かじ取ギヤボックス
かじ取り装置において、ギアボックスにある油圧パイプの取り付けボルトの締め付けトル クが不適切なため、走行時の振動等で当該ボルトがゆるむものがあり、そのままの状態で 使用を続けると、パワーステアリングの作動油が漏れてかじ取りハンドルの操舵力が増大 し、最悪の場合、漏れた作動油が着火して火災に至るおそれがある。
🔔 Crea un account gratuito per ricevere avvisi via e-mail su BMW Serie 7 E38
かじ取り装置において、ギアボックスにある油圧パイプの取り付けボルトの締め付けトル クが不適切なため、走行時の振動等で当該ボルトがゆるむものがあり、そのままの状態で 使用を続けると、パワーステアリングの作動油が漏れてかじ取りハンドルの操舵力が増大 し、最悪の場合、漏れた作動油が着火して火災に至るおそれがある。
Vehicle description: Passenger vehicles. The differential pinion shaft within the differential case assembly was produced without the appropriate surface hardening. This can result in the shaft experiencing premature wear.
Fuel seepage can occur between a hose and the metal fuel line on either end of the hose resulting in fuel odor.
緩衝装置において、前輪側のコイルスプリングの形状が不適切なため、そのままの状態で 主に積雪地帯での使用をすると、当該スプリングと下部のパッドとの間に蓄積された異物 により生じた傷から腐食することがあり、最悪の場合、折損し、走行安定性を損なうおそ れがある。
On certain 323I, 328I, 528I, 528IT, 540I, 540IT, 740I, 740IL, 750IL and M5 vehicles, the brake light switch capacitor housing may be cracked and in high humidity conditions the capacitor and switch housing could become overheated and deformed. As a result, a short circuit or an open circuit could occur in the switch. This could cause the switch to remain either in the "brake lamps off" position or the "brake lamps on" position. If the switch remains in the "off" position, the brake lamps will be rendered inoperative. Conversely, if the switch remains in the "on" position, the brake lamps will be continuously illuminated when the ignition switch is in the "on" position. Correction: Brake lamp switch will be replaced with an improved switch.
制動灯の制御回路において、制動灯用スイッチに一部製造不良のものがあり、そのままの 状態で使用を続けると電子回路が故障し、最悪の場合、ブレーキペダルの操作とは関係な く、制動灯が点滅もしくは点灯し続けてしまうおそれがある。
Vehicle description: Passenger vehicles. The brake lamps in these vehicles are controlled by a switch activated by the movement of the brake pedal. This switch could fail internally, causing it to remain either in the "brake lamps off" position or in the "brake lamps on" position.
There is a possibility that the brake light switch circuits may become defective and cause the brake light circuit to fail stay on continuously or flicker. In extreme cases the brake switch could overheat.
Vehicle description: Passenger vehicles. The thickness of the main positive electrical cable (generator to starter) insulation is less than specified, making it susceptible to being abraded or cut by the clip that secures the cable to the generator.
Vehicle description: Passenger vehicles equipped with a 5hp24 automatic transmission. Premature wear of the ring gear can occur, leading to the loss of 1st, 2nd, 3rd, and reverse gears.
Su alcuni veicoli, il guasto di un componente del sistema di raffreddamento come termostato, pompa dell'acqua o cinghia della ventola può causare un aumento significativo della temperatura del liquido refrigerante e della pressione del sistema. L'aumento della pressione del sistema potrebbe causare la formazione di una crepa o la separazione di una giuntura nell'estremità del nucleo del riscaldamento, che causerebbe l'espulsione di refrigerante caldo dal nucleo del riscaldamento. Questo fluido caldo potrebbe entrare in contatto con gli occupanti dell'auto, causando possibili lesioni personali e/o appannamento delle superfici interne dei finestrini. Correzione: Il tappo del radiatore sarà sostituito con un nuovo tappo di design per evitare l'accumulo di eccessiva pressione nel sistema di raffreddamento.
Vehicle description: Passenger vehicles. A malfunction or failure of a coolant system component, such as a thermostat, water pump, or fan belt, can result in significantly increased coolant temperature and system pressure. If the indications of a critical overheating condition is not noticed by the driver, it is possible that damage to, or failure of, a coolant system component could occur.
