Ein Defekt im Gasgenerator des Beifahrerairbags führt beim Auslösen des Airbags zu einer unkontrollierten Entfaltung und zum Austritt von Metallsplittern.
Safety Gate · EU · RappelConso · Frankreich4. Juli 2022a12/0089/19Modelljahre 2004–2012Automatisch übersetzt · Original: FranzösischDetails ansehen →
Ein Defekt im Gasgenerator des Beifahrerairbags führt beim Auslösen des Airbags zu einer unkontrollierten Entfaltung und zum Austritt von Metallsplittern. Dadurch können die Insassen des Fahrzeugs verletzt werden.
Im Jahr 2013 kündigte Nissan eine Rückrufaktion an, bei der die Takata-SPI-Gasgeneratoren des Beifahrerairbags ersetzt werden sollten. Für den Austausch wurde ein nicht getrockneter Gasgenerator des Beifahrerairbags verwendet. Obwohl bei Gasgeneratoren dieses Typs bislang keine bekannten Vorfälle aufgetreten sind, hat Nissan entschieden, alle Gasgeneratoren, die zuvor durch einen nicht getrockneten Gasgenerator ersetzt wurden, durch eine neue, getrocknete Version zu ersetzen.
The air bag inflators on affected vehicles were previously checked and deemed to be serviceable. As a precautionary measure the manufacturer has decided to replace them with new assemblies.
Im Falle einer Auslösung des Beifahrerairbags könnte der Gasgenerator des Airbags bersten und Metallsplitter in den Fahrgastraum freisetzen, wodurch die Insassen verletzt werden können.
The manufacturer has identified that a potential air leak at the passenger airbag inflators which may allow moisture to enter the airbag inflator causing the propellant in the inflator units to deteriorate. Deterioration of the propellant may lead to abnormal deployment of the passenger airbag. In an extreme situation this may result in separation of the airbag housing during deployment causing injury to occupants.
null A potential air leak on some passenger airbag inflators may allow moisture to enter the airbag inflator causing the propellant in the inflator units to deteriorate. Deterioration of the propellant may create excessive pressure and may result in separation of the airbag housing.
Safety Gate · EU29. Mai 2015A12/0717/15Modelljahre 2012–2015Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
null A fault in the gas generator of the front passenger airbag can cause uncontrolled inflation when the airbag is activated. Because the ignition pressure is too high, it can damage the airbag housing and cause injury.
The subject vehicles are equipped with front passenger airbag inflators which could have been assembled with improperly manufactured propellant wafers. Improperly manufactured propellant wafers could cause the inflator to rupture and the front passenger airbag to deploy abnormally in a crash. This could result in increased risk of injury to the occupant and the possibility of a fire.
null The front passenger airbag inflators may have been manufactured out of specification. This could create excessive pressure within the inflator during airbag deployment and may result in separation of the airbag housing.
The brake system LSV pilot tube may chafe on the vehicle floorpan. Over time the wall thickness may reduce and allow fluid leakage resulting in reduced brake efficiency.
DVSA · Vereinigtes Königreich19. Juli 2000R/2000/028Modelljahre 1995–1997Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Quellen: NHTSA (USA, gemeinfrei), Transport Canada (Open Government Licence – Canada), DVSA (Vereinigtes Königreich, Open Government Licence v3.0), RappelConso und EU-Safety-Gate (Frankreich, Licence Ouverte 2.0), MLIT (Japan, Public Data License 1.0) und MOLIT (Südkorea, car.go.kr).