نشرة
This bulletin contains repair instructions for when an oil leak is present around the ATF sump. 2018 A5 Sportback
🔔 أنشئ حسابًا مجانيًا لتلقي تنبيهات البريد عن Audi إيه4 (كل الأجيال)
النشرات الفنية (TSB) تعليمات إصلاح يرسلها المصنعون إلى وكلائهم بشأن مشكلات معروفة. ليست استدعاءات سلامة، لكنها كثيرًا ما تؤكد وجود عطل.
This bulletin contains repair instructions for when an oil leak is present around the ATF sump. 2018 A5 Sportback
This bulletin contains repair instructions for when an oil leak is present around the ATF sump. Also includes 2018 A5 Sportback.
This bulletin contains repair instructions for when an oil leak is present around the ATF sump.
This bulletin contains repair instructions for when an oil leak is present around the ATF sump.
On-Hoist Inspection Section: Removed "Perform a coolant reservoir cap pressure test via ELSA -> Enter VIN # -> Repair manual Engine -> 4-Cylinder Direct Injection 1.8L; 2.0L 4V TFSI Engine (Generation III) -> 19 Cooling System -> Coolant System/Coolant -> Cooling System, Checking for Leaks -> Pressure Relief Valve in Cap, Checking. Only the procedure ?Pressure Relief Valve in Cap, Checking? should be performed in the document Cooling System, Checking for Leaks
"for a4 sedan only: Added to on-hoist inspection section: ""perform a coolant reservoir cap pressure test via elsa -> enter vin # -> repair manual engine -> 4-cylinder direct injection 1.8l; 2.0l 4v tfsi engine (generation iii) -> 19 cooling system -> coolant system/coolant -> cooling system, checking for leaks -> pressure relief valve in cap, checking. Only the procedure pressure relief valve in cap, checking should be performed in the document cooling system, checking for leaks"""
A small amount of dry or crusted coolant is seen on the coolant pump housing. The coolant level warning is not on. A minor coolant leak is possible during the break-in phase of the coolant seal on the coolant pump. The dry coolant marks are normal.
Supersedes Technical Service Bulletin Group 19 number 13-42 dated July 11, 2013. Customer may report coolant leaking from the engine area. The leak can be traced to the connection of the water pump and the hose leading to the heater core. The seal ring is not the cause of the leak.
Supersedes Technical Service Bulletin Group 19 number 13-40 dated June 17, 2013. Customer may report coolant leaking from the engine area. The leak can be traced to the connection of the water pump and the hose leading to the heater core. The seal ring is not the cause of the leak.
Customer may report coolant leaking from the engine area. The leak can be traced to the connection of the water pump and the hose leading to the heater core. The seal ring is not the cause of the leak.
Supersedes Technical Service Bulletin Group 19 number 13-36 dated April 15, 2013. Customer may report coolant leaking from the engine area. The leak can be traced to the connection of the water pump and the hose leading to the heater core. The seal ring is not the cause of the leak.
MIL on. DTCs for the cam actuators are stored in ECM memory. After the activation of the cam actuator to change to the other cam profile, the pin of the actuator is pushed back in by the cam. This is confirmed by a voltage impulse, which is registered by the engine control unit and confirms the operation. If this does not happen, or not at the right time, a DTC "implausible signal" is saved in ECM memory. Check the distance of the pin tip of the cam actuator for valve lift system to the camshaft when it is not operated with a gauge. The measurement of the tip to the basic camshaft circle outside of the groove must be taken. If this measurement is 0.9mm, the actuator 06E103697J must be installed. The actuator 06E103697J must only be used, if the measurement is 0.9mm or bigger.
Supersedes Technical Service Bulletin Group 19 number 13-44 dated July 18, 2013. Customer may report coolant leaking from the engine area. The leak can be traced to the connection of the water pump and the hose leading to the heater core. The seal ring is not the cause of the leak.
Audi: The connection of water pump and hose, on some vehicles, leading to heater core, has a coolant leakage from engine area and seal ring is not the cause. Model 2009-2013 a4, a5, q5, a6. *pe
Audi: On the turbocharger engine, the coolant supply line may leak, within a specific period and needs to be replaced. *pe
Audi service campaign: See document search button for owner letter. Under certain conditions the coolant pump may leak. *rm
Audi: It is possible that the coolant supply line at the turbocharger may leak on audi vehicles with 2.0l tfsi engines built within a specific period. *pe
Audi: It is possible that the coolant supply line at the turbocharger may leak on vehicles with 2.0l tfsi engines built within a specific period. *pe
Audi: Engine oil may be leaking from upper engine area. Due to the porosity of the cam carrier casting, oil can drain into the thread of the cam bolt and cause an external engine leak. All bolts are installed with loctite. *pe
Engine stumbles after cold start / warm engine may attempt to stall in idle when engaging gear with vehicle stationary. *tt
This TSB provides information about engine control unit drive system faults P060C00 and U041600.
This bulletin provides information when the MIL is on, DTC P310B00 in ECM; Vapor pocket formation in fuel system.
This bulletin provides informatin when the engine does not run smoothly at idling speeds.
This bulletin provides information when the MIL is on; DTCs for misfire, air/fuel ratio imbalance, or lean fuel system stored in the ECM P030000.
This bulletin provides informatin when the engine does not run smoothly at idling speeds.
المصادر: NHTSA (الولايات المتحدة، ملك عام)، وزارة النقل الكندية (رخصة الحكومة المفتوحة – كندا)، DVSA (المملكة المتحدة، رخصة الحكومة المفتوحة 3.0)، RappelConso وSafety Gate الأوروبي (فرنسا، الرخصة المفتوحة 2.0)، ووزارة MLIT اليابانية (رخصة البيانات العامة 1.0)، ووزارة MOLIT الكورية (car.go.kr).