Bollettino
Ritorno del turbocompressore
🔔 Crea un account gratuito per ricevere avvisi via e-mail su Mini Hatch (tutte le generazioni)
I bollettini tecnici (TSB) sono istruzioni di riparazione che i costruttori inviano ai concessionari su problemi noti. Non sono richiami di sicurezza, ma spesso confermano un difetto.
Ritorno del turbocompressore
During a vehicle inspection and/or while addressing a customer's concern, the engine stabilizer bar/link appears to be worn.
Mini parts logistics TEC 26 turbo charger return
N18 engine high pressure fuel pump (hdp): limited warranty extension to 10 years/120,000 miles
Service action: B46 AND B48 ENGINES - CHECK AND REPLACE CRANKSHAFT GUIDE BEARING
B38, B46 and B48 Engines: Engine Replacement Procedures
Engine will not start (no crank). The engine will not crank or the engine loses power while driving, followed by a no crank situation.
Different air temperatures are felt from left to right out of the front fresh air grilles (air vent). The following fault code is saved in the IHKA (integrated automatic heating/air conditioning system) control unit: 801189 - Engine mixed air right: Initialization fault.
MINI Water Pump Class Action Settlement
TURBOCHARGER RETURN: MINI AG has requested the inspection and return of the following part number: 11 65 8 626 637
BUZZING NOISE IS HEARD WHEN AIR CONDITIONING IS DEACTIVATED: A buzzing noise is heard when the air conditioning (A/C) is deactivated while the vehicle is in park or neutral. Prior to turning off the A/C, the system was functional and cooling properly. A/C compressor, or The power supply to the A/C compressor is too low.
BUZZING NOISE IS HEARD WHEN AIR CONDITIONING IS DEACTIVATED: A buzzing noise is heard when the air conditioning (A/C) is deactivated while the vehicle is in park or neutral. Prior to turning off the A/C, the system was functional and cooling properly. A/C compressor, or The power supply to the A/C compressor is too low.
ENGINE REPLACEMENT AND REPAIRS - OIL PUMP AND SUPPLY CIRCUIT PRIMING PROCEDURE: New and remanufactured replacement engine assemblies are NOT pre-filled with engine oil. After replacing an engine with a new or remanufactured engine assembly, the engine oil level must be verified as outlined in the procedure below first, before starting the engine for the first time.
MINI TURBOCORD PORTABLE EV 120V/240V CHARGER: The MINI-approved accessory TurboCord will not charge the vehicle.
FUEL PUMP CONTROL UNIT (EKP) DIAGNOSIS AND REPLACEMENT: The Fuel Pump Control Unit (EKP) replacement rate and replaced parts have been extensively analyzed by MINI and its suppliers. The EKP has not been found defective during the component testing, therefore, the EKP is not the root cause of any known complaints or systematic defects. Always perform the test plans for the applicable faults stored in the car.
FUEL PUMP CONTROL UNIT (EKP) DIAGNOSIS AND REPLACEMENT: The EKP has not been found defective during the component testing therefore the EKP is not the root cause of any known complaints or systematic defects. Always perform the test plans for the applicable faults stored in the car. Do not replace the EKP unless the test plan specifically states to replace the EKP. If you discover a situation where the EKP is defective please create and submit an Info Only TSARA case with "EKP Failure" in the subject line. Please describe the type of failure how you determined the failure or the troubleshooting steps you performed to reach the conclusion.
ENGINE REPLACEMENT AND REPAIRS - OIL PUMP AND SUPPLY CIRCUIT PRIMING PROCEDURE: This Service Information Bulletin replaces SI M11 04 15 dated November 2016. New and remanufactured replacement engine assemblies are NOT pre-filled with engine oil. After replacing an engine with a new or remanufactured engine assembly the engine oil level must be verified as outlined in the procedure below first before starting the engine for the first time.
