. For the vehicle AC Compressor and Receiver Drier noise and/or no AC, call Stellantis Engineering for further instructions. Technician can contact FCA Redacted Content If there is no answer within 15 minutes, please proceed with the repair.
Customer complaints may include abnormal engine noise, rough idle, lack of power, misfire. Upon investigation, it may be found that there is excessive camshaft lobe wear/lifter wear (roller failure) on one or more cam lobes and that camshaft/lifter replacement is necessary.
Coolant Charge Air Cooler Pump Associated To Low Coolant Level or Diagnostic Trouble Codes
Loose Rear Spoiler Scat Pack Badge This bulletin involves inspecting and if necessary, replacing a separating or not adhering chrome Scat Pack badge on the rear spoiler. The customer may describe the following:The chrome letter Scat Pack badge is separating or loose, has gaps or is not adhering to the rear spoiler on the passenger side of the vehicle.
Muffler and tailpipe ? Exhaust
Tube - turbo water feed
Front Engine Cover Oil Weep This bulletin involves inspecting and replacing the right side front engine cover gasket if necessary. The customer may experience an oil weep from the right front engine cover.
Part Description: Exhaust Actuator Issue Description: Please call Jason Maltese at cell (248) 931-4179 or email him at emailjason.maltese@fcagroup.com before replacing this part. Engineering may want to visit dealers in the SE Michigan area to investigate this issue. If no answer and if you do not receive a return call within 15 minutes please continue with the normal repair.
Attention! Release Of New Engine Coolant Organic Additive Technology (OAT) Chrysler Corporation LLC. has released a new engine coolant for the 2013 model year vehicles and beyond, for all engine applications except the ones listed in the note above. This new coolant is an Organic Additive Technology (OAT) (Fig. 1). OAT coolants have a service interval of 10 years or 150,000 miles. For heavy duty truck and extreme duty cycle applications refer to the Service Information or Owner's Manual for proper maintenance schedules.
Part Description: Exhaust Actuator Issue Description: Please call Jason Maltese at cell (248) 931-4179 or email him at emailjason.maltese@fcagroup.com before replacing this part. Engineering may want to visit dealers in the SE Michigan area to investigate this issue. If no answer and if you do not receive a return call within 15 minutes please continue with the normal repair.
Before replacing this part for debris issue faults, please call the following people;~ Engineering is seeking information regarding this part.~ Bob Smith ? Cell (248) 202-9458 - Robert.M.Smith@fcagroup.com~ If a response is not received within 15 mins, then proceed with the necessary repair.~
Fontes: NHTSA (Estados Unidos, domínio público), Transport Canada (Open Government Licence – Canada), DVSA (Reino Unido, Open Government Licence v3.0), RappelConso e Safety Gate da UE (França, Licence Ouverte 2.0), MLIT (Japão, Licença de Dados Públicos 1.0) e MOLIT (Coreia do Sul, car.go.kr).