Su alcuni veicoli, variazioni nel processo di produzione o l'esposizione a temperature ambientali elevate possono causare la rottura della valvola di non ritorno (ICV) dell'ingresso del serbatoio del carburante.
NHTSA · Stati Uniti8 ago 200707V349000Anni modello 2001–2004Tradotto automaticamente · originale: ingleseVedi dettagli →
On certain minivan, passenger and sport utility vehicles, some of these vehicles have a driver's side airbag that may not deploy as designed. In addition, the airbag inflator could rupture.
NHTSA · Stati Uniti14 feb 200303V051000Anni modello 2003Tradotto automaticamente · originale: ingleseVedi dettagli →
Alcuni autovetture, minivan e sport utility vehicle hanno un gonfiatore dell'airbag sul lato guidatore che potrebbe rompersi in corrispondenza di una saldatura durante l'attivazione.
NHTSA · Stati Uniti9 ago 200202V222000Anni modello 2002–2003Tradotto automaticamente · originale: ingleseVedi dettagli →
Vehicle description: Passenger, sport utility vehicles and minivans. The passenger air bag inflator modules were built without the correct amount of generant, which produces the gas that fills the air bag. Some were built with a double load of generant and some were built without generant.
NHTSA · Stati Uniti1 feb 200101V026000Anni modello 2001Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Vehicle description: Mini vans with extended wheelbase. Some of these vehicles have inoperative fuel tank rollover valves and fuel leakage would exceed the permissible amount in a rollover test. This does not comply with the requirements of fmvss no. 301, "fuel system integrity."
NHTSA · Stati Uniti29 set 199999V268000Anni modello 2000Mostrato in inglese originale · traduzione in attesaVedi dettagli →
On certain vehicles, ice may accumulate on the rear brake pipes located approximately under the driver's side floor mat. If a large amount of ice accumulates on the brake pipes, the weight of the buildup may pull the pipes away from the underbody of the vehicle which could cause the pipes to drag on the ground and be damaged. Damaged brake pipes could result in loss of brake fluid and reduced brake effectiveness. Correction: A brake pipe retainer clip will be installed to the underbody.
Transport Canada14 apr 19991999059Anni modello 1997Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Su alcuni veicoli Aztek (AWD), Montana (AWD), Relay (AWD), RendezVous (AWD), RendezVous (FWD), Silhouette (AWD), Terraza (AWD), Uplander (AWD) e Venture (AWD) equipaggiati con sospensioni posteriori indipendenti, quando utilizzati a temperature estreme fredde e su strade accidentate, acqua e sale possono intrudere oltre la guarnizione del giunto sferico. La combinazione di queste condizioni può quindi portare a un'usura prematura del giunto sferico. Se l'usura del giunto sferico progredisce fino al punto di separazione dal braccio inferiore, potrebbe verificarsi una perdita del controllo del veicolo. Correzione: I concessionari sostituiranno entrambi i giunti sferici con nuovi giunti sferici che hanno un stivale e un perno a sfera rivisitati per migliorare la guarnizione dell'albero del perno a sfera.
Transport Canada15 ago 20062006199Anni modello 2002–2004Tradotto automaticamente · originale: ingleseVedi dettagli →
On certain minivans equipped with second-row bucket seats or captain's chairs and a power sliding door on the passenger side of the vehicle, a passenger using the interior handle to open the power sliding door could be injured.
NHTSA · Stati Uniti22 dic 200404V597000Anni modello 1997–2005Mostrato in inglese originale · traduzione in attesaVedi dettagli →
On certain passenger, sport utility vehicles and mini vans, some of these vehicles have a passenger air bag that was manufactured without a check valve pin. An air bag without the check valve pin could produce increased pressure at the onset of the air bag deployment and reduced pressure afterward.
NHTSA · Stati Uniti9 dic 200202V329000Anni modello 2001Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Certain passenger vehicles and mini vans have lower pinion bearings in the power rack and pinion assembly in which the retainer tabs were not crimped properly. These and some other retainers used in vehicles assembled between january 1, 1996 and october 31, 1997, could fail and permit the ball bearings to escape.
NHTSA · Stati Uniti4 nov 200202V286000Anni modello 1997–1998Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Vehicle description: Certain mini vans built with second row 50/50 split bench seats or captain's chairs, fail to comply with the requirements of fmvss no. 225, "child restraint anchorage systems." the seat latch anchor wire diameter is greater than 6.1 mm.
NHTSA · Stati Uniti13 dic 200101V383000Anni modello 2001Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Vehicle description: 1997-2001 chevrolet venture, pontiac montana/transport, and oldsmobile silhouette mini vans equipped with passenger side power sliding doors that were serviced in campaign 01013 (01v-067) from april to august 2001. Also 2001 chevrolet venture, pontiac montana, and oldsmobile silhouette mini vans equipped with passenger side power sliding doors assembled in january through april 2001. These vehicles have inadequate front welds. If a front weld fails, the actuator can jam in the unlatched position and, when the sliding door closes, it will not be latched.
NHTSA · Stati Uniti21 ago 200101V264000Anni modello 1997–2001Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Vehicle description: Minivans equipped with passenger side power sliding doors. The door closes but may not be latched. If this happens, the power sliding door can open while the vehicle is in motion, particularly when the vehicle ascends a hill, makes a turn, or travels over a rough road surface.
