Kraftfahrzeuge - Karosserie (Insassenschutzmittel)
Der Gewichtssensor des Beifahrersitzes funktioniert aufgrund einer defekten Leiterplatte nicht richtig.
🔔 Kostenloses Konto anlegen und Benachrichtigungen zu Honda Odyssey (alle generationen) erhalten
Der Gewichtssensor des Beifahrersitzes funktioniert aufgrund einer defekten Leiterplatte nicht richtig.
The Supplemental Restraint System (SRS) control module contains incorrect deployment parameters for the side and head airbags, which could cause them to deploy inadvertently when the vehicle experiences road impacts. This increases the risk of accidents and injuries.
Aufgrund einer fehlerhaften Platine im Gewichtssensor des Beifahrersitzes kann das System zur Erkennung der Sitzbelegung auf dem Beifahrersitz einen Fehler des Lenkradsensors (Steering Wheel Sensor, SWS) erkennen, und die Kontrollleuchte des Rückhaltesystems (Supplemental Restraint System, SRS) kann sich einschalten. Dadurch kann es zu einer fehlerhaften Auslösung der Airbags kommen, wodurch für ein auf dem Beifahrersitz sitzendes Kind das Verletzungsrisiko steigt.
Problem: Bei bestimmten Fahrzeugen ist der Gewichtssensor für den Beifahrersitz vorne möglicherweise nicht richtig gefertigt. Daher könnten der Beifahrer-Frontairbag und der Knieairbag bei einem Unfall, der dies nicht erfordert, ausgelöst werden. Hinweis: Dieser Rückruf ist eine Erweiterung des Transport Canada Rückrufs Nr. 2024-059. Wenn der Gewichtssensor ausfällt, würde die SRS-Warnleuchte im Instrumentenpanel eingeschaltet werden. Sicherheitsrisiko: Ein Airbag-System, das nicht richtig funktioniert, kann das Verletzungsrisiko bei einem Unfall erhöhen. Korrekturmaßnahmen: Das Unternehmen informiert die Besitzer per Post und rät Ihnen, Ihr Fahrzeug zu einem Händler zu bringen, um den Beifahrer-Vordersitz-Gewichtssensor zu ersetzen.
Issue: On certain vehicles, under certain conditions, a software problem could cause the side airbag(s) and side curtain airbag(s) to inflate unexpectedly. Safety Risk: An airbag that deploys without a crash could create a risk of injury. Corrective Actions: Honda will notify owners by mail and advise you to take your vehicle to a dealership to reprogram or replace the supplemental restraint system (SRS) electronic control unit (ECU), as necessary.
Bei der Abhilfemaßnahme für die Niederdruck-Kraftstoffpumpe wurden aufgrund fehlerhafter Verpackung der Abhilfeteile teilweise falsche Dichtungen ausgeliefert. Dadurch können bei der Abhilfemaßnahme falsche Dichtungen eingebaut werden, sodass die Dichtwirkung zwischen Kraftstoffpumpe und Kraftstofftank unzureichend ist und bei vollgetanktem Fahrzeug Kraftstoff austreten kann.
Issue: On certain vehicles, water could enter the steering gearbox assembly and cause the gears to corrode and stick together. If this happens, there could be a loss of steering control. Safety Risk: A loss of steering control could create the risk of a crash. Corrective Actions: Honda will notify owners by mail and advise you to take your vehicle to a dealership to replace the electric power steering rack.
Honda (American Honda Motor Co.) is recalling certain 2023-2024 Odyssey and 2024 Acura RDX vehicles. The steering gear box assembly may not have been tightened properly, allowing water to enter the assembly and cause corrosion and binding gears.
