Activation of a non-dessicated ammonium nitrate inflator with degraded propellant may result in an inflator rupture
Activation of a non-desiccated ammonium nitrate inflator with degraded propellant may result in an inflator rupture.
🔔 Create a free account to get email alerts about Mitsubishi Lancer Evolution (all generations)
Activation of a non-desiccated ammonium nitrate inflator with degraded propellant may result in an inflator rupture.
When the front passenger airbag is deployed, a part of the inflation mechanism can come loose due to the high pressure.
On certain vehicles operated in areas of heavy road salt usage, a mixture of snow, water and road-salt solution may infiltrate between the front impact sensor and the bracket that attaches it to the vehicle. Over time, repeated freezing/thawing cycles could cause a crack to develop in the sensor case allowing water intrusion and short circuit of the sensor. In the event of a crash, this could result in delayed deployment of the driver and passenger front airbags which would increase the risk of injury. Correction: Dealers will inspect the front impact sensor and replace it if it is found to be cracked. An updated designed bracket and cover will also be installed.
Mitsubishi Motors North America, Inc. (MMNA) is recalling certain model year 2006-2007 Lancer and Lancer Evolution vehicles manufactured June 29, 2005, to June 19, 2007, equipped with certain air bag inflators assembled as part of the passenger frontal air bag modules, and used as original equipment or replacement equipment. In the event of a crash necessitating air bag deployment, these inflators may rupture due to propellant degradation occurring after long-term exposure to absolute humidity and temperature cycling.
Mitsubishi Motors North America, Inc. (Mitsubishi) is recalling certain model year 2014-2015 Lancer Evolution vehicles manufactured January 31, 2014, to September 5, 2014, and 2014-2015 Lancer Ralliart vehicles manufactured February 3, 2014, to September 5, 2014. The affected turbocharged vehicles have a right parking brake cable that may contact the fuel tank, wearing away the tank's protective coating.
On certain vehicles, the right parking brake cable may have been incorrectly installed resulting in insufficient clearance with the fuel tank, causing abrasive contact between the two components. This contact could result in the coating on the fuel tank deteriorating and allowing rust to form, which could result in fuel leakage. Fuel leakage, in the presence of an ignition source, could result in a fire causing injury and/or damage to property. Correction: Dealers will replace the right parking brake cable and inspect the fuel tank. If the fuel tank’s exterior coating is damaged from contact with the parking brake cable, the fuel tank will also be replaced.
過給機付車両の駐車用ブレーキケーブルにおいて、組付作業が不適切なため、右側駐車用ブレーキケーブルと燃料タンクが干渉するものがある。そのため、そのまま使用を続けると燃料タンクのコーティングが剥がれ、本体が腐食し、最悪の場合、穴が開いて、燃料が漏れるおそれがある。
On certain vehicles, the drive belt material may cause abnormal pulley wear. If the vehicle is driven under this condition, the drive belt may become damaged from the worn pulley and detach, affecting electrical charging system and cooling system function and would illuminate the engine warning lamp(s) on the instrument panel. This could result in battery depletion and an overheated engine, resulting in a loss of motive power. Vehicles equipped with a hydraulic power steering system could also experience loss of power steering assist. These issues could increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will replace the drive belt, and the pulley will be replaced if it is found worn beyond a certain level.
Mitsubishi Motors North America, Inc. (Mitsubishi) is recalling certain model year 2014 Lancer Evolution vehicles manufactured January 31, 2014, through February 21, 2014, and 2014 Lancer Ralliart vehicles manufactured February 3, 2014, through February 14, 2014. The affected vehicles may have insufficient clearance between the power steering pressure tube and the crossmember brace.
On certain vehicles operated in areas of heavy road salt usage, the front impact sensors may corrode between the sensor bushing and sensor bracket. Over time, the corrosion may cause a crack to develop in the sensor case allowing water intrusion and short circuit of the sensor. This could result in delayed deployment of the driver and passenger front airbags during a vehicle crash, increasing the risk of personal injuries or death. Correction: Dealers will replace the front impact sensors.
Mitsubishi is recalling model year 2008-2009 lancer and lancer evolution vehicles originally sold in or currently registered in the states of connecticut, delaware, illinois, indiana, iowa, kentucky, maine, maryland, massachusetts, michigan, minnesota, missouri, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, virginia, west virginia, wisconsin and district of columbia. In areas where heavy road salt is used in the winter, a long term exposure to a mixture of melted snow with salt thrown up by the other vehicles on the road may cause a water-salt mixture to adhere to the front impact sensors.
