On the subject vehicles the control logic which monitors the charging control program fails to divert the electrical power away from the capacitor when a fault is detected within the capacitor circuit. This can cause a short circuit inside the DCDC converter and could cause the engine to stall or overheating of the DCDC converter itself which could cause a fire. The fault is accompanied by the �i-ELOOP� warning light being illuminated on the instrument cluster along with the �i-Stop� warning light flashing The engine may in some circumstances stall and fail to restart. In extreme cases the DCDC converter could overheat and cause a fire
DVSA · 영국2018년 9월 17일R/2018/237연식 2015–2017원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
The engine control unit of the direct-current converter may be defective. This could result in a short circuit and damage of the converter, which can lead to a fire.
Safety Gate · EU2018년 9월 7일A12/1310/18연식 2014–2017원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Mazda North American Operations (Mazda) is recalling certain model year 2016 CX-3 vehicles manufactured June 1, 2015, to December 2, 2015, 2013-2014 Mazda2 vehicles manufactured July 3, 2013, to August 8, 2014, 2014-2016 CX-5 vehicles manufactured January 19, 2013, to December 2, 2015, and 2013-2015 CX-9 vehicles manufactured December 6, 2012, to July 31, 2015. The lower mounting nuts and bolts that attach the front strut assembly to the steering knuckle may loosen, allowing the steering knuckle to separate.
NHTSA · 미국2016년 4월 11일16V203000연식 2016원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
On certain vehicles, the nut and bolt holding the strut assembly to the knuckle may not have been tightened properly during the manufacturing process. Over time, this could cause the strut assembly to separate from the knuckle, resulting in a loss of steering control which would increase the risk of a crash causing injury and/or damage to property. Correction : Dealers will inspect and replace the nut and bolt holding the strut assembly to the knuckle if found loose.
캐나다 교통부2016년 4월 8일2016152연식 2016원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
가솔린 엔진 차량의 저압 연료 펌프 임펠러(수지제 날개차)에서, 성형 조건이 부적절하여 수지 밀도가 낮아지고, 연료에 의해 팽윤되어 변형되는 경우가 있다. 그 결과 임펠러가 펌프 케이스와 접촉하여 저압 연료 펌프가 작동 불량을 일으킬 수 있으며, 최악의 경우 주행 중 엔진 정지(엔진 스톨)에 이를 우려가 있다.
국토교통성 · 일본2024년 1월 26일1154360연식 2017–2020자동 번역 · 원문: 일본어자세히 보기 →
마즈다 북미법인(Mazda North American Operations, Mazda)은 2018년형 Mazda3, Mazda6, 2019년형 CX-3, 2018~2019년형 MX-5, CX-5, CX-9, 그리고 2019~2020년형 Mazda2 일부 차량에 대해 리콜을 실시하고 있습니다. 저압 연료펌프 내부의 임펠러에 균열이 생기고 변형될 수 있으며, 이로 인해 연료펌프가 고장 날 가능성이 있습니다.
NHTSA · 미국2021년 11월 12일21V875000연식 2019자동 번역 · 원문: 영어자세히 보기 →
On the subject vehicles the engine protection logic does not work properly. When the engine speed reaches maximum with no engine load present � the software is unable to cut the engine. This could in extreme cases cause catastrophic engine failure. Immediate and catastrophic engine damage may result.
DVSA · 영국2018년 4월 2일R/2018/087연식 2015–2017원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Mazda North American Operations(Mazda)는 2010~2013년식 Mazda3 및 Mazdaspeed3 중 2008년 11월 18일부터 2013년 6월 8일 사이에 생산된 차량, 2012~2015년식 Mazda5 중 2010년 10월 26일부터 2015년 6월 22일 사이에 생산된 차량, 2016년식 CX-3 중 2015년 6월 1일부터 2015년 12월 26일 사이에 생산된 차량, 그리고 2013~2016년식 CX-5 중 2011년 12월 15일부터 2015년 12월 26일 사이에 생산된 차량을 리콜하고 있습니다. 해당 차량에서는 리프트게이트 지지 스트럿(support strut)이 부식되어 스트럿이 파손되거나 리프트게이트가 예기치 않게 떨어질 수 있습니다.
NHTSA · 미국2016년 9월 6일16V644000연식 2016자동 번역 · 원문: 영어자세히 보기 →
출처: NHTSA(미국, 퍼블릭 도메인), 캐나다 교통부(Open Government Licence – Canada), DVSA(영국, Open Government Licence v3.0), RappelConso 및 EU Safety Gate(프랑스, Licence Ouverte 2.0), 일본 국토교통성(공공데이터 이용약관 1.0), 한국 국토교통부(자동차리콜센터 car.go.kr).