NHTSA · Stati Uniti8 mar 200101V067000Anni modello 1997–2001Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Vehicle description: Passenger vehicles, light duty trucks, sport utility vehicles, and mini vans equipped with trw seat belt buckle assemblies. The buckle base of these seat belt assemblies were not properly heat treated and therefore do not pass the load bearing requirement of federal motor vehicle safety standard no. 209, "seat belt assemblies."
NHTSA · Stati Uniti7 ago 200000V228003Anni modello 2000–2001Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Su alcuni veicoli utilizzati in zone con un elevato impiego di sale, il cavo di sollevamento della ruota di scorta può corrodersi e, alla fine, rompersi. Ciò consentirebbe alla ruota di scorta di cadere dal veicolo, con possibile pericolo per la circolazione degli altri veicoli.
Correzione: Verrà inviata una lettera ai proprietari dei veicoli interessati con le istruzioni di manutenzione e ispezione per i gruppi cavo di sollevamento della ruota di scorta. Inoltre, la lettera informerà il proprietario che, se il cavo si rompe durante tale ispezione, il concessionario provvederà alla riparazione del gruppo. Questa politica sarà in vigore fino al 31 dicembre 2002.
Transport Canada21 mar 20002000080Anni modello 1995–1999Tradotto automaticamente · originale: ingleseVedi dettagli →
Vehicle description: Passenger mini vans. The left and/or right front lower insulator to cradle center metal sleeve is collapsed, which can result in loss of clamp load in the joint. If the clamp load is reduced or lost, the bolt can be lost or broken and the joint can separate.
NHTSA · Stati Uniti12 apr 199999V071000Anni modello 1999Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Note: Vehicles equipped with bucket seats or a split bench seat in the middle or back row. The seat latch release mechanisms on bucket seats and on the 40% portion of the split bench seat in the second and third rows do not have protective covers. When activating the release mechanism to roll a bucket seat forward, an operator's fingers may be severely injured or severed if they are not kept clear of the mechanism. Correction: Dealers will install a protective cover over the release mechanism.
Transport Canada22 lug 19981998152Anni modello 1997–1998Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Vehicle description: Passenger mini vans equipped with bucket seats or a split bench seat in the second (middle) or third (back) row. The seat latch mechanisms on bucket seats and on the 40% portion of the split bench seat in the second and third rows do not have protective covers.
NHTSA · Stati Uniti26 giu 199898V145000Anni modello 1997–1998Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Vehicle description: Mini vans. These vehicles may have (1) a broken shift cable fitting or (2) loose shift linkage. Consequently, moving the shift lever to a 'park' position may not shift the transmission to 'park'.
NHTSA · Stati Uniti11 giu 199898V131000Anni modello 1998Mostrato in inglese originale · traduzione in attesaVedi dettagli →
These vehicles may not comply with c.M.V.S.S. 102 - transmission shift control sequence. Vehicles may have a broken shift cable fitting or loose shift linkage swivel tubes. With either condition, moving the shift lever to "park" may not shift the transmission to "park". This could result in vehicle roll away and a possible crash without prior warning. Correction: Dealers will inspect and, if necessary, replace the automatic transaxle range selector cable.
Transport Canada9 giu 19981998119Anni modello 1998Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Note: Vehicles equipped with traction control. When the windshield wipers are turned on, the windshield wiper linkage arm may contact a brake line connected to the traction control system (tcs) modulator. This could result in brake fluid leakage, reduced braking effectiveness and increased stopping distances. Correction: A brake line clip will be installed which will assure proper clearance. Additionally, vehicles will be inspected for brake line damage caused by this condition and damaged brake lines will be replaced.
Transport Canada8 apr 19981998066Anni modello 1997–1998Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Vehicle description: Passenger mini vans equipped with traction control systems. The windshield wiper linkage arm can contact a brake line which is connected to the traction control system modulator valve. This contact can chafe the brake line resulting in a brake fluid leak.
NHTSA · Stati Uniti7 apr 199898V072000Anni modello 1997–1998Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Note: Vehicles equipped with a 3.4 litre engine. Water may be drawn into the evaporative emission canister when the vehicle is driven in slushy snow conditions. The water is then delivered to the engine which can result in setting an mil (malfunction indicator lamp), misfire, rough idle, lack of power and eventually engine stall if driveability and mil are ignored. Correction: Evaporative emission canister vent solenoid valve assembly will be relocated to a protected area. Rear heater, ventilation and air conditioning equipped vehicles will have a shield installed under the assembly.
Transport Canada4 feb 19981998021Anni modello 1998Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Certain minivans fail to conform to the requirements of federal motor vehicle safety standard no. 213, "child restraint systems." these vehicles do not have text and formatting on the warning label attached to the available second-row integral child restraint as specified by amendments to the standard.
NHTSA · Stati Uniti8 apr 200404V177000Anni modello 2004Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Fonti: NHTSA (Stati Uniti, pubblico dominio), Transport Canada (Open Government Licence – Canada), DVSA (Regno Unito, Open Government Licence v3.0), RappelConso e Safety Gate UE (Francia, Licence Ouverte 2.0), MLIT (Giappone, Public Data License 1.0) e MOLIT (Corea del Sud, car.go.kr).