Technische Bulletins (TSB) sind Reparaturanweisungen, die Hersteller ihren Händlern zu bekannten Problemen schicken. Sie sind keine Sicherheitsrückrufe, bestätigen aber oft einen Mangel.
?ANTENNA - A technical problem has occurred. Please contact your Audi dealer" is displayed in the driver information panel when in the SiriusXM band. Audio from the satellite radio is present. DTC 02617 (Satellite antenna) is stored in the radio (address word 56) with fault code 11 (Open circuit). Visually, the MMI and MIB antennas are the same, but each antenna draws a different amount of current. For this reason, if an MIB antenna has been installed on a vehicle with an MMI radio, it causes an open circuit DTC. The open circuit DTC will be set on an MMI radio if the current draw from the antenna falls below 60mA . A MIB antenna draws 55mA (+/- 10mA) 4G0-035-503-K. A MMI antenna draws 110mA (+/- 10mA) 4G0-035-503-J.
Großer Wartungsabschnitt: GEÄNDERT: "(außer Audi A3 e-tron)" zu (nur Audi A3 etron)" am Ende von "Kühlsystem für elektrische Bauteile: Kühlmittelstand gemäß Beschreibung in ElsaPro prüfen" HINZUGEFÜGT: "(außer A3 e-tron)" am Ende von "Kühlsystem - Kühlmittelstand prüfen und bei Bedarf Kühlmittel hinzufügen"
This bulletin provides software update instructions for warning messages in the MMI when a user tries to manually refresh data or the vehicle cannot be locked or unlocked.
This document contains the Audi pre-delivery inspection checklist. All items must be completed prior to customer delivery by an Audi technician. Audi recommends using an Audi approved battery charger to prevent excessive battery discharge during inspection. Refer to the Special functions tab of ODIS Diagnosis using GFF for the PDI function tests. It is advised to start ODIS with the engine running to enable all 5F Test Plans in GFF and also to ensure SVM sees all control units during the SVM check vehicle configuration. For items marked with *, please refer to the PDI Technician Reference Document posted on ServiceNet for additional information.
This document contains the Audi pre-delivery inspection checklist. All items must be completed prior to customer delivery by an Audi technician. Audi recommends using an Audi approved battery charger to prevent excessive battery discharge during inspection. Refer to the Special functions tab of ODIS Diagnosis using GFF for the PDI function tests. It is advised to start ODIS with the engine running to enable all 5F Test Plans in GFF and also to ensure SVM sees all control units during the SVM check vehicle configuration. For items marked with *, please refer to the PDI Technician Reference Document posted on ServiceNet for additional information. This document is in Spanish.
This document contains the Audi pre-delivery inspection checklist. All items must be completed prior to customer delivery by an Audi technician. Audi recommends using an Audi approved battery charger to prevent excessive battery discharge during inspection. ALL PDI function tests must be run in Guided Fault Finding (GFF) only. Do NOT use Guided Functions for any PDI related test as these will not be uploaded to the Paperless Server. Refer to the Special functions tab of ODIS Diagnosis for using GFF for PDI function tests. It is advised to start ODIS with the engine running to enable all 5F Test Plans in GFF and also to ensure SVM sees all control units during the SVM check vehicle configuration. For items marked with *, please refer to the PDI Technician Reference Document posted on ServiceNet for additional information.
This document contains the Audi vehicle detail report checklist. DO NOT use accessories (radio, etc.) while performing detail, as this can discharge the battery. Refer to TSB 2009967 for Detailer responsibilities, specific use of chemicals, and for part numbers to order materials. Only operate power convertible top with engine running to conserve battery power (A5/S5 Cab, R8 ONLY). DO NOT allow convertible top to remain in a partially opened or partially closed position for longer than 5 minutes. This will cause the top to stop functioning and will require service (A5/S5 Cab, R8 ONLY). DO NOT treat vehicle parts painted with matte finish paint using polishing materials or hard wax. NEVER use protective wax. It can destroy the matte finish effect. Only use a microfiber cloth for cleaning (R8 ONLY).
This document contains the Audi vehicle detail report checklist. DO NOT use accessories (radio, etc.) while performing detail, as this can discharge the battery. Refer to TSB 2009967 for Detailer responsibilities, specific use of chemicals, and for part numbers to order materials. Only operate power convertible top with engine running to conserve battery power (A5/S5 Cab, R8 ONLY). DO NOT allow convertible top to remain in a partially opened or partially closed position for longer than 5 minutes. This will cause the top to stop functioning and will require service (A5/S5 Cab, R8 ONLY). DO NOT treat vehicle parts painted with matte finish paint using polishing materials or hard wax. NEVER use protective wax. It can destroy the matte finish effect. Only use a microfiber cloth for cleaning (R8 ONLY). This document is in Spanish.
Side assist inoperative or warning about sensor vision. Audi side assist (lane change assist) does not work. A warning about sensor vision appears in the driver information system. DTCs B200000, C111504, C1114F3, or C1115F5 may be stored in the lane change assistance control module. Defective internal control unit component. Production Solution is improved hardware.
Quellen: NHTSA (USA, gemeinfrei), Transport Canada (Open Government Licence – Canada), DVSA (Vereinigtes Königreich, Open Government Licence v3.0), RappelConso und EU-Safety-Gate (Frankreich, Licence Ouverte 2.0), MLIT (Japan, Public Data License 1.0) und MOLIT (Südkorea, car.go.kr).