影響を受けた車両のセルモジュールは仕様通りに生産されておらず、それは...
影響を受けた車両のセルモジュールは仕様通りに製造されておらず、モジュールフレームの破損を引き起こす可能性があります。これにより高電圧システムの停止や火災が発生する可能性があります。
🔔 無料アカウントを作成して BMW iX のメール通知を受け取る
影響を受けた車両のセルモジュールは仕様通りに製造されておらず、モジュールフレームの破損を引き起こす可能性があります。これにより高電圧システムの停止や火災が発生する可能性があります。
고전압배터리 셀 모듈의 제조과정 오류로 인해 고전압 배터리 셀 모듈 프레임의 압력판이 허용된 압력을 초과하여 압축되어 측면판과 용접되었을 수 있으며, 이런 경우 시간이 지남에 따라 고전압 배터리 셀 모듈 프레임의 압력판과 측면판 사이의 용접 이음새가 파손되어 고전압 배터리 셀간 정렬이 어긋나 사전 경고 없이 고전압이 차단될 수 있으며, 화재가 발생할 수 있는 가능성이 확인됨에 따른 리콜 <대상차량별 생산일자> BMW iX xDrive50: 2021.08.23~2023.05.08 BMW 750e xDrive: 2023.05.15~2023.08.31
The cell modules in the vehicles concerned were not produced in accordance with the specifications, which may cause the module frame to fail. This may lead to a shutdown of the high-voltage system and fire.
高電圧バッテリーのセルモジュールにおいて、製造が不適切なため、セルをプレッシャープレートで加圧する際に、許容範囲以上で加圧されて過度な残留応力が生じているものがある。そのため、経時的な応力によりセルの関連部品が破損して、最悪の場合、告知機能なしにハイボルテージバッテリーが停止するおそれや、火災に至るおそれがある。
リコール:駆動モーター内のブラシモジュールの製造または組立工程で混入した異物により、ブラシモジュールとハウジングの間に導通接続が生じる可能性があります。この場合、感電や火災の危険はありませんが、高電圧とアース間の絶縁抵抗異常検知が過度に作動し、警告灯が点灯してセンターモニターにチェックコントロールメッセージが表示されます。ごくまれに、走行中に車両が徐々に停止する可能性があるため、リコールを実施します。 <対象車両の生産日> BMW i4 eDrive40: 2021.11.23~2023.12.13 BMW i4 eDrive40: 2022.06.07 BMW i4 M50: 2021.11.22~2023.12.08 BMW i5 eDrive40: 2022.07.29~2023.12.13 BMW i5 M60 xDrive: 2023.06.27~2023.12.13 BMW i5 M60 xDrive: 2023.09.13 BMW i7 eDrive50: 2023.06.30~2023.12.11 BMW i7 M70 xDrive: 2023.07.28~2023.11.07 BMW i7 xDrive60: 2022.02.15~2023.12.11 BMW i7 xDrive60: 2023.11.29 BMW iX M60: 2022.03.29~2023.12.08 BMW iX xDrive40: 2021.08.02~2023.07.03 BMW iX xDrive40: 2023.02.10 BMW iX xDrive50: 2020.09.01~2023.12.12 BMW iX xDrive50: 2023.07.19 BMW iX1 xDrive30: 2022.11.08~2023.12.14
BMW of North America, LLC (BMW) is recalling certain 2022-2025 i4, 2022-2024 IX, 2023-2024 I7, and 2024 I5 vehicles. The electric drive motor software may shut down the high-voltage system, causing a loss of drive power.
BMW of North America, LLC (BMW) is recalling certain 2022-2025 IX, 2023-2024 I7, and 2022-2023 i4 vehicles. The high-voltage battery cell modules may not have been assembled properly, resulting in stress on the module frame and possible module failure.
The airbag control module (ACSM) may be defective, potentially preventing the airbags from deploying in the event of an accident. This increases the risk of injury to vehicle occupants. Additionally, the airbag warning light or Check Control message may not activate, leaving the driver unaware of the fault.
高電圧バッテリーの製造上の欠陥は、バッテリーの故障を引き起こし、火災のリスクを高める可能性があります。
The driver airbag may be incorrectly folded. In the event of an accident it may consequently not be able to unfold correctly, increasing the risk of injury to the driver.
**問題:** 一部の車両では、衝突時に運転席側フロントエアバッグが正しく展開しない場合があります。 **安全上のリスク:** エアバッグが正しく展開しない場合、衝突時の傷害リスクが高まるおそれがあります。 **是正措置:** BMWは所有者に郵送で通知し、運転席側フロントエアバッグを交換するためにディーラーへ車両を持ち込むよう案内します。
BMW of North America, LLC (BMW) is recalling certain 2022-2023 iX xDrive40, iX xDrive50, iX M60, i4 eDrive35, i4 eDrive40, i4 M50, and 2023 i7 xDrive60 vehicles. The high voltage battery electronic control unit (ECU) software may cause an interruption of electrical power.
