Problem: Dieser Rückruf betrifft bestimmte Blockheizsätze, die bei bestimmten Fahrzeugen installiert oder als Zubehör bei Toyota- oder Lexus-Händlern verkauft werden. Bei bestimmten Fahrzeugen hat das Motorblockheizkabel möglicherweise nicht ausreichend Hitzeschutz und kann durch hohe Temperaturen beschädigt werden. Wenn dies passiert, könnte das Kabel während des Einsteckens kurzschließen und dazu führen, dass die Kabel überhitzt oder schmelzen. Hinweis: Dieser Rückruf betrifft nur die folgenden Teilenummern des Blockheizer/-kabels: C014003034 PK5A408J09 PU14000904 C014003151 PK5A408J13 PU14000905 C014000885 PK5A489J11 PU14000907 C014000888 PK5A489J22 PU14000909 C014000907 PK5A410H00 PU14000911 C014100904 PU14000900 PU14000913 C014100907 PU14000901 PU14003571 C014100911 PU14000902 PK5A489J14 PK5A408J05 PU14000903 Sicherheitsrisiko: Überhitzung oder Schmelzen der Motorblockheizungsleitungen können ein Brandrisiko darstellen. Korrekturmaßnahmen: Toyota empfiehlt, die Motorblockheizung sofort nicht mehr zu verwenden. Toyota wird die Besitzer per Post benachrichtigen und Sie anweisen, Ihr Fahrzeug zu einem Händler zu bringen, um den Motorblockheizer zu deaktivieren. Für einige Fahrzeuge sind die Korrekturmaßnahmen für diesen Rückruf noch in Entwicklung. Bei anderen kann kein neuer Motorblockheizer installiert werden, und der Besitzer erhält eine Rückerstattung des Kaufpreises für den Motorblockheizer.
On certain vehicles, the electrical power cords of some dealer installed block heaters may have been improperly manufactured, causing the wires to contact each other, resulting in a short circuit. A short circuit could lead to a fire which would increase the risk of injury and/or damage to property. Correction: For vehicles where the subject block heater was approved for installation, the dealer will replace the block heater assembly with a new one of an improved design. For vehicles where the subject block heater was not approved for installation, dealers will remove the block heater assembly. In the interim, until the remedy can be performed, dealers will cut the plug end from the block heater cord to disable the block heater's operation.
Transport Canada20. Juli 20172017363Modelljahre 2016–2017Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
The fuel pressure sensor may not have correctly tightened during assembly. Over time this may affect the seal and allow fuel odour to escape. This could ignite in the presence of an ignition source.
DVSA · Vereinigtes Königreich26. Mai 2016R/2016/080Modelljahre 2005–2007Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
null The sealing performance of the gasket seated between the fuel pressure sensor and the engine fuel delivery pipe could degrade over time. If this occurs, fuel could leak which, in the presence of an ignition source, could lead to a vehicle fire.
The fuel pressure sensor gasket may degrade and allow fuel to leak into the engine compartment. In the presence of an ignition source the risk of fire is increased.
In the front wipers on subject left hand drive cars there is high friction at the tightening surface between the wiper arm nut and the wiper arm that could result in the nut being insufficiently tight. If the movement of the wiper arm is restricted by an external load such as a build up of heavy snow on the windshield the wiper motor torque may exceed the wiper arm slipping torque and one or both wipers could become inoperative. If this happens then visibility could be reduced which could increase the risk of a crash.
null The wiper arm nuts on the front wipers may be insufficiently tight. If the movement of wipers is restricted by an external load, such as a build-up of heavy snow on the windscreen, the wiper motor torque may exceed the wiper arm slipping torque, and one, or both, of the wipers could become inoperative. If this occurs, driver visibility could be reduced, which could lead to an accident.
Toyota is recalling certain model year 2006-2012 Lexus IS250 and IS350 vehicles manufactured August 23, 2005, through October 5, 2011; 2010-2012 Lexus IS250C and IS350C vehicles manufactured April 10, 2009, through October 6, 2011; and 2008-2011 Lexus IS-F vehicles manufactured December 14, 2007, through July 10, 2011. The nuts that fasten the wiper arms may be insufficiently torqued such that if the wiper arms are restricted by an external load, such as a buildup of heavy snow, one or both of the wipers may become inoperative.
Quellen: NHTSA (USA, gemeinfrei), Transport Canada (Open Government Licence – Canada), DVSA (Vereinigtes Königreich, Open Government Licence v3.0), RappelConso und EU-Safety-Gate (Frankreich, Licence Ouverte 2.0), MLIT (Japan, Public Data License 1.0) und MOLIT (Südkorea, car.go.kr).