免费阅读 · 免费账户即可贡献Anticars(2000)的继任者

BMW X7

2018– · 1 各代车型 · 已记录10项缺陷 · 5个市场
各代车型

技术服务通报(TSB)是制造商就已知问题发给经销商的维修说明。它们不是安全召回,但常常能证实某个缺陷。

严重程度全部中等轻微
车型年份
市场全部NA
通报中等其他NA

通报

水在暖通空调(HVAC)系统维修后,从该系统渗漏到地毯上。

NHTSA · 制造商通报11039090车型年份 2026自动翻译 · 原文:英语查看详情 →
通报中等其他NA

通报

A small number of vehicles were produced without the evaporator condensate drain hose being installed.This is not immediately apparent to the customer. However, condensation water that has drained into thefront footwell can cause subsequent damage.

NHTSA · 制造商通报11037846车型年份 2026以原文(英语)显示 · 翻译待完成查看详情 →
通报中等制动NA

通报

After replacement of the Integrated Braking system (IB)/Power Brake the total distance covered might belower than when handed over to the workshop for the repair.

NHTSA · 制造商通报11036380车型年份 2024以原文(英语)显示 · 翻译待完成查看详情 →
通报中等电气NA

通报

Due to an implementation error in various OBD diagnostics in the vehicle's control units, in very rare cases itmay happen that stored fault memory codes (DTCs) and the MIL (warning light) are not automaticallydeleted even though the underlying malfunction has already been rectified. This does not comply with the statutory OBD specifications.

NHTSA · 制造商通报11034449车型年份 2025以原文(英语)显示 · 翻译待完成查看详情 →
通报中等悬架NA

通报

When turning the steering wheel while stationary or when driving on uneven roads; cracking, creaking, or knocking noises may be heard.

NHTSA · 制造商通报11031574车型年份 2024以原文(英语)显示 · 翻译待完成查看详情 →
通报中等制动NA

通报

It was determined that your vehicle was fitted with a brake booster that potentially has a faulty hydraulic valve. This may result in a modified pedal feel and a sporadic red Check Control message. The brake booster should be replaced.

NHTSA · 制造商通报11030319车型年份 2025以原文(英语)显示 · 翻译待完成查看详情 →
通报中等其他NA

通报

Various external influences can cause premature aging of the tension strut hydro-mount elastomer; which can lead to cracks in the material, and leakage.

NHTSA · 制造商通报11029047车型年份 2024以原文(英语)显示 · 翻译待完成查看详情 →
通报中等制动NA

通报

The wheel bearing and the brake disc are not correctly aligned; are not concentric (circled). When applicable work is being performed, it is therefore difficult to remove the wheel bolts from, or fasten them into the wheel bearing hub.

NHTSA · 制造商通报11025672车型年份 2026以原文(英语)显示 · 翻译待完成查看详情 →
通报中等悬架NA

通报

When turning the steering wheel while stationary or when driving on uneven roads; cracking, creaking, or knocking noises may be heard.

NHTSA · 制造商通报11021817车型年份 2024以原文(英语)显示 · 翻译待完成查看详情 →
通报中等悬架NA

通报

The seat lumbar system Massage will not function if the module needs to be initialized. This can occur toeither the drivers and/or passenger side seat. Here is a list of possible faults: Seat pneumatics module front right SPNM _ VR 025908 - SPNMVR: Control unit is not coded 02590B - SPNMVR: Control unit is not encoded for the vehicle 806927 - SPNMVR: Installation location not taught in Seat pneumatics module front left SPNM _ VL 025308 - SPNMVL: Control unit is not coded 02530B - SPNMVL: Control unit is not encoded for the vehicle 8067A7 - SPNMVL: Installation location not taught in Seat Module Driver FAS SMFA 80301E - No seat adjustment because of engine start conditions Seat Module Passenger BFS SMBF 802C1E - No seat adjustment because of engine start conditions Seat Module Drivers Side Rear FAH SMFAH 802E1E - No seat adjustment because of engine start conditions Seat Module Passenger Side Rear BFH SMBFH 802A1E - No seat adjustment because of engine start conditions

NHTSA · 制造商通报11020931车型年份 2024以原文(英语)显示 · 翻译待完成查看详情 →
通报中等制动NA

通报

After programming from the I-Levels between 24-03-505 and lower than 24-03-540 to I-Level 24-11-530 or higher, the following CCM may be displayed: CCM-2525: Brake system. Drive at moderate speed

NHTSA · 制造商通报11020910车型年份 2024以原文(英语)显示 · 翻译待完成查看详情 →
通报中等电气NA

通报

When navigation is selected, only the start animation with the text Starting navigation system... isdisplayed. The Navigation application does not start. This only applies to vehicles where Navigation hasbeen enabled and has been verified to work previously.

