Lectura libre · cuenta gratuita para colaborarSucesor de Anticars (2000)

Mazda MPV

1988–2016 · 3 generaciones · 25 averías documentadas · 4 mercados
Generaciones
Año del modelo
MPV II · 1999–2006
LlamadaModeradoMotorNA

Engine

Certain vehicles previously updated following an emission recall concerning the PCV hose may experience throttle icing during cold weather operation. As a result of misrouting of the PCV hose during the emission recall, moisture build-up inside the hose could freeze while the vehicle is parked. If the vehicle is then driven at constant highway speeds in extremely cold temperatures (-30 degrees Celsius or colder), the moisture in the blow-by gases may freeze in the throttle valve area. Under these conditions, even if the accelerator pedal is released while driving, engine speed may not decrease. Unwanted acceleration could result in a vehicle crash without prior warning. Correction: Dealers will inspect the previously replaced PCV hose for proper routing and reroute if necessary.

Transport Canada10 feb 20062006035Años modelo 2002–2003Mostrado en inglés original · traducción pendienteVer detalles →
MPV II · 1999–2006
LlamadaModeradoMotorNA

Engine

On certain vehicles equipped with a 2.5L V6 Duratec engine, while driving at a constant speed on the highway, it is possible that the engine speed will not decrease when releasing the accelerator pedal due to a frozen throttle valve. This condition occurs at ambient temperatures from -30 to -40 degrees Celsius. The vehicle can be brought to a full stop by depressing the brake pedal. Correction: Dealers will replace the intake manifold and PCV hose with modified parts which will change the layout of the PCV hose system.

Transport Canada20 oct 20042004376Años modelo 2000–2001Mostrado en inglés original · traducción pendienteVer detalles →
MPV II · 1999–2006
MPV II · 1999–2006
LlamadaModeradoMotorJP

ブローバイ装置

ブローバイガスを吸気管に導くPCVホースの形状が不適切なため、エンジンの負圧変動 により当該ホースが伸縮する。そのため、そのまま使用を続けると、ブローバイガスまた はオゾンの影響で発生する微細な亀裂が進行し、当該ホースが破損するおそれがある。

MLIT · Japón26 ago 20041112110Años modelo 2002–2003Mostrado en japonés original · traducción pendienteVer detalles →
MPV II · 1999–2006
LlamadaModeradoMotorJP

エンジン一般

オートクルーズ・コントロール装置装着車において、オートクルーズ・コントロール・ケ ーブルの取り付け部に曲げ応力に対する耐久性が不十分なものがあり、そのままの状態で 使用を続けると、当該取り付け部(ケーブルブラケットに固定する部分)に亀裂が生じて 破損することがある。そのため、オートクルーズ・コントロール・ケーブルがケーブルブ ラケットに保持されなくなり、最悪の場合、オートクルーズ・コントロール・ケーブルが アクセルケーブルに引っ掛かり、オートクルーズ・コントロール・ケーブルのインナーワ イヤーが引かれた状態となり、エンジン回転が下がらなくなるおそれがある。

MLIT · Japón10 jun 20041110890Años modelo 1999–2002Mostrado en japonés original · traducción pendienteVer detalles →
MPV II · 1999–2006
LlamadaModeradoMotorNA

Vehicle speed control:Cables

On certain minivans equipped with cruise control, the cruise control actuator cable may be broken due to insufficient strength (group 1). Also included are certain 2000-2001 minivans equipped with cruise control built between march 31, 1999 and march 31, 2001, that have had the cruise control repaired and possibly had a defective cable installed during that repair (group 2).

NHTSA · Estados Unidos19 may 200404V234000Años modelo 2001–2002Mostrado en inglés original · traducción pendienteVer detalles →
MPV II · 1999–2006
LlamadaModeradoMotorNA

Emissions

Certain vehicles do not comply with the requirements of CMVSS 1101- Emission Device. Inappropriate programming of the Powertrain Control Module.(PCM). Correction: Dealer will reprogram the PCM.

Transport Canada17 feb 20002000029Años modelo 2000Mostrado en inglés original · traducción pendienteVer detalles →

Fuentes: NHTSA (Estados Unidos, dominio público), Transport Canada (Licencia de Gobierno Abierto – Canadá), DVSA (Reino Unido, Open Government Licence v3.0), RappelConso y Safety Gate de la UE (Francia, Licence Ouverte 2.0), MLIT (Japón, Licencia de Datos Públicos 1.0) y MOLIT (Corea del Sur, car.go.kr).