losed-circuit Current Measurement. Closed circuit current needs to be measured. Excessive closed-circuit currents may occur continuously or intermittently, and may cause the battery to discharge prematurely. CAUSE The increase in closed-circuit current may be caused by a faulty control unit, or by the installation of a non-approved accessory. INFORMATION In a situation where a vehicle has broken down due to a discharged battery, for diagnostic purposes it is important to not disconnect the battery. This is because a control unit will be reset if the battery is disconnected. Following a reset, the faulty control unit may start functioning correctly again, making accurate diagnosis impossible. To correctly measure closed-circuit current, the 50-amp clip-on probe (previously used with the IMIB) or the 100-amp clip-on probe can now be used in conjunction with the IMIB (Integrated Measurement Interface Box) to properly diagnose closed-circuit current problems over an extended period of time. Connect the amp clip-on probe directly to the IMIB Measurement input 3 (green socket).
NANHTSA · boletim do fabricante10147825
Boletins técnicos
Exibido no inglês original · tradução pendente
Abrange: BMW 1 Series (F40) · BMW 2 Series II · BMW 3 Series (F30) · BMW 5 Series (E28) · BMW 6 Series (E63) · BMW 7 Series E65 · BMW 8 Series (G15) · BMW E24 · BMW Z4 M Coupé (E86) · BMW M Roadster Z4 M Coupé (E86) · BMW M1 · BMW F80 M3 · BMW M5 (F10) · BMW X5 · BMW Z3 · BMW Z4 (E89) · BMW Z8
Fontes: NHTSA (Estados Unidos, domínio público), Transport Canada (Open Government Licence – Canada), DVSA (Reino Unido, Open Government Licence v3.0), RappelConso e Safety Gate da UE (França, Licence Ouverte 2.0), MLIT (Japão, Licença de Dados Públicos 1.0) e MOLIT (Coreia do Sul, car.go.kr).