電気系統:スターターアセンブリ
**車両の説明:** 乗用車 スターターアセンブリの一部は、問題のある樹脂製ターミナルブロックを使用して製造されていました。このターミナルブロックは、スターター本体への取り付け後に応力亀裂が発生するおそれがあります。ターミナルブロックがスターター本体から分離すると、ヒューズで保護されていない正極端子が隣接する表面に接触し、接地への経路が生じるおそれがあります。
🔔 無料アカウントを作成して Dodge Neon (すべての世代) のメール通知を受け取る
**車両の説明:** 乗用車 スターターアセンブリの一部は、問題のある樹脂製ターミナルブロックを使用して製造されていました。このターミナルブロックは、スターター本体への取り付け後に応力亀裂が発生するおそれがあります。ターミナルブロックがスターター本体から分離すると、ヒューズで保護されていない正極端子が隣接する表面に接触し、接地への経路が生じるおそれがあります。
ステアリングコラムのカップリングは、車両の underside (床下) に強い衝撃を受けた場合に外れる可能性があります。その結果、ステアリング操作ができなくなるおそれがあります。 対策:衝撃時に潰れる構造のステアリングコラムカップリングに交換します。
Vehicle description: Passenger vehicles. The steering column coupler can become disconnected when the vehicle experiences an underbody impact.
The fuel and rear brake tubes may experience accelerated corrosion between the tubes and a rubber isolator. Failure of these tubes could result in fuel leakage and/or diminished braking capacity. Correction: Brake, fuel supply and fuel vapour tubes will be inspected for the presence of red corrosion. Any tubes showing evidence of red corrosion will be replaced. In addition vehicles will have the rubber isolator replaced with a plastic clip.
The fuel and rear brake tubes can experience accelerated corrosion between the tubes and a rubber isolator.
The abs brake master cylinder rear seal allows air to enter the brake system, causing spongy brakes or partial brake system loss.
車両の説明:乗用車。オイルと熱の影響があると、ブレーキブースターの負圧ホースが膨張し、インテークマニホールドから外れることがあります。
Vehicle description: Passenger cars. Vapors from the positive crankcase ventilation (pcv) system can condense and freeze inside of the throttle body when the vehicle is operated in extremely cold ambient temperatures.
Vehicle description: Passenger vehicles. The front suspension lower control arms may have been inadequately welded between the pivot tube and the arm.
Vehicle description: Passenger vehicles. Some frontal (passenger side) air bags may not inflate properly.
Vehicle description: 乗用車。リアサスペンションのクロスメンバーに溶接スポットが欠落している場合があります。
これらの車両は、C.M.V.S.S. 1103(排出ガス)に適合していません。ソリッドステート式ファンリレーは、熱による電気的過負荷ストレスが原因で故障し、ファンが停止して車両がオーバーヒートする可能性があります。車両がオーバーヒートすると、排出ガスと運転性の両方に影響するおそれがあります。 対策:ソリッドステートリレーを交換し、ファン配線回路にダイオード付きジャンパーワイヤーを取り付けます。
The circuit design in the air bag electronic control module may allow the potential for inadvertent air bag deployment upon vehicle ignition shut down. Correction: The air bag electronic control module will be replaced with a module that incorporates the latest production redesigned circuit to prevent this condition.
The electrical circuit design allows the potential for an inadvertent air bag deployment upon vehicle ignition shut down.
On certain vehicles, the brake master cylinder may leak brake fluid due to a damaged double lip rear piston seal. Brake fluid leakage may result in diminished effectiveness of one portion of the split brake system. Correction: Rear brake master cylinder piston assemblies will be replaced.
The brake master cylinder can leak brake fluid due to a damaged double lip rear piston seal.
An engine wiring harness may short due to contact with the exhaust gas recirculation (egr) tube. Shorting of the harness may cause various electrical malfunctions, including engine die out. Correction: Wiring harness will be properly routed and any damaged wiring will be replaced.
An engine wiring harness can short circuit due to contact with the exhaust gas recirculation tube..
Moisture can get into the powertrain control module (pcm) causing driveability malfunctions, including stalling.
The rear brake hose mounting bracket screws can fail allowing the brake hoses to move out of position. The unrestrained hoses are then susceptible to damage which could result in brake fluid leakage.
Vehicles may experience an engine die out due to moisture in the powertrain control module (pcm) caused by inadequate potting material sealing. Also, the rear brake lines may be out of position due to failure of the mounting bracket screws. Correction: Powertrain control module and rear brake line bracket screws will be replaced on affected vehicles.
Vehicles may have been built with a rear abs brake master cylinder seal that may allow air ingestion into the cylinder and cause spongy brake feel or partial brake system loss. Correction: Vehicles will be inspected and suspect master cylinders will be replaced.
車両の概要:15インチホイールを装着し、R/Tパッケージを搭載した乗用車。一部の車両には誤ったタイヤ placard(タイヤ情報ラベル)が取り付けられていた。これらの車両には P195/50R16 タイヤが装着されていたが、タイヤ placard には推奨タイヤサイズとして P185/65R14 および P185/65R15 が記載されていた。これは FMVSS No. 110「タイヤの選択とリム」の要件に適合していない。
Vehicle description: Passenger vehicles equipped with the sport appearance package fail to comply with the requirements of fmvss 110, "tire selection and rims." certain vehicles built with 16" wheels and tires were equipped with the incorrect tire placard.
Vehicle description: Certain passenger vehicles, pickup trucks and sport utility vehicles fail to comply with the requirements of fmvss no. 225, "child restraint anchorage systems." some of the owner's manuals for these vehicles are missing instructions that provide a step-by-step procedure, including diagrams, for properly attaching a child restraint system's tether strap to the tether anchorage.
出典:NHTSA(米国、パブリックドメイン)、カナダ運輸省(Open Government Licence – Canada)、DVSA(英国、Open Government Licence v3.0)、RappelConso および EU Safety Gate(フランス、Licence Ouverte 2.0)、国土交通省(日本、公共データ利用規約1.0)、韓国国土交通部(car.go.kr)。