Issue: On certain vehicles, the weight sensor for the front passenger seat may not have been manufactured properly. As a result, the passenger-front airbag and knee airbag could deploy in a crash that doesn't require them to. Note: If the weight sensor fails, the SRS warning light would turn on in the instrument panel. Safety Risk: An airbag system that doesn't work properly could increase the risk of injury in a crash. Corrective Actions: Honda will notify owners by mail and advise you to take your vehicle to a dealership for an inspection if the SRS warning light is on. If the SRS warning light is on due to a faulty weight sensor, the weight sensor will be replaced. When repair parts are available, Honda will send you a second letter. They will advise you to take your vehicle to a dealership to replace the passenger-front seat weight sensor.
Honda (American Honda Motor Co.) is recalling certain 2015-2020 Acura TLX, 2016-2020 Acura MDX, 2016 and 2018-2019 Pilot, 2017 and 2019 Ridgeline, and 2018-2019 Odyssey vehicles. Due to a manufacturing error, the connecting rod bearing in the engine may wear and seize, damaging the engine.
Issue: On certain vehicles equipped with a V6 engine, the connecting rod bearings could wear prematurely and become damaged. If this happens, the engine could make abnormal noises and a warning light may turn on. If you continue to drive the vehicle with these symptoms, the engine could fail. Safety Risk: An engine failure could cause a sudden loss of power and/or increase the risk of a vehicle fire. Both issues could increase the risk of a crash or injury. Corrective actions: Honda will notify owners by mail and advise you to take your vehicle to a dealership to inspect the engine. If damage is found, the dealer will replace the necessary parts.
Les gonfleurs d’airbag peuvent être défectueux et peuvent créer une pression interne excessive en cas d’activation. en conséquence, le caisson de gonflage métallique peut se rompre, ce qui fait que des fragments métalliques sont propulsés à travers l’airbag et dans l’habitacle, blessant les occupants du véhicule.
Issue: On certain vans converted for wheelchair access by BraunAbility, the fuel tank can be overfilled and fuel can enter the charcoal canister. If this happens, fuel can leak from the canister onto nearby components and the ground. Note: This problem only affects Honda Odyssey wheelchair vans with a power infloor side-entry ramp, which were altered between September 13, 2018 and December 3, 2020. Safety Risk: A fuel leak can create the risk of a fire. Corrective Actions: BraunAbility will notify owners by mail and instruct you to take your vehicle to a BraunAbility service center for an inspection. If there is evidence of a fuel leak, the dealer will install a new fuel tank assembly that has a different fill limit vent valve. The dealer will also replace the charcoal canister. A warning label will be applied on or near the fuel filler neck advising you not to overfill or "top off" the fuel tank.
Braun Corporation (Braun) is recalling certain 2018-2021 Braun-modified Honda Odyssey vehicles. The fuel tank assembly installed by Braun may be susceptible to the fuel tank overfilling into the charcoal canister. If the charcoal canister fills with a sufficient amount of fuel, fuel may leak out.
Die Aufnahme von Feuchtigkeit in den Treibstoff des Fahrerairbags kann zu einer verzögerten Auslösung oder zum Bersten des Gasgenerators führen.
De werking van de brandstofpomp kan mogelijk uitvallen.
A short circuit may occur in the wiring harness.Consequently, it can overheat, leading to increased risk of fire.
The airbag inflators may be defective and may create excessive internal pressure in the event of activation.As a result, the metal inflator casing may rupture, causing metal fragments to be propelled through the airbag and into the passenger compartment, injuring the vehicle occupants.
3열 좌측에 위치한 액세서리 파워 소켓 하네스가 고정되지 않아, 실내 트림 패널 안쪽의 모서리 부위와 차체 돌출부 사이로 배치되는 경우, 하네스가 눌러져 손상되어 피복이 노출되어 화재가 발생할 수 있는 가능성에 따른 리콜
De bedrading van de kabelboom naar de 12 volt accessoire-aansluitpunt van de derde zitrij kan beschadigen.
