Leitura livre · conta gratuita para contribuirSucessor do Anticars (2000)

Mazda MPV

1988–2016 · 3 gerações · 25 defeitos documentados · 4 mercados
Gerações
Ano do modelo
MPV II · 1999–2006
RecallModeradoMotorNA

Engine

Certain vehicles previously updated following an emission recall concerning the PCV hose may experience throttle icing during cold weather operation. As a result of misrouting of the PCV hose during the emission recall, moisture build-up inside the hose could freeze while the vehicle is parked. If the vehicle is then driven at constant highway speeds in extremely cold temperatures (-30 degrees Celsius or colder), the moisture in the blow-by gases may freeze in the throttle valve area. Under these conditions, even if the accelerator pedal is released while driving, engine speed may not decrease. Unwanted acceleration could result in a vehicle crash without prior warning. Correction: Dealers will inspect the previously replaced PCV hose for proper routing and reroute if necessary.

Transport Canada10 de fev. de 20062006035Anos-modelo 2002–2003Exibido no inglês original · tradução pendenteVer detalhes →
MPV II · 1999–2006
RecallModeradoMotorNA

Engine

On certain vehicles equipped with a 2.5L V6 Duratec engine, while driving at a constant speed on the highway, it is possible that the engine speed will not decrease when releasing the accelerator pedal due to a frozen throttle valve. This condition occurs at ambient temperatures from -30 to -40 degrees Celsius. The vehicle can be brought to a full stop by depressing the brake pedal. Correction: Dealers will replace the intake manifold and PCV hose with modified parts which will change the layout of the PCV hose system.

Transport Canada20 de out. de 20042004376Anos-modelo 2000–2001Exibido no inglês original · tradução pendenteVer detalhes →
MPV II · 1999–2006
MPV II · 1999–2006
RecallModeradoMotorJP

ブローバイ装置

ブローバイガスを吸気管に導くPCVホースの形状が不適切なため、エンジンの負圧変動 により当該ホースが伸縮する。そのため、そのまま使用を続けると、ブローバイガスまた はオゾンの影響で発生する微細な亀裂が進行し、当該ホースが破損するおそれがある。

MLIT · Japão26 de ago. de 20041112110Anos-modelo 2002–2003Exibido no japonês original · tradução pendenteVer detalhes →
MPV II · 1999–2006
RecallModeradoMotorJP

エンジン一般

オートクルーズ・コントロール装置装着車において、オートクルーズ・コントロール・ケ ーブルの取り付け部に曲げ応力に対する耐久性が不十分なものがあり、そのままの状態で 使用を続けると、当該取り付け部(ケーブルブラケットに固定する部分)に亀裂が生じて 破損することがある。そのため、オートクルーズ・コントロール・ケーブルがケーブルブ ラケットに保持されなくなり、最悪の場合、オートクルーズ・コントロール・ケーブルが アクセルケーブルに引っ掛かり、オートクルーズ・コントロール・ケーブルのインナーワ イヤーが引かれた状態となり、エンジン回転が下がらなくなるおそれがある。

MLIT · Japão10 de jun. de 20041110890Anos-modelo 1999–2002Exibido no japonês original · tradução pendenteVer detalhes →
MPV II · 1999–2006
RecallModeradoMotorNA

Vehicle speed control:Cables

On certain minivans equipped with cruise control, the cruise control actuator cable may be broken due to insufficient strength (group 1). Also included are certain 2000-2001 minivans equipped with cruise control built between march 31, 1999 and march 31, 2001, that have had the cruise control repaired and possibly had a defective cable installed during that repair (group 2).

NHTSA · Estados Unidos19 de mai. de 200404V234000Anos-modelo 2001–2002Exibido no inglês original · tradução pendenteVer detalhes →
MPV II · 1999–2006
RecallModeradoMotorNA

Emissions

Certain vehicles do not comply with the requirements of CMVSS 1101- Emission Device. Inappropriate programming of the Powertrain Control Module.(PCM). Correction: Dealer will reprogram the PCM.

Transport Canada17 de fev. de 20002000029Anos-modelo 2000Exibido no inglês original · tradução pendenteVer detalhes →

Fontes: NHTSA (Estados Unidos, domínio público), Transport Canada (Open Government Licence – Canada), DVSA (Reino Unido, Open Government Licence v3.0), RappelConso e Safety Gate da UE (França, Licence Ouverte 2.0), MLIT (Japão, Licença de Dados Públicos 1.0) e MOLIT (Coreia do Sul, car.go.kr).