NHTSA · 制造商通报11019572车型年份 2025以原文(英语)显示 · 翻译待完成查看详情 →
通报中等悬架NA

通报

The air line on the air suspension supply system may not be properly installed. In the event of a fault, residual pressure is maintained in the struts and corresponding check control message.

NHTSA · 制造商通报11019565车型年份 2025以原文(英语)显示 · 翻译待完成查看详情 →
通报中等悬架NA

通报

The air line on the air suspension supply system may not be properly installed. In the event of a fault, residual pressure is maintained in the struts and corresponding check control message.

NHTSA · 制造商通报11018563车型年份 2025以原文(英语)显示 · 翻译待完成查看详情 →
通报中等电气NA

通报

There is a jerking or shuddering during either or both of the following: Cornering or accelerating from low speeds Driving with low to medium loads There are no warning lights or Check Control messages.

NHTSA · 制造商通报11016472车型年份 2020以原文(英语)显示 · 翻译待完成查看详情 →
通报中等制动NA

通报

After replacement of the Integrated Braking system (IB)/Power Brake the total distance covered might be lower than when handed over to the workshop for the repair.

NHTSA · 制造商通报11013438车型年份 2024以原文(英语)显示 · 翻译待完成查看详情 →
通报中等制动NA

通报

After replacement of the Integrated Braking system (IB)/Power Brake the total distance covered might be lower than when handed over to the workshop for the repair.

NHTSA · 制造商通报11013040车型年份 2024以原文(英语)显示 · 翻译待完成查看详情 →
通报中等制动NA

通报

Improved diagnostic software for the brake system.

NHTSA · 制造商通报11008992车型年份 2024以原文(英语)显示 · 翻译待完成查看详情 →
通报中等制动NA

通报

Improved diagnostic software for the brake system.

NHTSA · 制造商通报11008107车型年份 2024以原文(英语)显示 · 翻译待完成查看详情 →
通报中等电气NA

通报

Due to an installation error, the crankshaft sensor connector may not have been properly locked. In very rare cases, the plug connection may become disconnected. If no signal is sent by the crankshaftsensor, the engine will switch to emergency operation and a Check Control message will occur.

NHTSA · 制造商通报11008104车型年份 2024以原文(英语)显示 · 翻译待完成查看详情 →
通报中等电气NA

通报

There is a jerking or shuddering during either or both of the following: Cornering or accelerating from low speeds Driving with low to medium loads There are no warning lights or Check Control messages.

NHTSA · 制造商通报11006766车型年份 2023以原文(英语)显示 · 翻译待完成查看详情 →
通报中等电气NA

通报

Please have the starter motor checked and, if necessary, replaced in the vehicles concerned (according tothe vehicle identification number selection) if possible before vehicle delivery. If vehicles have already been delivered, please have the measure carried out the next time the vehiclesenter the workshop. A bolting fault on the long bolt screws can cause the magnets in the starter motor to twist. As a result, thepower of the starter motor decreases. As a result, the engine does not start.

NHTSA · 制造商通报11006719车型年份 2024以原文(英语)显示 · 翻译待完成查看详情 →
通报中等电气NA

通报

There is a jerking or shuddering during either or both of the following: Cornering or accelerating from low speeds Driving with low to medium loads There are no warning lights or Check Control messages.

NHTSA · 制造商通报11002858车型年份 2023以原文(英语)显示 · 翻译待完成查看详情 →
通报中等悬架NA

通报

Incorrect adjustment of the front and rear axles may result in steering wheel drift or increased tire wear onthe vehicle.

NHTSA · 制造商通报11000635车型年份 2024以原文(英语)显示 · 翻译待完成查看详情 →
通报中等悬架NA

通报

At low outside temperatures (below 40 degrees F) and slow driving speeds (i.e. when parking, maneuvering)with a large steering angle, the front end can be slightly axially misaligned.

NHTSA · 制造商通报11000563车型年份 2024以原文(英语)显示 · 翻译待完成查看详情 →
更早 →

来源:NHTSA(美国,公有领域)、加拿大交通部(加拿大开放政府许可)、DVSA(英国,开放政府许可 v3.0)、RappelConso 与欧盟 Safety Gate(法国,开放许可 2.0)、日本国土交通省(公共数据许可1.0)、韩国国土交通部(car.go.kr)。