On certain 540I, 540IA, 740IA, 740ILA and 750ILA, the differential pinion shaft in the differential case assembly was not properly surface hardened. This condition will result in premature wear which can lead to noisy operation and ultimately to a lack of drive capability through the rear axle. Correction: Entire differential assembly will be replace on affected vehicles.
On certain 740I, 740IL and 750IL vehicles, road grit and gravel associated with winter road conditions can penetrate the rubber of the lower front spring mounts and accumulate in the mounts causing notches or pits to develop. Eventually this could cause the coild spring to crack and break at a bottom coild. This could adversely affect the vehicle's dynamic stability and reduce driver control. Correction: Both front springs and lower spring mounts will be replace on affected vehicles.
On certain 318IC, 318IS, 318TI, 325I, 325IC, 325IS, 525I, 525IT, 530I, 530IT, 540I, 740I, 740IL, 840CI and M3, the cruise control and throttle cable are attached to the same throttle valve actuating lever at the throttle housing. It is possible that the plastic bushing on either cable could break causing the outer cable housing to separate from the bushing. Throttle pedal application without cruise control engagement could cause the outer tube to catch on the edge of the broken bushing resulting in the throttle valve remaining partially open. If this were to occur, the car might not decelerate as expected and a crash could occut. Correction: A spring clip will be installed on the outer tube of each cable to prevent dislodgment from the bushing.
The cruise control and throttle cables are attached to the same throttle valve actuating lever at the throttle housing. It is possible that the plastic bushing on either cable could break due to environmental influences coupled with vibration. If the bushing breaks, the outer cable housing can separate from the bushing. In this case, during application of the throttle pedal without cruise control being engaged, the outer tube could catch on the edge of the broken bushing.
On certain 325I, 325IC, 325IS, 525I, 525IT, 530I, 530IT, 535I, 540I, 735I, 735IL, 740I, 740IL and 750I, the brake light switch may fail due to a reduction of contact force on the "snap contact" system which the switch incorporates. This could cause heat induced distortion of the plastic internal switch parts in the area of the electrical contacts. This could cause the switch to remain either in the ON or the OFF position resulting in the brake lights being continuously illuminated or inoperative regardless of brake pedal operation. Correction: Switch will be replaced with on that utilizes a different contact system.
The brake light switch can fail allowing the switch to remain in the "brake lights off" position or in the "brake lights on" position.
エンジンル-ム内の金属製燃料パイプの端部形状が不適切なため、車両の振動等により 当該パイプに接続するゴム製燃料ホースが損傷し、そのままの状態で使用を続けると燃料 が漏れるおそれがある。
後輪右側の緩衝装置を構成するホイールキャリア(ホイール取付用部品)に鋳造不良の ものがあり、そのままの状態で使用を続けると、鋳造不良の部分が破損し、走行安定性を 損なうおそれがある。
On certain 740I, 740IL and 750IL vehicles, the lower suspension arm mounting eye on the right side rear axle hub carrier could have a casting flaw. It is possible that the carrier eye could crack and break during driving. If this were to occur, the right rear wheel would no longer function as designed and the driver's ability to maintain control of the vehicle would be considerably reduced. Correction: Right side rear axle hub carrier will be inspected for the presence of the casting flaw and replaced if the flaw is present.
The lower suspension arm mounting eye on the right side rear axle hub carrier was produced with a casting flaw.
US Specs is recalling one 2002 Porsche Carrera, one 1997 BMW 750IL, and two 1986 BMW 635 CSI vehicles for failing to conform to Federal Motor Vehicle Safety Standard No. 111, "Rearview Mirrors." While performing conformity-related modifications for the US market, labels with an incorrect size font were applied to the passenger side mirror.
Vehicle description: Passenger vehicles. Road grit and gravel associated with winter road conditions can penetrate the rubber of the lower front spring mounts and accumulate in the mounts causing notches or pits to develop. These notches can develop cracks resulting in breakage of a bottom coil of the spring.
Fonti: NHTSA (Stati Uniti, pubblico dominio), Transport Canada (Open Government Licence – Canada), DVSA (Regno Unito, Open Government Licence v3.0), RappelConso e Safety Gate UE (Francia, Licence Ouverte 2.0), MLIT (Giappone, Public Data License 1.0) e MOLIT (Corea del Sud, car.go.kr).