Issue: On certain vehicles, the wiring for the accessory power outlet located near the third-row seat could get pinched. This could result in a short circuit, and cause overheating of the wiring harness. Safety Risk: Wiring that overheats could create the risk of a fire. Corrective Actions: Honda will notify owners by mail and instruct you to take your vehicle to a dealer to inspect the wire harness for the third-row seat accessory power outlet. If it is damaged, it will be replaced. If no damage is found, the wire harness will be wrapped with protective tape and re-routed.
Honda (American Honda Motor Co.) is recalling certain 2018-2020 Odyssey vehicles. The wire harness for the third row seat accessory power outlet may get pinched between the unibody and rear trim panel, possibly damaging the wires and causing an electrical short.
Bei dem Inflator (Gasgenerator) des fahrerseitigen Airbags kann es aufgrund unzureichenden Feuchtigkeitsschutzes zu einer Aufnahme von Feuchtigkeit durch das Gasgeneratormittel kommen. Wenn das Gasgeneratormittel im Betriebsverlauf wiederholt Feuchtigkeit aufnimmt und wieder trocknet, besteht daher die Gefahr, dass sich der Airbag beim Auslösen nicht ordnungsgemäß entfaltet.
## Problem Bei bestimmten Fahrzeugen könnte die Einwirkung von Feuchtigkeit über einen längeren Zeitraum dazu führen, dass sich der Fahrerairbag bei einem Unfall nicht ordnungsgemäß aufbläst. In manchen Fällen könnte sich der Airbag nicht vollständig aufblasen, in anderen könnte er mit stärkerer Kraft als normal auslösen. Außerdem könnte der Gasgenerator platzen. Wenn der Airbag-Gasgenerator platzt, könnten kleine Metallteile in Richtung der Fahrzeuginsassen geschleudert werden oder den Airbag beschädigen und dessen ordnungsgemäße Funktion verhindern. Hinweis: Dieser Rückruf betrifft Airbag-Gasgeneratoren, die möglicherweise eingebaut wurden, als das Lenkrad-Airbag des Fahrzeugs ersetzt wurde. ## Sicherheitsrisiko Bei einem Unfall, der eine Auslösung des Airbags erfordert, könnte sich der Fahrerairbag möglicherweise nicht ordnungsgemäß aufblasen oder der Gasgenerator könnte platzen. Dadurch könnte ein Verletzungsrisiko entstehen. ## Korrekturmaßnahmen Das Unternehmen wird die Halter per Post benachrichtigen. Es kann zu einer erheblichen Verzögerung kommen, bevor Ersatzteile verfügbar sind. Das Unternehmen wird Ihnen einen zweiten Brief senden, sobald Ersatzteile verfügbar sind, und Sie anweisen, Ihr Fahrzeug zu einem Händler zu bringen, um den Gasgenerator des Fahrerairbags überprüfen zu lassen. Falls der Gasgenerator ausgetauscht werden muss, wird ein neu konstruiertes Teil eingebaut.
Issue: On certain vehicles, exposure to moisture over time could cause the driver-front airbag not to inflate properly in a crash. In some cases, this could cause an airbag not to fully inflate, while in others it could cause it to deploy with more force than normal. It could also cause the inflator to rupture. If the airbag inflator ruptures, small pieces of metal could be propelled toward vehicle occupants or cause damage to the airbag and prevent its proper function. Safety Risk: In a crash requiring an airbag deployment, the driver-front airbag may not inflate properly or the inflator could rupture. This could create a risk of injury. Corrective Actions: The company will notify owners by mail. There may be a significant delay before replacement parts are available. The company will send you a second letter once replacement parts are available and instruct you to take your vehicle to a dealer to inspect the driver-front airbag inflator. If the inflator requires replacement, a newly design part will be installed.
Quellen: NHTSA (USA, gemeinfrei), Transport Canada (Open Government Licence – Canada), DVSA (Vereinigtes Königreich, Open Government Licence v3.0), RappelConso und EU-Safety-Gate (Frankreich, Licence Ouverte 2.0), MLIT (Japan, Public Data License 1.0) und MOLIT (Südkorea, car.go.kr).