本档案收录Nissan Murano IV的已知缺陷,由社区撰写并注明出处。阅读免费;注册免费账户即可贡献。当足够多的可信贡献者验证后,缺陷将获得印章。
最严重的缺陷
此筛选条件下暂无已记录的缺陷。
召回轻微变速箱NA
Issue: On certain vehicles, a software problem could cause infotainment system display to remain blank when the vehicle is started. As a result, when the transmission is shifted into reverse gear, the rearview camera image would not appear on the display. Note: This recall only affects certain trim levels. Safety Risk: A rearview camera image that doesn't display could reduce a driver's ability to see behind the vehicle while backing up. This could increase the risk of a crash. Corrective Actions: The company will notify owners by mail and advise you to take your vehicle to a dealership to update the infotainment system software.
召回轻微电气NA
Nissan North America, Inc. (Nissan) is recalling certain 2025 Murano, 2025-2026 Armada, and Infiniti QX80 vehicles. A software error may occur in the In-Vehicle Infotainment (IVI) system at vehicle startup, resulting in the rearview camera image not displaying when the vehicle is shifted into reverse. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 111, "Rear Visibility."
召回中等制动NA
问题:在部分车辆上,前制动卡钳可能未被正确制造。因此,卡钳可能开裂,导致制动效能下降。
安全风险:制动效能下降可能导致制动距离延长,并增加发生碰撞的风险。
纠正措施:日产将通过邮件通知车主,并建议您将车辆送至经销商处进行检查,如有必要,更换前制动卡钳。
通报轻微其他NA
BSW WARNING WITH C1E00-47 AND/OR C1E80-47 STORED IN SIDE RADAR REAR LH AND/OR SIDE RADAR REAR RH This bulletin is no longer active. Please discard previous versions of NTB26-047.
通报轻微电气NA
BSW WARNING WITH C1E00-47 AND/OR C1E80-47 STORED IN SIDE RADAR REAR LH AND/OR SIDE RADAR REAR RH IF YOU CONFIRM The BSW warning was displayed, and one or more of the following DTCs are stored as Current: C1E00-47 for "Control Unit" stored in the Side radar "Rear Left" C1E80-47 for "Control Unit" stored in the Side radar "Rear Right" ACTION 1. Confirm the current part number of the Side Radar (Rear LH) and/or Side Radar (Rear RH) that corresponds to the stored DTC(s). 2. Based on the DTCs stored, individually reprogram each applicable Side Radar (Rear LH) and/or Side Radar (Rear RH).
通报中等悬架NA
ENGINE NO START WITH KEY SYSTEM ERROR AND DTC B2C20-24 STORED IN THE BCM IF YOU CONFIRM The customer states the engine will not start and Key System Error warning is displaying in the Information Display (Combination Meter) (Figure 1), AND DTC B2C20-24 for "STARTER CONTROL RELAY" is stored in the BCM. Figure 1 HINT: This DTC and warning message (Figure 1) may occur if the customer does not place the vehicle in Park Gear according to the Owners Manual for shifter operation. ACTION 1. Confirm the current ECM part number. 2. Confirm the current TCM part number. 3. Reprogram the ECM, and then the TCM, if applicable. 4. Erase the DTCs. IMPORTANT: The purpose of ACTION (above) is to give you a quick idea of the work you will be performing. You MUST closely follow the entire SERVICE PROCEDURE as it contains information that is essential to successfully completing this repair.
来源:NHTSA(美国,公有领域)、加拿大交通部(加拿大开放政府许可)、DVSA(英国,开放政府许可 v3.0)、RappelConso 与欧盟 Safety Gate(法国,开放许可 2.0)、日本国土交通省(公共数据许可1.0)、韩国国土交通部(car.go.kr)。