免费阅读 · 免费账户即可贡献Anticars(2000)的继任者

Nissan Murano

2002– · 4 各代车型 · 已记录30项缺陷 · 5个市场
各代车型

Nissan Murano 所有代的全部信息:缺陷、召回、技术通报和讨论。选择某一代以缩小范围。

最严重的缺陷

查看全部 (30) →
m

Airbags: problems reported by owners

158 owners in the United States reported problems with the airbags of this car to NHTSA (model years 2008–2014), typically at around 70,000 miles. Reported consequences: 23 crashes, 26 injuries, 1 death.

✓ Mecafile 对官方数据的分析2008–2014以原文(英语)显示 · 翻译待完成查看详情 →
m
严重发动机NAMurano II · 2007–2014

Engine: problems reported by owners

73 owners in the United States reported problems with the engine of this car to NHTSA (model years 2009–2014), typically at around 75,000 miles. Reported consequences: 1 crash, 3 fires, 1 death.

✓ Mecafile 对官方数据的分析2009–2014以原文(英语)显示 · 翻译待完成查看详情 →
m

Brakes: problems reported by owners

97 owners in the United States reported problems with the brakes of this car to NHTSA (model years 2015–2024), typically at around 22,000 miles. Reported consequences: 9 crashes, 6 fires, 8 injuries.

✓ Mecafile 对官方数据的分析2015–2024以原文(英语)显示 · 翻译待完成查看详情 →

最新官方召回

查看全部 (71) →
Murano IV · 2024–
召回轻微变速箱NA

Visual System

Issue: On certain vehicles, a software problem could cause infotainment system display to remain blank when the vehicle is started. As a result, when the transmission is shifted into reverse gear, the rearview camera image would not appear on the display. Note: This recall only affects certain trim levels. Safety Risk: A rearview camera image that doesn't display could reduce a driver's ability to see behind the vehicle while backing up. This could increase the risk of a crash. Corrective Actions: The company will notify owners by mail and advise you to take your vehicle to a dealership to update the infotainment system software.

加拿大交通部2025年11月26日2025656车型年份 2025以原文(英语)显示 · 翻译待完成查看详情 →
Murano IV · 2024–
召回轻微电气NA

Back over prevention:Software

Nissan North America, Inc. (Nissan) is recalling certain 2025 Murano, 2025-2026 Armada, and Infiniti QX80 vehicles. A software error may occur in the In-Vehicle Infotainment (IVI) system at vehicle startup, resulting in the rearview camera image not displaying when the vehicle is shifted into reverse. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 111, "Rear Visibility."

NHTSA · 美国2025年11月26日25V821000车型年份 2025以原文(英语)显示 · 翻译待完成查看详情 →
Murano IV · 2024–
召回中等制动NA

刹车

问题:在部分车辆上,前制动卡钳可能未被正确制造。因此,卡钳可能开裂,导致制动效能下降。 安全风险:制动效能下降可能导致制动距离延长,并增加发生碰撞的风险。 纠正措施:日产将通过邮件通知车主,并建议您将车辆送至经销商处进行检查,如有必要,更换前制动卡钳。

加拿大交通部2025年3月20日2025148车型年份 2025自动翻译 · 原文:英语查看详情 →

最新技术服务通报

查看全部 (234) →
Murano IV · 2024–
通报轻微其他NA

通报

BSW WARNING WITH C1E00-47 AND/OR C1E80-47 STORED IN SIDE RADAR REAR LH AND/OR SIDE RADAR REAR RH This bulletin is no longer active. Please discard previous versions of NTB26-047.

NHTSA · 制造商通报11039000车型年份 2025以原文(英语)显示 · 翻译待完成查看详情 →
Murano IV · 2024–
通报轻微电气NA

通报

BSW WARNING WITH C1E00-47 AND/OR C1E80-47 STORED IN SIDE RADAR REAR LH AND/OR SIDE RADAR REAR RH IF YOU CONFIRM The BSW warning was displayed, and one or more of the following DTCs are stored as Current: C1E00-47 for "Control Unit" stored in the Side radar "Rear Left" C1E80-47 for "Control Unit" stored in the Side radar "Rear Right" ACTION 1. Confirm the current part number of the Side Radar (Rear LH) and/or Side Radar (Rear RH) that corresponds to the stored DTC(s). 2. Based on the DTCs stored, individually reprogram each applicable Side Radar (Rear LH) and/or Side Radar (Rear RH).

NHTSA · 制造商通报11038998车型年份 2025以原文(英语)显示 · 翻译待完成查看详情 →
Murano IV · 2024–
通报中等悬架NA

通报

ENGINE NO START WITH KEY SYSTEM ERROR AND DTC B2C20-24 STORED IN THE BCM IF YOU CONFIRM The customer states the engine will not start and Key System Error warning is displaying in the Information Display (Combination Meter) (Figure 1), AND DTC B2C20-24 for "STARTER CONTROL RELAY" is stored in the BCM. Figure 1 HINT: This DTC and warning message (Figure 1) may occur if the customer does not place the vehicle in Park Gear according to the Owners Manual for shifter operation. ACTION 1. Confirm the current ECM part number. 2. Confirm the current TCM part number. 3. Reprogram the ECM, and then the TCM, if applicable. 4. Erase the DTCs. IMPORTANT: The purpose of ACTION (above) is to give you a quick idea of the work you will be performing. You MUST closely follow the entire SERVICE PROCEDURE as it contains information that is essential to successfully completing this repair.

NHTSA · 制造商通报11031702车型年份 2025以原文(英语)显示 · 翻译待完成查看详情 →

最新论坛话题

暂无讨论。

缺陷和讨论按代归档:请先在上方选择一代再发布。

来源:NHTSA(美国,公有领域)、加拿大交通部(加拿大开放政府许可)、DVSA(英国,开放政府许可 v3.0)、RappelConso 与欧盟 Safety Gate(法国,开放许可 2.0)、日本国土交通省(公共数据许可1.0)、韩国国土交通部(car.go.kr)。