Improper routing of the power seat switch wiring will allow the wiring to be contacted and potentially damaged by the seat cushion spring ends when the seat is occupied. This could abrade or puncture the wiring and cause an electrical short which could in turn result in a fire. Correction: Power seat switch wiring will be rerouted and damaged wiring will be replaced.
The composite construction front brake rotors on these vehicles may corrode, weaken and fracture, resulting in a reduction of braking performance. Such a fracture would result in loss of braking at the corresponding front wheel which could in turn result in increased stopping distance and a possible crash. Correction: Front brake rotors will be replaced.
On vehicles equipped with a driver side supplemental air bag, the centre post threads of the air bag module may have been damaged during assembly. In a deployment level collision, the centre post housing may separate from the air bag adapter causing the air bag not to inflate properly. In addition, hot combustion gases would flow directly through the air bag rather than through the normal filtering and cooling devices, presenting the possibility of burn injury to vehicle occupants. Correction: Air bag modules will be inspected and replaced if necessary.
The steering column lower shaft may not be properly attached to the steering shaft insulator flange. If the shaft were to separate, total loss of steering control would occur without prior warning, resulting in a possible vehicle crash. Correction: Vehicles will be inspected and, if necessary, the steering shaft assembly will be replaced.
Steering shaft assemblies contain lower shafts of insufficient length for proper attachment to the shaft insulator flange. Consequence of defect: Shaft could separate, resulting in total loss of steering control and a possible accident.
On certain vehicles with 3.0 Litre and 3.8 Litre engines, the body mounts on the rear corners of the subframe which supports the engine and transmission may become detached due to corrosion of the rear lower mount retaining plates, allowing the rear corners of the subframe to drop. Should this occur, steering could become very difficult, thereby adversely affecting vehicle control. Correction: modified lower body mounts and attaching bolts will be installed on affected vehicles.
Seat belt buckles on these vehicles may experience conditions whereby the buckle may not unlatch when the release button is depressed or may not latch, or in some cases, may latch partially but not sufficiently to provide occupant restraint in the event of a collision. Note: Only end-release buckles on "rigid" mountings are susceptible to this malfunction. Correction: Factory installed end-release seat belt buckles will be replaced with redesigned buckles.
The rigid mounted safety belt buckles are defective in three ways. First, a fastened safety belt buckle will not unlatch when the release button is depressed. This results from interference between the buckle ejector finger and the buckle tongue window. The second defect is the safety belt buckle may not latch. The third possible defect is that the tongue may be retained by the buckle, but it may not be latched sufficiently to provide occupant protection.
Note: Station wagon vehicles only. Young children left unattended in the vehicle could lock themselves in the footwell area of the rear-facing third seat (or the underfloor storage compartment in station wagons not equipped with the optional third seat). Once the compartment is closed, it cannot be opened from the inside, and there is the danger of air deprivation, excessive body heat and panic response to a child who may have closed himself or herself in the compartment. Correction: A modified latch will be installed which does not have a self-latching feature and allows the compartment cover to be pushed open from the inside.
Children can accidentally lock themselves in the footwell area of the rear-facing third seat, or in the storage compartment in station wagons not equipped with an optional third seat. Once the compartment is closed it cannot be opened from the inside.
The power seat switch wiring is routed over rather than under the front seat support brace, allowing damage by seat cushion spring ends when seat is occupied.
Ranger/bronco ii - 2.9 litre engines taurus/sable - 3.0 litre engines note: Vehicles located in newfoundland, nova scotia, new brunswick and prince edward island. The throttle may stick in an open position due to linkage binding caused by corrosion. This would cause the engine to run at higher than idle speed when the throttle is released and could adversely affect driver control resulting in a possible crash. Correction: On vehicles with 2.9 litre engines, dealers will clean, modify and lubricate the hub pin and lever bushings with a marine-type anti-seize grease. Additionally, on vehicles with 3.0 litre engines, the hub pin lever assembly will be replaced. Note: This recall has been superseded by recall no. 91021.
An incorrect transistor in the autolamp headlamp control system module may malfunction and cause the headlamps to turn off while the vehicle is being driven. This could cause impaired driver vision and a possible vehicle crash. Correction: Autolamp light sensor module will be replaced on affected vehicles.
These vehicles may not comply with C.M.V.S.S. 1103 - 排気ガス規制. The central fuel injector (CFI) may operate rich during certain operating conditions. 是正措置: 改良型CFIフューエルインジェクターを取り付け、アイドル回転数を調整します。
These vehicles do not comply with c.M.V.S.S. 108 - lighting. Vehicles were equipped with clear front side marker lamps and clear bulbs instead of amber bulbs. Correction: Clear front side marker lamp bulbs will be replaced with amber bulbs.
出典:NHTSA(米国、パブリックドメイン)、カナダ運輸省(Open Government Licence – Canada)、DVSA(英国、Open Government Licence v3.0)、RappelConso および EU Safety Gate(フランス、Licence Ouverte 2.0)、国土交通省(日本、公共データ利用規約1.0)、韓国国土交通部(car.go.kr)。