エンジンの燃料装置において、燃料リターンパイプの固定構造が不適切なため、エンジン振動により当該パイプ固定部の応力が高くなるものがある。そのため、そのまま使用を続けるとパイプに亀裂が発生し、燃料が漏れるおそれがある。
Mitsubishi is recalling model year 2008-2009 lancer evolution, ralliart, and sportback ralliart vehicles equipped with turbocharged engines. The manner in which the fuel return pipe is attached to the engine, in combination with frequent vehicle operation at certain engine revolutions, may result in a resonance that, if continued over time, may cause a stress crack to develop at the fixed portion of the fuel pipe.
On certain passenger vehicles, the turbo charger coolant hose was incorrectly manufactured, and may allow coolant leakage.
On certain vehicles, water may drain from the windshield cowl area onto the front wiper link ball joint. Over time, this could result in corrosion and/or wear to the joint, which could result in the separation of the wiper link ball. If separation were to occur, the windshield wipers could become inoperative, which could limit the driver’s visibility under certain operating conditions which may increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will replace the wiper link rod with a countermeasure one, and will replace the wiper motor crank arm with a new one.
Mitsubishi Motors North America, Inc. (MMNA) is recalling certain 2007-2010 Outlander, 2008-2010 Lancer, 2009-2010 Lancer Evolution, and 2010 Lancer Sportback vehicles equipped with sunroofs. The sunroof glass may detach from the sunroof assembly, becoming a road hazard to other vehicles.
In vehicles equipped with a sunroof, the resin material used for the outer frame of the sunroof glass may be improperly selected, so the adhesive strength between the frame and the sunroof glass can decline due to changes in temperature and humidity. If use continues in this condition, the sunroof glass may peel away from the outer frame and, in the worst case, may come loose from the vehicle due to vibration or wind pressure while driving.
Mitsubishi Motors North America, Inc. (MMNA) is recalling certain 2015-2017 Outlander, 2015-2016 Lancer and Outlander Sport, and 2015 Lancer Evolution vehicles. These vehicles may have defective relays that can result in an engine stall, reduced engine power or the engine overheating.
エンジンコントロールユニットの電源制御等に使用されるリレーにおいて、リレー内部の溶接が不適切なため、使用過程で溶接部が異常発熱して溶接が外れ、導通不良となることがある。そのため、走行中にエンストして再始動不能となるおそれがある。また、アイドリングストップ付車両は、エンジン警告灯が点灯してエンジン出力が制限されるおそれがある。
Due to poor connectivity the indicators and/or vehicle lights may turn off or blink
Mitsubishi Motors North America, Inc. (MMNA) is recalling certain model year 2002-2007 Lancer, 2004 Lancer Wagon, 2003-2006 Lancer Evolution, 2003-2006 Outlander and 2007-2013 Outlander V-6 vehicles originally sold in, or ever registered in, Connecticut, Delaware, Illinois, Indiana, Iowa, Kentucky, Maine, Maryland, Massachusetts, Michigan, Minnesota, Missouri, New Hampshire, New Jersey, New York, Ohio, Pennsylvania, Rhode Island, Vermont, Virginia, West Virginia, Wisconsin and the District of Columbia. In the affected vehicles, the front lower control arms may detach due to the front cross member corroding from salt water exposure such as from road salt use.
Some turn/light switches have insufficient mounting rigidity, so switch operation wears the connector terminals. The wear debris then oxidizes and forms an insulating material. If use continues, this insulating material can become lodged between the terminals and cause a conduction failure. This may cause the headlamps, clearance lamps, front fog lamps, rear fog lamps, tail lamps, license plate lamps, and the interior lighting linked to the switch to go out or flicker, or cause the turn signals to go out.
The right hand side parking brake cable may interfere with the fuel tank. As a result there is possibility of peeling off the coating on the fuel tank. In the worst case the fuel tank can corrode and leak. Leaking fuel is a risk to other road users.
null High voltage variations within the system that controls all of the vehicle's electrical components can cause the vehicle's lights and/or the windscreen wipers to malfunction.
Bij het activeren van de voorste passagiersairbag kan, als gevolg van de hoge druk, een deel van het opblaasmechanisme losraken.
Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).