高電圧バッテリーのセルモジュールの製造不良により、高電圧バッテリーが誤作動するおそれがある。そのため、稀にではあるが高電圧バッテリーが放電し、最悪の場合、火災につながる可能性がある。
배터리 셀 생산 공정 중에 손상된 음극판 조각이 배터리 셀 내부에 유입되어 고전압 배터리에 단락이 발생할 수 있고, 이로 인해 셀 모듈이 방전될 수 있으며 화재가 발생할 수 있는 가능성에 따른 리콜 <*대상차량별 생산일자> BMW i4 eDrive40: 2021.11.30~2022.07.15 BMW i4 M50: 2021.11.22~2022.06.08 BMW i7 xDrive60: 2022.08.04~2022.08.04 BMW iX M60: 2022.05.04~2022.05.09 BMW iX xDrive50: 2022.04.28~2022.06.01 ?
エアバッグ回路の故障時にソフトウェアの不具合が原因で、エアバッグ警告灯や警告メッセージが運転者に表示されない場合があります。
製造上の欠陥により高電圧バッテリーが故障し、火災のリスクが高まる可能性があります。
배터리 셀 생산 공정 중에 손상된 음극판 조각이 배터리 셀 내부에 유입되어 고전압 배터리에 단락이 발생할 수 있으며, 이런 경우 셀 모듈이 방전될 수 있고 화재가 발생할 수 있는 가능성에 따른 리콜 <*대상차량별 생산일자> BMW i4 eDrive40: 2022.02.10~2022.08.11 BMW i4 M50: 2022.04.25~2022.06.07 BMW i7 xDrive60: 2022.07.29 BMW iX xDrive50: 2021.09.20
高電圧バッテリーのセルモジュールの製造不良により、高電圧バッテリーが誤作動するおそれがある。そのため、稀にではあるが高電圧バッテリーが放電し、最悪の場合、火災につながる可能性がある。
배터리 셀 생산 공정 중에 손상된 음극판 조각이 배터리 셀 내부에 유입되어 고전압 배터리에 단락이 발생할 수 있으며, 이런 경우 셀 모듈이 방전될 수 있고, 화재가 발생할 수 있는 가능성에 따른 리콜 <*대상차량별 생산일자> BMW i4 eDrive40: 2021.11.24~2022.06.01 BMW i4 M50: 2021.11.23~2022.06.23 BMW iX M60: 2022.03.30~2022.03.30 BMW iX xDrive50: 2021.12.17~2022.06.27?
BMW of North America, LLC (BMW) is recalling certain 2022-2023 iX xDrive50, iX M60, 2022 i4 eDrive40, and i4 M50 vehicles. The high voltage battery may have internal damage, resulting in an electrical short-circuit.
Issue: On certain vehicles, the air bag control unit may not work properly due to a software error. As a result, the airbag warning light and warning messages may not turn on when there is a problem with the airbag system or the pedestrian protection system. Note: This recall replaces Transport Canada recall 2022-183. Vehicles that were repaired under that recall also require this repair. Safety Risk: An airbag system that does not work properly could increase the risk of injury in a crash. Corrective Actions: BMW will notify owners by mail and instruct you to take your vehicle to a dealership to update the airbag control unit software. To reduce the safety risk, BMW recommends that you should not transport any passengers until the recall repairs have been completed.
If a failure is detected by the control unit the airbag warning light and check control message would not to be illuminated and activated.
This recall was replaced by Transport Canada Recall No. 2022-364. Issue: On certain vehicles, the air bag control unit may not work properly due to a software error. As a result, the airbag warning light and warning messages may not turn on when there is a problem with the airbag system or the pedestrian protection system. Safety Risk: An airbag system that does not work properly could increase the risk of injury in a crash. Corrective Actions: BMW will notify owners by mail and instruct you to take your vehicle to a dealership to update the airbag control unit software. To reduce the safety risk, BMW recommends that you should not transport any passengers until the recall repairs have been completed.
On the vehicles concerned, the A-pillar panel holder may not be screwed in place according to specifications. Activation of the airbag, as well as causing the panel to separate, could lead to bending affecting the inflation behaviour of the airbag and, in a worst case scenario, damage the airbag, increasing the risk of injury.
生産工程において、当該車両に別仕様のホイールボルトが取り付けられている可能性が確認されました。この場合、車両の最大積載状態でホイールボルトが折損するおそれがあります。走行中にタイヤが車両から脱落すると事故のリスクが高まり、安全な走行に影響を及ぼすおそれがあるため、リコールを実施するものです。
出典:NHTSA(米国、パブリックドメイン)、カナダ運輸省(Open Government Licence – Canada)、DVSA(英国、Open Government Licence v3.0)、RappelConso および EU Safety Gate(フランス、Licence Ouverte 2.0)、国土交通省(日本、公共データ利用規約1.0)、韓国国土交通部(car.go.kr)。