Lecture libre · compte gratuit pour contribuerSuccesseur d’Anticars (2000)

Mini Hatch III

2013–2024 · 11 défauts documentés · 3 marchés

Les bulletins techniques (TSB) sont des instructions de réparation que les constructeurs envoient à leurs concessionnaires sur des problèmes connus. Ce ne sont pas des rappels de sécurité, mais ils confirment souvent un défaut.

Année modèle
MarchéTousNA
BulletinModéréMoteurNA

Bulletin

Due to a manufacturing defect, the left charge air line can fail and cause an induction leak. In some casesthe Engine Malfunction warning may illuminate.

NHTSA · bulletin constructeur10242925Années modèle 2024Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinModéréMoteurNA

Bulletin

The left charge air line can fail and cause an induction leak. In some cases the Engine Malfunctionwarning may illuminate. Note: This Service Information is similar to M11 03 23; though this one pertains to vehicles already retailed.

NHTSA · bulletin constructeur10242926Années modèle 2024Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinModéréMoteurNA

Bulletin

B38 Engine: Mixture Faults Stored in DME and Cylinder Head Cover Leaking Engine Oil

NHTSA · bulletin constructeur10216761Années modèle 2016Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinModéréMoteurNA

Bulletin

During the vehicle's operational life, normal engine oil seepage or sweating, in addition to accumulated road dust, dirt and grime in the engine compartment can give an appearance that there is an active engine oil leak. This is further exaggerated by residual oil that remains on the engine assembly after maintenance services are performed, for example, oil filter changes, engine oil top-offs, etc. If this visual appearance of accumulated oil on the engine assembly is misinterpreted as an active engine oil leak, then unnecessary gasket repairs/replacements will result.

NHTSA · bulletin constructeur10201151Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinModéréMoteurNA

Bulletin

SERVICE ACTION - MOUNTING THE OIL FILLER CAP CORRECTLY: The oil filler cap may not be mounted correctly. The cap was not installed correctly during assembly.

NHTSA · bulletin constructeur10182925Années modèle 2021Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinModéréMoteurNA

Bulletin

SERVICE ACTION - MOUNTING THE OIL FILLER CAP CORRECTLY: The oil filler cap may not be mounted correctly. The cap was not installed correctly during assembly.

NHTSA · bulletin constructeur10182626Années modèle 2021Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinModéréMoteurNA

Bulletin

ENGINE STALLS AFTER STARTING OR WILL NOT START. The engine stalls right after starting (when stationary).

NHTSA · bulletin constructeur10153782Années modèle 2016Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinModéréMoteurNA

Bulletin

VANOS AND VANOS CENTRAL BOLT IDENTIFICATION. INFORMATION Replacing the VANOS gear central bolts or the VANOS gear will require a component inspection when the engine assembly has been previously replaced in one of the vehicles listed above. Ordering the parts via the model, production or VIN may provide the incorrect part numbers. The procedure below will help identify which VANOS parts are installed in the replacement engine. 11 36 7 608 788 Inlet adjustment unit Oulet adjustment unit Refer to the ETK and the repair instructions for one time use fastener and component information regarding additional screws, gaskets and seals.

NHTSA · bulletin constructeur10151386Années modèle 2016Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinModéréMoteurNA

Bulletin

SI M11 03 15 February 2016 Engine Technical Service This Service Information bulletin supersedes SI M11 03 15 dated April 2015. SUBJECT B38 Engine: Mixture Faults Stored in DME and Cylinder Head Cover Leaking Engine Oil.

NHTSA · bulletin constructeur10151154Années modèle 2015–2016Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinModéréMoteurNA

Bulletin

SI M11 03 15 February 2016 Engine Technical Service This Service Information bulletin supersedes SI M11 03 15 dated April 2015. SUBJECT B38 Engine: Mixture Faults Stored in DME and Cylinder Head Cover Leaking Engine Oil.

NHTSA · bulletin constructeur10151152Années modèle 2015–2016Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinModéréMoteurNA

Bulletin

SI M11 03 15 February 2016 Engine Technical Service This Service Information bulletin supersedes SI M11 03 15 dated April 2015. SUBJECT B38 Engine: Mixture Faults Stored in DME and Cylinder Head Cover Leaking Engine Oil.

NHTSA · bulletin constructeur10151153Années modèle 2015–2016Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinModéréMoteurNA

Bulletin

SI M11 03 15 February 2016 Engine Technical Service This Service Information bulletin supersedes SI M11 03 15 dated April 2015. SUBJECT B38 Engine: Mixture Faults Stored in DME and Cylinder Head Cover Leaking Engine Oil.

NHTSA · bulletin constructeur10151055Années modèle 2016Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinModéréMoteurNA

Bulletin

SI M11 03 15 February 2016 Engine Technical Service This Service Information bulletin supersedes SI M11 03 15 dated April 2015. SUBJECT B38 Engine: Mixture Faults Stored in DME and Cylinder Head Cover Leaking Engine Oil.

