Sistema de combustível, gasolina: Armazenamento
Em determinados veículos, variações no processo de fabricação ou a exposição a altas temperaturas ambientes podem levar à fratura da válvula de retenção (ICV) da entrada do tanque de combustível.
🔔 Crie uma conta gratuita para receber alertas por e-mail sobre Pontiac Aztek (todas as gerações)
Em determinados veículos, variações no processo de fabricação ou a exposição a altas temperaturas ambientes podem levar à fratura da válvula de retenção (ICV) da entrada do tanque de combustível.
On certain passenger vehicles, a weld between the fuel tank inlet check valve and the fuel tank can fail.
In some of these sport utility vehicles, the diameter of the steering column intermediate shaft is too small.
Vehicle description: Passenger, sport utility vehicles and minivans. The passenger air bag inflator modules were built without the correct amount of generant, which produces the gas that fills the air bag. Some were built with a double load of generant and some were built without generant.
On certain Aztek (AWD), Montana (AWD), Relay (AWD), RendezVous (AWD), RendezVous (FWD), Silhouette (AWD), Terraza (AWD), Terraza (FWD), Uplander (AWD) and Venture (AWD) vehicles equipped with independent rear suspension, when operated in extreme cold temperature and on rough roads, water and salt can intrude past the ball joint seal. The combination of these conditions may then lead to premature wear of the ball joint. If the ball joint wear progresses to the point of separation from the lower control arm, a loss of vehicle control may occur. Correction: Dealers will replace both ball joints with new ball joints which have a revised boot and ball stud to improve the seal to the ball stud shaft.
Em alguns veículos utilitários esportivos, a contaminação nos contatos do relé de ignição pode causar alta resistência. Isso pode afetar os sinais enviados ao módulo de controle do trem de força e, consequentemente, provocar paradas intermitentes do veículo a qualquer momento.
On certain vehicles, the aluminum wheels are not marked with "T" and "DOT" as required by CMVSS 120. Correction: Since this does not pose any safety risk, no corrective action is required.
On certain passenger, sport utility vehicles and mini vans, some of these vehicles have a passenger air bag that was manufactured without a check valve pin. An air bag without the check valve pin could produce increased pressure at the onset of the air bag deployment and reduced pressure afterward.
Vehicle description: Certain mini vans built with second row 50/50 split bench seats or captain's chairs, fail to comply with the requirements of fmvss no. 225, "child restraint anchorage systems." the seat latch anchor wire diameter is greater than 6.1 mm.
Certain minivans, passenger and sport utility vehicles fail to comply with the requirements of federal motor vehicle safety standard no. 225, "child restraint anchorage system." the owner's manual does not explain the meaning of the location symbols for the child restraint lower universal anchorage system.
Fontes: NHTSA (Estados Unidos, domínio público), Transport Canada (Open Government Licence – Canada), DVSA (Reino Unido, Open Government Licence v3.0), RappelConso e Safety Gate da UE (França, Licence Ouverte 2.0), MLIT (Japão, Licença de Dados Públicos 1.0) e MOLIT (Coreia do Sul, car.go.kr).