Technische Bulletins (TSB) sind Reparaturanweisungen, die Hersteller ihren Händlern zu bekannten Problemen schicken. Sie sind keine Sicherheitsrückrufe, bestätigen aber oft einen Mangel.
Flash: Aktualisierungen des Antriebsstrang-Steuermoduls (PCM)
Kunden müssen eine Leuchte der Motorkontrollanzeige (Malfunction Indicator Lamp, MIL) aufleuchten sehen, und das Fahrzeug muss einen oder mehrere der folgenden Diagnostic Trouble Codes (DTCs) anzeigen/speichern: **P0420 - Katalysator-Systemwirkungsgrad unterhalb des Schwellenwerts Bank 1. P0430 - Katalysator-Systemwirkungsgrad unterhalb des Schwellenwerts Bank 2.** P0456 - EVAP-System, kleine Leckage. **Kunden können außerdem Folgendes bemängeln: Fahrzeug besteht die Abgasuntersuchung (Emissionsprüfung) nicht.* Bei dieser Technischen Information wird das PCM mit der neuesten verfügbaren Software neu programmiert.
Part Description: Mirror, Side View Issue Description: New mirror now includes a grommet on the electrical wire. If the mirror being removed from the vehicle does not have a grommet and the new mirror does, this is not an issue. Install the new mirror and grommet.
Part Description: 5.7L Long Block Issue Description: This 5.7L Long Block Assembly is compatible with both EGR and Non-EGR applications. An EGR Block-Off Plate (53032739AA) must be ordered when installing this Long Block Assembly in a Non-EGR application. Unless, the EGR Block-Off Plate is being transferred from the old engine.
Kundenzufriedenheitsmitteilung T12 VECI-Etikett
Das Fahrzeugemissions-Kontrollinformations-Etikett (VECI-Etikett) bei etwa 120.000 der oben genannten Fahrzeuge enthält möglicherweise keine Emissionskontrollinformationen. Das VECI-Etikett wird häufig bei der Prüfung und Wartung im Betrieb (Inspection and Maintenance, I/M) verwendet, um die ordnungsgemäße Funktion emissionsrelevanter Bauteile zu überprüfen. Falsche Angaben auf dem VECI-Etikett könnten im Bundesstaat Kalifornien zur Verweigerung der Fahrzeugzulassung führen. Ein neues VECI-Etikett muss installiert werden.
Service - Four Piece Oil Pan Gasket All Cummins Equipped Vehicles ONLY - The replacement oil pan gasket can be a four piece gasket rather than a single piece gasket. This applies to Cummins 5.9L and 6.7L engines only. Installation: 1. Clean the oil pan T-joints.~ 2. Fill the T-joint between the pan rail/gear housing and pan rail/rear seal retainer with sealant. Use Mopar Silicone Rubber Adhesive Sealant or equivalent. 3. Apply a 2-mm [0.063-in] bead of Mopar Engine Sealant RTV Silicone Rubber Adhesive, to the oil pan flange.~ 4. The four piece gasket will need to be assembled to make a complete oil pan gasket. 5. Lay the oil pan gasket(s) onto the oil pan flange.~ 6. Ensure the oil pan gasket segment joints are properly aligned. 7. Apply a 2-mm [0.063-in] bead of Mopar Engine Sealant RTV Silicone Rubber Adhesive, to the top of the oil pan gasket.~ 8. Install the oil pan. Starting from the center and working outward, tighten the oil pan bolts to 28 Nm [21 ft. lbs.].
Part Description: 5.7L Long Block Issue Description: This 5.7L Long Block Assembly is compatible with both EGR and Non-EGR applications. An EGR Block-Off Plate (53032739AA) must be ordered when installing this Long Block Assembly in a Non-EGR application. Unless, the EGR Block-Off Plate is being transferred from the old engine.
Part Description: Mirror, Side View Issue Description: New mirror now includes a grommet on the electrical wire. If the mirror being removed from the vehicle does not have a grommet and the new mirror does, this is not an issue. Install the new mirror and grommet.
SEAL, Input If looking to replace stubshaft due to ATX fluid leaking, do not replace PTU seals. None of the seals from the PTU side will need to be replaced whenever the ATX stubshaftis replaced, even though V-seal (68408748A$) is in direct contact with the stubshaft,it will not avoid grease/oil leakage from transmission side. PTU V-seals are intended to act as a dust cover for stubshaft-PTU input shaft spline interface. PTU Input shaft seal (68408749A$) is intended to hold PTU oil and debris ingress; it should be replaced only if the fluid leakage is confirmed to be PTU oil and not ATX trans. fluid.
