Vehicle description: Mini vans equipped with 2-spoke luxury wheels manufactured july 1992 through june 1993; or equipped with 4-spoke sport wheels manufactured from july 1992 through september 1993. The steering wheel armature stamping can crack and separate from the center hub attachment to the steering column.
Die Stanzteile des Lenkradskeletts können reißen und sich von der mittleren Nabe der Lenksäule lösen. Dadurch könnte die Lenkkontrolle beeinträchtigt werden und es könnte ohne vorherige Warnung zu einem möglichen Unfall kommen.
Korrektur: Lenkräder mit Rissen werden ersetzt. Bei allen übrigen betroffenen Fahrzeugen wird eine Anti-Lösungs-Platte installiert, um das Lösen des Lenkrads von der Lenksäule zu verhindern.
Improper stamping of the fuel tank flanges could result in damage to the fuel tank mounting straps and/or the fuel lines which in turn could result in fuel tank separation or fuel leakage. Correction: Vehicles will be inspected for proper fuel tank flange bends and if necessary the flange will be bent to the specified angle. Damaged mounting straps and fuel lines will be replaced as required.
Transport Canada19. Nov. 19921992147Modelljahre 1992Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Eine Lenksäulen-Kupplungsschraube kann aufgrund von Wasserstoffversprödung brechen, wodurch die Klemmkraft auf die Verbindung der Lenksäulenwelle verloren geht und sich daraus ein Verlust der Lenkkontrolle ergeben kann. Korrektur: Verzinkte Lenksäulen-Kupplungsschrauben werden durch eine phosphatierte Schraube ersetzt.
On certain vehicles equipped with an anti-lock brake system (ABS), the high pressure hose may leak or detach due to inadequate crimping of the hose-to-end fittings. This condition could result in loss of brake power assist and a possible increase in stopping distances. Correction:(526) ABS high pressure hose will be replaced with a hose of different design and construction. (527) four hundred and twenty six of the identified mini vans will also have the ABS pump casting inspected for porosity. Leaking pumps, if found, will be replaced.
Transport Canada20. Nov. 19911991157Modelljahre 1991Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Continued flexing of the inboard front seat belt buckle assembly straps can result in eventual strap failure near the anchor location. This could result in the increased risk of front seat occupant injury during a sudden stop or vehicle crash. Correction: Straps will be inspected and reinforced or replaced with a strengthened version as required.
Transport Canada18. Apr. 19911991065Modelljahre 1990Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Bei Fahrzeugen mit 2,2-Liter- oder 2,5-Liter-EFI-Motor (ohne Turbolader) kann die Ventildeckeldichtung undicht werden und Öl austreten lassen, wodurch die Gefahr eines Motorraumbrandes entsteht. Korrektur: Die Ventildeckeldichtung wird durch einen überarbeiteten Ventildeckel ersetzt, und anstelle der Dichtung wird RTV-Dichtmasse aufgetragen.
Vehicle description: Mini vans. The bolts used to attach the strut to the body and the rear liftgate can accumulate fatigue damage if three factors combine. If the bolt is loose, the gas strut is over-pressurized, and the frequency of opening and closing cycles is higher than for the average customer, the bolt can fail.
Vehicle description: Mini vans. The wiring that initiates the driver and/or passenger air bag could electrically short circuit to ground. A short circuit to ground that exists immediately after turning the ignition key to the "on" or "start" position can cause the air bag(s) to inadvertently deploy.
NHTSA · USA6. Mai 199999V113000Modelljahre 1993–1995Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
The first row rear seat outboard side seat belt anchor hook can become unattached from the body anchor position. Also, the covers on solid stalk mounted seat belt buckles may become dislodged. Should a cover become dislodged, the release button may stick inside the cover creating the potential for the buckle to become partially latched. In the event of a vehicle crash, either of these conditions could result in the occupant not being properly restrained. Correction: Anchor hook retaining clip will be replace with a revised profile clip and cover plate. Dealers will also install a cover retaining clip to the stalk mounted buckle cover to prevent dislocation of the buckle cover.
Transport Canada29. Sept. 19971997162Modelljahre 1991–1993Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Vehicle description: Passenger mini-vans. The center rear seat, right outboard side, safety belt anchor hook can become unattached from the body anchor position.
Vehicle description: Passenger mini-vans. Covers on the solid stalk mounted seat belt buckles can become dislodged causing the release button to stick inside the cover. The buckle would then be only partially latched.
The bolts used to attach the strut to the body and the rear liftgate can accumulate fatigue damage if three factors combine. If the bolt is loose, the gas strut is over-pressurized, and the frequency of opening and closing cycles is higher than for the average customer, the bolt can fail.
NHTSA · USA16. Mai 199797V079000Modelljahre 1992Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Die hydraulische ABS-Steuereinheit kann übermäßigen Verschleiß der Dichtungen der Bremsaktuator-Kolben erleiden, was zu einer Verschlechterung des Pumpenmotors führt.
Wheels with misformed lug nut seats were installed on these vehicles. This causes reduced nut to wheel contact area and limits the wheel self-centering capability during installation. This results in loss of wheel lug nut torque retention.
Vehicles equipped with 15" stamped road wheels or spare wheel may have a misformed wheel lug nut seat configuration. This could cause a reduced nut to wheel contact area and limit the wheel self centering capability during installation. This could result in loosening of the wheel lug nuts and possible wheel loss. Correction: Suspect wheels will be replaced and installed with new lug nuts.
Transport Canada8. Juni 19931993086Modelljahre 1993Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Quellen: NHTSA (USA, gemeinfrei), Transport Canada (Open Government Licence – Canada), DVSA (Vereinigtes Königreich, Open Government Licence v3.0), RappelConso und EU-Safety-Gate (Frankreich, Licence Ouverte 2.0), MLIT (Japan, Public Data License 1.0) und MOLIT (Südkorea, car.go.kr).