Lenkung:Hydraulische Servounterstützung:Schläuche, Leitungen und Verbindungen
Bei bestimmten Pkw mit 2,4-Liter-Motoren kann der Hochdruck-Servolenkungsschlauch vorzeitig thermisch altern und undicht werden.
🔔 Kostenloses Konto anlegen und Benachrichtigungen zu Chrysler Cirrus (alle generationen) erhalten
Bei bestimmten Pkw mit 2,4-Liter-Motoren kann der Hochdruck-Servolenkungsschlauch vorzeitig thermisch altern und undicht werden.
Vehicle description: Passenger vehicles. Some of these vehicles may have been built with an inadequate weld between the right front brake hose block and the stand-off bracket.
Vehicle description: Passenger vehicles. The rear seat belt anchor does not achieve the loading required by fmvss no. 210, "seat belt assembly anchorages."
Vehicle description: Passenger vehicles. The lower control arm ball joint can separate due to loss of lubrication.
In bestimmten Fahrzeugen dichtet der Verschlussstopfen der Ölgalerie im Motorzylinderkopf nicht richtig ab, und das Motoröl im Zylinderkopf wird nicht ausreichend zurückgehalten.
An engine cylinder head oil galley plug may not be adequately retained. Inadequate retention of the plug may result in oil leakage which could potentially cause a fire in the engine compartment. Correction: An expansion plug and retaining bracket will be installed over the suspect cylinder head oil galley plug.
Bei bestimmten Personenkraftwagen kann die Zündschloss-Parksperre des Bodenschalthebels versagen, sodass der Schalthebel bei abgezogenem Schlüssel aus der Parkstellung bewegt werden kann. Eine funktionsunfähige Sperre kann außerdem dazu führen, dass der Schlüssel abgezogen werden kann, obwohl der Schalthebel nicht in die Parkstellung gebracht wurde.
Fahrzeugbeschreibung: Pkw. Die rechte hintere Bremsleitung kann den Auspuffanlagenbügel berühren und ein Loch in ihn scheuern.
On certain vehicles, incorrect weld wire, in combination with the stainless steel shell of the catalytic converter, will cause rusting at the weld joints and premature failure to the converter assembly. Correction: Dealers will replace the catalytic converter.
Note: Vehicles equipped with a floor mounted automatic transmission shift lever. A combination of applying a mis-adjusted shifter release button with a low force attempt to shift out of park with the key in the locked position may break the connecting pin in the shifter. If this happens, the "ignition-park" interlock system will not function. Correction: The console shift interlock mechanism will be inspected for proper function. Any vehicles that are not functional after the inspection will have the shift mechanism and cable replaced with a current production "self adjusting" design.
Vehicle description: Passenger vehicles equipped with automatic transmissions. The adjustment of the cable connecting the console shifter mechanism to the ignition key can cause a trapped key condition which can result in a low force required to depress the shift button. A combination of applying a mis-adjusted release button with a low force attempt to shift out of park with the key in the locked position, can break the connecting pin in the shifter.
These vehicles may not comply with c.M.V.S.S. 210 - seat belt assembly anchorages. The rear seat belt anchor may not achieve the loading required by the standard during testing. Correction: The rear outboard seat belt anchor floor attachments will be inspected for orientation and repositioned if required.
Certain vehicles do not comply with CMVSS 1103 - exhaust emissions. The calibration of the Powertrain Control Module (PCM) may fail to adequately control CO emissions. Correction: PCM will be reflashed with a new calibration.
On certain vehicles, the lower control arm ball joint may separate due to loss of lubrication. This separation could result in loss of vehicle control and a crash without prior warning. Correction: Ball joint end housing cover seal will be inspected for leakage and the rubber boot will be inspected for damage. If the cover seal leaks or the boot is damaged, the lower control arm will be replaced.
The primary/secondary hood latch spring may not remain in position during hood closing, which can result in loss of both the primary and secondary latch function. Loss of hood function can result in a hood fly-up condition. Correction: The secondary hood latch spring will be replaced with one having a longer end hook.
Vehicle description: Passenger vehicles. The secondary hood latch spring can disengage from its retention hole if the hood is slammed shut.
On certain vehicles, the brake master cylinder may leak brake fluid due to a damaged double lip rear piston seal. Brake fluid leakage may result in diminished effectiveness of one portion of the split brake system. Correction: Rear brake master cylinder piston assemblies will be replaced.
Corrosion of the abs hydraulic control unit may cause the solenoid valves to stick in the open position. If either front wheel valve sticks, the vehicle may tend to deviate from a straight stop when the brakes are applied. Correction: A plate will be installed on the abs hydraulic control unit and silicone grease injected into the solenoid cavity to eliminate the potential for this condition.
The brake master cylinder can leak brake fluid due to a damaged double lip rear piston seal.
Corrosion of the abs hydraulic control unit can cause the solenoid valves to stick in the open position.
Fahrzeugbeschreibung: Bestimmte Personenkraftwagen, Pickup-Trucks und Sport Utility Vehicles erfüllen die Anforderungen von FMVSS Nr. 225, „Child Restraint Anchorage Systems" (Verankerungssysteme für Kindersitze), nicht. Einige Betriebsanleitungen für diese Fahrzeuge enthalten keine Anweisungen mit einer schrittweisen Vorgehensweise, einschließlich Abbildungen, zum ordnungsgemäßen Befestigen des Haltegurts eines Kindersitzsystems an der Haltegurtverankerung.
Vehicle description: Passenger vehicles. The affected vehicles were built with unpainted fuel tank straps.
Vehicle description: Passenger vehicles. The affected vehicles were built with incorrect child lock instruction labels.
Quellen: NHTSA (USA, gemeinfrei), Transport Canada (Open Government Licence – Canada), DVSA (Vereinigtes Königreich, Open Government Licence v3.0), RappelConso und EU-Safety-Gate (Frankreich, Licence Ouverte 2.0), MLIT (Japan, Public Data License 1.0) und MOLIT (Südkorea, car.go.kr).