Part Description: Mirror, Side View Issue Description: New mirror now includes a grommet on the electrical wire. If the mirror being removed from the vehicle does not have a grommet and the new mirror does, this is not an issue. Install the new mirror and grommet.
Radiator If vehicle comes in for transmission fluid leaking from trans-oil cooler fittings on the radiator, please check the following before replacing the radiator/cooler:~ 1. Remove both of the transmission lines from the cooler?s top/bottom flared fittings on the radiator. ~ 2. Loosen the hex nut on the top flared fitting on the radiator tank.~ 3. Torque the top flared fitting to 235 +/- 15 Lb-In.~ 4. Torque hex nut to 100 +/- 10 Lb-In.~ 5. Repeat for bottom flared fitting.~ 6. Reinstall transmission line per normal installation procedures and ensure correct fluid level.~ ~ If vehicle is in need of a new radiator for another reason, check the new radiator for correct torque on the trans-oil cooler fitting per steps 2-5 above.~ ~ If radiator has a yellow mark by the trans-oil cooler fittings the torque does not have to be checked.
Oem torque specifications for the steering shaft have been identified and are now being used in the installation of the vmi steering extension. This sb notifies the technicians to ensure the torque specifications for the steering extension have been complied with at the factory. This will bring the van into conformance with vmi updated processes
Oem torque specifications for the steering shaft have been identified and are now being used in the installation of the vmi steering extension. This sb notifies the technicians to ensure the torque specifications for the steering extension have been complied with at the factory. This will bring the van into conformance with vmi updated processes
"flash: Powertrain diagnostic and system improvements this bulletin involves selectively erasing and reprogramming the powertrain control module (pcm) with new software. Symptom/condition: A small number of customers may experience a malfunction indicator lamp (mil) illumination. Upon further investigation the technician may find one or more of the following diagnostic trouble codes (dtcs) set in the pcm: Jc vehicles 3.6l: P0335 - crankshaft position sensor circuit. P2610 - pcm internal engine off timer performance. U0140 - lost communication with body control module (bcm). P0456 - evap system small leak. P0108 - manifold absolute pressure sensor circuit high (2012 my only). The following transmission enhancements are also included in this software update: Continuous cycling of fuel pump relay when using remote start. 1 - 2 upshift clunk or bump. 3 - 4 harsh upshift at closed throttle after a wot stab in 1st or 2nd gear. 4 - 5 upshift clunk or bump. 5 - 6 upshift clunk or bump. 5- 4 downshift clunk or bump. 6 - 5 downshift clunk or bump. Rpm fluctuating or jerking while operating in cruise control. Condition is more noticeable when the vehicle is going up and down grades. Improves the consistency of how shifts are controlled during upshifts torque management. Delayed downshifts. Jc vehicles 2.4l: **u0140 - lost communication with body control module (bcm).** p0456 - evap system small leak. The following transmission enhancements are also included in this software update: 1 - 2 upshift clunk or bump. 3 - 4 harsh upshift at closed throttle after a wot stab in 1st or 2nd gear. 4 - 5 upshift clunk or bump. Rpm fluctuating or jerking while operating in cruise control. Condition is more noticeable when the vehicle is going up and down grades. 1 - 2 harsh upshift going down a grade. 3 - 2 downshift clunk or bump. 4 - 3 downshift clunk or bump.
Chrysler/dodge: When braking, steering wheel would shake, brake pedal pulsates and/or floor pan vibrates and need to replace, both, front brake rotors, right and left front lower control arms, brake linings and resurfacing, and install new right and left front lower control arms. Model 2011-2012 caravan, town and country. *pe
Chrysler/dodge service campaign: See document search button for owner letter. The low pressure power steering hose on certain vehicles may leak under certain extreme cold climate operating conditions. This result in a loss of power steering assist upon vehicle start up. Csc letter was received. *pe
Chrysler\dodge\jeep service campaign: See document search button for owner letter. Emissions recall h06-spark plugs. Approximately 440 engines in the above vehicles may have had incorrect spark plugs inadvertently installed in three of the six cylinders. Csc was received. *pe
Quellen: NHTSA (USA, gemeinfrei), Transport Canada (Open Government Licence – Canada), DVSA (Vereinigtes Königreich, Open Government Licence v3.0), RappelConso und EU-Safety-Gate (Frankreich, Licence Ouverte 2.0), MLIT (Japan, Public Data License 1.0) und MOLIT (Südkorea, car.go.kr).