NHTSA · bulletin constructeur10151057Années modèle 2016–2017Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinModéréMoteurNA

Bulletin

SI M11 03 15 February 2016 Engine Technical Service This Service Information bulletin supersedes SI M11 03 15 dated April 2015. SUBJECT B38 Engine: Mixture Faults Stored in DME and Cylinder Head Cover Leaking Engine Oil.

NHTSA · bulletin constructeur10151056Années modèle 2016Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinModéréMoteurNA

Bulletin

"N14 and N18 Engine: High-pressure Pump Repair Instruction. INFORMATION The current version of ISTA/D Repair Instruction 13 51 017, ""Removing and installing or replacing high-pressure pump (N14, N18)"" has a procedure error. The current version of the Repair Instruction states to replace the highpressure supply hose on the N14 engine. The Repair Instruction also states not to replace the high-pressure supply hose on the N18 engine. The N18 portion of the Repair Instruction is incorrect. As an interim solution, follow the procedure outlined below until this portion of the Repair Instruction is corrected. https://www.minitis.net/tiscode/cgi-bin/bulletin.aspx?sie_path=/tsb/bulletins/htm_store/15601.2.M130113... 8/30/2013 Page 2 of 2 All vehicles equipped with the N18 engine and produced from 3/2012 and later. When the engine is fitted with a Bosch High-pressure Pump (1) the highpressure supply hose (2) MUST NOT be replaced when making repairs. The remaining portion of the Repair Instruction and tightning torques are correct. Refer to EPC for the applicable part numbers when making repairs. "

NHTSA · bulletin constructeur10150238Années modèle 2013Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinModéréMoteurNA

Bulletin

"N14 and N18 Engine: High-pressure Pump Repair Instruction. INFORMATION The current version of ISTA/D Repair Instruction 13 51 017, ""Removing and installing or replacing high-pressure pump (N14, N18)"" has a procedure error. The current version of the Repair Instruction states to replace the high-pressure supply hose on the N14 engine. The Repair Instruction also states not to replace the high-pressure supply hose on the N18 engine. The N18 portion of the Repair Instruction is incorrect. As an interim solution, follow the procedure outlined below until this portion of the Repair Instruction is corrected. https://www.minitis.net/tiscode/cgi-bin/bulletin.aspx?sie_path=/tsb/bulletins/htm_store/159...2/5/2014 Page 2 of 2 Bosch High-pressure Pump (1): All vehicles equipped with the N18 engine and produced from 3/2012 and later When the engine is fitted with a Bosch High-pressure Pump (1), the highpressure supply hose (2) MUST NOT be replaced when making repairs. The remaining portion of the Repair Instruction and tightening torques is correct. Refer to EPC for the applicable part numbers when making repairs."

NHTSA · bulletin constructeur10147960Années modèle 2013Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinModéréMoteurNA

Bulletin

ENGINE CRANKS, NO START AND/OR ENGINE COOLANT TEMPERATURE FAULTS: NOTE: The engine may also exhibit the same starting behavior as in Situation1.

NHTSA · bulletin constructeur10145369Années modèle 2014Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinModéréMoteurNA

Bulletin

JCW ENGINE TUNING KIT - ENGINE LOSS OF POWER IN STOP-AND-GO DRIVING: The engine may lose power if the vehicle is decelerated, in gear, to a near stop and then accelerated again.

NHTSA · bulletin constructeur10143573Années modèle 2016Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinModéréMoteurNA

Bulletin

Mini: The oil filter housing assembly is leaking engine oil and/or coolant. No model or years listed. *pe

NHTSA · bulletin constructeur10054636Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinMineurMoteurNA

Bulletin

Retour du turbocompresseur

NHTSA · bulletin constructeur11029017Années modèle 2022Traduit automatiquement · original : anglaisVoir le détail →
BulletinMineurMoteurNA

Bulletin

During a vehicle inspection and/or while addressing a customer's concern, the engine stabilizer bar/link appears to be worn.

NHTSA · bulletin constructeur10228445Années modèle 2021Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinMineurMoteurNA

Bulletin

Mini parts logistics TEC 26 turbo charger return

NHTSA · bulletin constructeur10216708Années modèle 2016Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinMineurMoteurNA

Bulletin

Service action: B46 AND B48 ENGINES - CHECK AND REPLACE CRANKSHAFT GUIDE BEARING

NHTSA · bulletin constructeur10216762Années modèle 2014Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinMineurMoteurNA

Bulletin

B38, B46 and B48 Engines: Engine Replacement Procedures

NHTSA · bulletin constructeur10216766Années modèle 2015Affiché en anglais d’origine · traduction en attenteVoir le détail →
BulletinMineurMoteurNA

Bulletin

Engine will not start (no crank). The engine will not crank or the engine loses power while driving, followed by a no crank situation.

NHTSA · bulletin constructeur10216767Années modèle 2016Affiché en anglais d’origine · traduction en attenteVoir le détail →
Plus anciens →

Sources : NHTSA (États-Unis, domaine public), Transports Canada (Licence du gouvernement ouvert – Canada), DVSA (Royaume-Uni, Open Government Licence v3.0), RappelConso et Safety Gate de l'UE (France, Licence Ouverte 2.0), MLIT (Japon, licence de données publiques 1.0) et MOLIT (Corée du Sud, car.go.kr).