The high-pressure fuel pumps (HDP: left and right) component-specific limited warranty extension to 10
N16 ENGINE IGNITION COILS: LIMITED WARRANTY EXTENSION TO 10 YEARS/120000 MILES This Service Information bulletin supersedes SI M01 08 17 dated February 2018.
ENGINE OIL IS BELOW THE MINIMUM LEVEL. Prior to a "Due" engine oil service, a customer may contact your dealer or arrive at your workshop stating the vehicle's engine oil is below the minimum level.
In the seven affected vehicles, the DME control unit (Digital Motor Electronics) may have a manufacturing defect which could cause the engine not to start.
"N18 Engine High-Pressure Fuel Pump (HDP): Limited Warranty Extension to 10 Years/120,000 Miles. For the above-referenced vehicles, MINI USA, a division of BMW of North America, LLC (""MINI USA"") is extending the limited warranty for the engine's High-Pressure Fuel Pump (HDP) to: 10 years/120,000 miles as determined by the vehicle's original in-service date Item #1: This ""componentspecific"" limited warranty extension applies to defects in materials and workmanship and is subject to the applicable vehicle and coverage eligibility requirements, exclusions and limitations that apply to the New MINI Passenger Car Limited Warranty. Important Note: This limited warranty extension only applies to the listed vehicles produced up to and including 2/29/2012 (Leap year). Vehicles produced on or after 3/1/2012 are fitted with different equipment. This bulletin is notice of a ""limited warranty extension."" This is NOT a notice of a Recall or Service Action. There is no immediate repair required unless the MINI vehicle is currently experiencing this problem. Even though this is NOT a Recall, MINI USA will be sending VIN-specific customer notification letters in a phased release."
Service Action: N14 Engine Retrofit Turbocharger Engine Oil Supply Line Heat Shield. After switching off the engine, the heat radiating from the turbocharger may cause the engine oil to solidify in the oil supply line to the turbocharger. This can lead to a restriction in the oil supply line, resulting in damage to the turbocharger bearings. CAUSE Close proximity of the turbocharger engine oil supply line and the turbocharger
Service Action: N14 Engine Check Timing Chain Tensioner and Timing Chain. The timing chain tensioner applies pre-tension to the timing chain guide rail mechanism. In some cases, the tensioner spring force may be too low. Depending on the severity of the wear, it may lead to a rattling noise when starting the engine cold or when the engine is idling. CAUSE The timing chain tensioner internal tolerances are not consistent.
"N18 FUEL TANK PURGE/BREATHER/VENT VALVE: LIMITED WARRANTY EXTENSION TO 10 YEARS/120,000 MILES. INFORMATION For the above-referenced vehicles, MINI USA, a division of BMW of North America, LLC (""MINI USA"") is extending the limited warranty for the fuel tank's purge/breather/vent valve to: ? 10 years/120,000 miles as determined by the vehicle's original in-service date This bulletin is notice of a ""component-specific limited warranty extension."" This is NOT a notice of a Recall or Service Action. There is no immediate repair required unless the MINI vehicle is currently experiencing this problem Even though this is NOT a Recall, MINI USA will be sending VIN-specific customer notification letters in a phased release Customer Notification Letter - VIN and Component-specific Warranty Extension Even though this is NOT a Recall, MINI USA will be sending VIN-specific customer notification letters in a phased release. Note: A small number of model year 2012 and 2014 vehicle were included in the mailing, these VINs will also be ""flagged"" as ""Eligible Vehicles."" The tank purge/breather/vent valve componentspecific limited warranty extension will be honored, this only applies to these vehicles which have the corresponding DCSnet ""Vehicle Comment."""
Fonti: NHTSA (Stati Uniti, pubblico dominio), Transport Canada (Open Government Licence – Canada), DVSA (Regno Unito, Open Government Licence v3.0), RappelConso e Safety Gate UE (Francia, Licence Ouverte 2.0), MLIT (Giappone, Public Data License 1.0) e MOLIT (Corea del Sud, car.go.kr).