Frei lesbar · kostenloses Konto zum MitmachenNachfolger von Anticars (2000)

Audi A3

1996– · 7 generationen · 42 dokumentierte Mängel · 6 Märkte
Generationen

Technische Bulletins (TSB) sind Reparaturanweisungen, die Hersteller ihren Händlern zu bekannten Problemen schicken. Sie sind keine Sicherheitsrückrufe, bestätigen aber oft einen Mangel.

SchweregradAlleMittelGering
Modelljahr
MarktAlleNA
A3 S3 (8Y) · 2020–
BulletinMittelMotorNA

Bulletin

An engine cover was not installed on affected vehicles at the factory. An engine cover will be installed on affected vehicles free of charge. Updated criteria and engine cover part number

NHTSA · Herstellerbulletin11022660Modelljahre 2024Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
A3 S3 (8Y) · 2020–
BulletinMittelMotorNA

Bulletin

An engine cover was not installed on affected vehicles at the factory. An engine cover will be installed on affected vehicles free of charge. Updated criteria and engine cover part number

NHTSA · Herstellerbulletin11022658Modelljahre 2024Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
A3 S3 (8Y) · 2020–
BulletinMittelMotorNA

Bulletin

This Pending Service Solution (PSS) requests that technicains create a PSS Record in instances where the engine does not start sporadically.

NHTSA · Herstellerbulletin11009955Modelljahre 2024Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
A3 S3 (8Y) · 2020–
BulletinMittelMotorNA

Bulletin

An engine cover was not installed on affected vehicles at the factory. An engine cover will be installed on affected vehicles free of charge.

NHTSA · Herstellerbulletin10247146Modelljahre 2024Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
A3 S3 (8Y) · 2020–
BulletinMittelMotorNA

Bulletin

An engine cover was not installed on affected vehicles at the factory. An engine cover will be installed on affected vehicles free of charge.

NHTSA · Herstellerbulletin10247145Modelljahre 2024Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
A3 III · 2012–2020
BulletinMittelMotorNA

Bulletin

On-Hoist Inspection Section: Removed "Perform a coolant reservoir cap pressure test via ELSA -> Enter VIN # -> Repair manual Engine -> 4-Cylinder Direct Injection 1.8L; 2.0L 4V TFSI Engine (Generation III) -> 19 Cooling System -> Coolant System/Coolant -> Cooling System, Checking for Leaks -> Pressure Relief Valve in Cap, Checking. Only the procedure ?Pressure Relief Valve in Cap, Checking? should be performed in the document Cooling System, Checking for Leaks

NHTSA · Herstellerbulletin10120803Modelljahre 2017Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
A3 III · 2012–2020
BulletinMittelMotorNA

Bulletin

Supersedes Technical Service Bulletin Group 87 number 14-56 dated September 12, 2014. The air conditioning does not cool, or the cooling performance is very weak. The air conditioning system cools, but the compressor is noisy. The noise is characterized as a grinding or groaning noise. Either symptom may be intermittent . No DTCs are stored. The condition may be caused by a faulty N280 valve. The internal components of the valve can be obstructed and incapable of full function. This loss of refrigerant regulation from N280 can cause noise from the A/C compressor and/or affect the HVAC cooling. The Denso A/C compressor is currently being installed in production. An improved N280 valve for the Sanden A/C compressor is in development, as the installation of Sanden compressors for production will resume in the future.

NHTSA · Herstellerbulletin10119951Modelljahre 2015Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
A3 III · 2012–2020
BulletinMittelMotorNA

Bulletin

Supersedes Technical Service Bulletin Group 10 number 13-10 dated September 5, 2013. Prior to engine replacement, any debris lodged in transferred assemblies must be removed. If the engine experienced a serious mechanical problem, it is possible that small pieces of metal debris resulting from the mechanical problem may have become deposited in the intake manifold, air intake hoses, exhaust manifolds, exhaust down-pipes, turbocharger, supercharger, and/or intercooler. If these metal debris pieces are not removed prior to the installation and operation of the replacement engine, they could be drawn into the combustion chamber, which can cause a knocking noise and subsequent serious engine damage.

NHTSA · Herstellerbulletin10119945Modelljahre 2016Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
A3 III · 2012–2020
BulletinMittelMotorNA

Bulletin

The MIL is on due to a Fuel Rail/System Pressure Too Low DTC stored in the ECM. Drivability concerns such as hard starting/no starting are present. Fuel pump may be making a straining noise. Outside temperature is sub-freezing. This issue is related to the diesel fuel and not a technical problem with the vehicle.

NHTSA · Herstellerbulletin10119854Modelljahre 2015Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
A3 III · 2012–2020
BulletinMittelMotorNA

Bulletin

This bulletin describes the service for a vehicle that intermittently does not start or the engine is not performing.

NHTSA · Herstellerbulletin10094666Modelljahre 2015Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
A3 III · 2012–2020
BulletinMittelMotorNA

Bulletin

Supersedes Technical Service Bulletin Group 01 number 13-86 dated April 15, 2013. The MIL is on. There is a rough idle. DTCs are stored in the ECM. Engine may have reduced performance without significant loss of power or stalling. Because there are a number of different misfire faults (unrelated to ignition coil operation) that could cause the MIL to illuminate, proper Guided Fault Finding (GFF) misfire diagnosis must be followed before any ignition coils are replaced.

NHTSA · Herstellerbulletin10122184Modelljahre 2015Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
A3 III · 2012–2020
BulletinMittelMotorNA

Bulletin

Supersedes Technical Service Bulletin Group 01 number 14-59 dated January 21, 2014. The MIL is on. DTC may be stored in the ECM. Drivability concerns such as hard starting/no starting are present. Outside temperature is sub-freezing. In tank, fuel pump may be making a straining noise.

NHTSA · Herstellerbulletin10122183Modelljahre 2015Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
A3 III · 2012–2020
BulletinMittelMotorNA

Bulletin

Supersedes Technical Service Bulletin Group 01 number 14-55 dated January 8, 2014. The MIL is on. DTC P0087 may be stored in the ECM. Drivability concerns such as hard starting/no starting are present. Outside temperature is sub-freezing. In tank, fuel pump may be making a straining noise.

NHTSA · Herstellerbulletin10122180Modelljahre 2015Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
A3 III · 2012–2020
BulletinMittelMotorNA

Bulletin

The MIL is on. DTC P0087 may be stored in the ECM. Drivability concerns such as hard starting/no starting are present. Outside temperature is sub-freezing. In tank, fuel pump may be making a straining noise. Diesel fuel requires additive blending or ?winterization? to be useable at low temperatures. At temperatures below 20 F (-7 C), No. 2 Diesel with insufficient winterization blending may lose its fluidity due to wax separation. This may clog the fuel filter or in-tank filter, preventing the engine from operating properly. No. 2 Diesel is blended by refineries to various levels of winterization (minimum useable temperature) based on month, geographical location, and the 10th percentile minimum ambient air temperature for the given region. Although rare, during sudden periods of extreme low temperatures (record lows), fuel stations may not be adequately prepared with No. 2 Diesel fuel with sufficient winterization to resist wax formation or ?gelling?.

NHTSA · Herstellerbulletin10122176Modelljahre 2015Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
A3 II · 2003–2013
BulletinMittelMotorNA

Bulletin

Audi: Mil on; no start or rough running (dtc p0087-rail fuel pressure too low). Contaminated or incorrect fuel can cause performance, drivability, and/or fuel delivery problems. Rust or metallic debris found in the fuel system indicates a major component failure. *pe updated on 6/14/2011. *kb

NHTSA · Herstellerbulletin10034751Modelljahre 2010Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
A3 III · 2012–2020
BulletinGeringMotorNA

Bulletin

Dieses Bulletin liefert Informationen, wenn der Motor nicht reibungslos läuft; alle Gasmotoren.

NHTSA · Herstellerbulletin11039252Modelljahre 2018Automatisch übersetzt · Original: EnglischDetails ansehen →
A3 III · 2012–2020
BulletinGeringMotorNA

Bulletin

This bulletin provides information when DTC B105A1A, B103E25 is stored in 0017; fuel tank level implausible.

NHTSA · Herstellerbulletin11035829Modelljahre 2018Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
A3 III · 2012–2020
BulletinGeringMotorNA

Bulletin

This bulletin provides information when DTC B105A1A, B103E25 is stored in 0017; fuel tank level implausible.

NHTSA · Herstellerbulletin11035828Modelljahre 2018Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
A3 III · 2012–2020
BulletinGeringMotorNA

Bulletin

This bulletin provides information when the DTC P218100 malfunction in cooling system is logged.

NHTSA · Herstellerbulletin11002998Modelljahre 2019Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
A3 III · 2012–2020
BulletinGeringMotorNA

Bulletin

This bulletin provides information when the DTC P218100 malfunction in cooling system is logged.

NHTSA · Herstellerbulletin11002929Modelljahre 2019Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
A3 III · 2012–2020
BulletinGeringMotorNA

Bulletin

Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay. When an unapproved aftermarket speed-filling device is used to add oil to the engine, the increased oil flow rate may force oil into the intake manifold or combustion chamber, creating the potential for engine damage.

NHTSA · Herstellerbulletin10228295Modelljahre 2016Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
A3 II · 2003–2013
BulletinGeringMotorNA

Bulletin

Contaminated or incorrect fuel can cause performance, drivability, and/or fuel delivery problems.

NHTSA · Herstellerbulletin10228356Modelljahre 2010Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
A3 III · 2012–2020
BulletinGeringMotorNA

Bulletin

Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay. When an unapproved aftermarket speed-filling device is used to add oil to the engine, the increased oil flow rate may force oil into the intake manifold or combustion chamber, creating the potential for engine damage.

NHTSA · Herstellerbulletin10224974Modelljahre 2016Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
A3 II · 2003–2013
BulletinGeringMotorNA

Bulletin

Contaminated or incorrect fuel can cause performance, drivability, and/or fuel delivery problems.

NHTSA · Herstellerbulletin10225035Modelljahre 2010Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
A3 III · 2012–2020
BulletinGeringMotorNA

Bulletin

Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay. When an unapproved aftermarket speed-filling device is used to add oil to the engine, the increased oil flow rate may force oil into the intake manifold or combustion chamber, creating the potential for engine damage.

NHTSA · Herstellerbulletin10221947Modelljahre 2016Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Ältere →

Quellen: NHTSA (USA, gemeinfrei), Transport Canada (Open Government Licence – Canada), DVSA (Vereinigtes Königreich, Open Government Licence v3.0), RappelConso und EU-Safety-Gate (Frankreich, Licence Ouverte 2.0), MLIT (Japan, Public Data License 1.0) und MOLIT (Südkorea, car.go.kr).