Les bulletins techniques (TSB) sont des instructions de réparation que les constructeurs envoient à leurs concessionnaires sur des problèmes connus. Ce ne sont pas des rappels de sécurité, mais ils confirment souvent un défaut.
Unable To Install The Left-Hand Power Take-Off (PTO) Unit Upfitters or technicians may experience the following: Unable to install the left-hand PTO unit because of an interference with the fuel line engine bundle. This bulletin involves replacing the fuel line bundle or possibly giving the fuel line bundle to a third party upfitter
NHTSA · bulletin constructeur11025710Années modèle 2025Affiché en anglais d’origine · traduction en attenteVoir le détail →
Engine Block Heater Cord Not Fully Installed From The Factory. Discussion: During Pre-Delivery Inspection (PDI) you will notice that the engine block heater cord is not installed on the engine block.
NHTSA · bulletin constructeur11018601Années modèle 2025Affiché en anglais d’origine · traduction en attenteVoir le détail →
Le problème concerne une surchauffe, un fonctionnement à température élevée, des fuites de liquide de refroidissement et des symptômes associés après l'installation d'un moteur de remplacement Mopar dans le véhicule.
NHTSA · bulletin constructeur10230180Années modèle 2012Traduit automatiquement · original : anglaisVoir le détail →
Le problème concerne une surchauffe, un fonctionnement à température élevée, des fuites de liquide de refroidissement et des symptômes associés après l'installation d'un moteur de remplacement Mopar dans le véhicule.
NHTSA · bulletin constructeur10221594Années modèle 2012Traduit automatiquement · original : anglaisVoir le détail →
Valve Cover Gasket It is advised to replace the full valve cover assembly if you are experiencing a valve cover leak Engineering has updated the skirt height of the valve cover to address oil leaks. Replace the valve cover (part # 04893800AI (right side) or 04893799AH (left side)includes valve cover gasket) to ensure proper repair. Please call FCA Redacted Content to facilitate fast track shipment of failed part.
NHTSA · bulletin constructeur10221366Années modèle 2021Affiché en anglais d’origine · traduction en attenteVoir le détail →
GASKET, Timing Case Cover, Rear Gear Housing For 2021 Model Year only. If you are replacing the timing gear housing gasket due to an oil leak, please be sure to also replace all outer timing gear housing bolts (PN# 04638665 and 04882109). Do not discard these bolts as engineering will be requesting them to be returned for analysis.
NHTSA · bulletin constructeur10221373Années modèle 2021Affiché en anglais d’origine · traduction en attenteVoir le détail →
Valve Cover Gasket If you are experiencing a right valve cover leak and plan on replacing only the gasket, the customer may later return for an oil leak. Engineering has updated the skirt height of the valve cover to address oil leaks. Replace the valve cover (part # 04893800AI includes valve cover gasket) to ensure proper repair. Please call FCA Redacted Content if further questions or help is needed with parts retention returns on valve cover assemblies
NHTSA · bulletin constructeur10214518Années modèle 2021Affiché en anglais d’origine · traduction en attenteVoir le détail →
Intermittent No Crank No Start This bulletin involves inspecting the ground wire to engine block fastener and replacingif necessary. The customer may comment on the following:A no start and/or intermittent no start condition.
NHTSA · bulletin constructeur10175549Années modèle 2020Affiché en anglais d’origine · traduction en attenteVoir le détail →
Intermittent No Crank No Start This bulletin involves inspecting the ground wire to engine block fastener and replacingif necessary. The customer may comment on the following:A no start and/or intermittent no start condition.
NHTSA · bulletin constructeur10175136Années modèle 2020Affiché en anglais d’origine · traduction en attenteVoir le détail →
Intermittent No Crank No Start This bulletin involves inspecting the ground wire to engine block fastener and replacingif necessary. The customer may comment on the following:A no start and/or intermittent no start condition.
NHTSA · bulletin constructeur10174216Années modèle 2020Affiché en anglais d’origine · traduction en attenteVoir le détail →
Description de la pièce : Bloc moteur complet 5.7L
Description du problème : Cet ensemble bloc moteur complet 5.7L est compatible avec les applications EGR et non-EGR. Une plaque d'obturation EGR (53032739AA) doit être commandée lors de l'installation de cet ensemble bloc moteur complet sur une application non-EGR. Sauf si la plaque d'obturation EGR est transférée depuis l'ancien moteur.
NHTSA · bulletin constructeur10229181Années modèle 2003–2008Traduit automatiquement · original : anglaisVoir le détail →
Rear Crank Shaft Oil Seal and Retainer Plate For Cummins equipped vehicles only;~ If you are working on a 2016 vehicle ONLY and are replacing the Rear Main Seal for oil leak, replace seal, retainer and gasket using PNs; 05086755A$, 05086754A$, 05015705A$. Remove the retainer with the seal installed. Please do not disturb seal in retainer when removing from engine. Please refer to detailed repair instructions in DealerConnect TechConnect for oil seal retainer replacement.~ Cummins Engineering is currently investigating the root cause of the oil leak concern and would like to analyze these parts. Please contact Chad Eichbrecht at cell (248) 309-2695 to arrange for part return~ If you do not receive a response within 15 minutes, please proceed with normal repair. ~
NHTSA · bulletin constructeur10228156Années modèle 2016Affiché en anglais d’origine · traduction en attenteVoir le détail →
Customer Satisfaction Notification T12 VECI Label The Vehicle Emission Control Information (VECI) label on about 120,000 of the above vehicles may be missing emission control information. The VECI label is often used during in-use Inspection and Maintenance (I/M) testing to verify proper emissions related components. Incorrect VECI label information could result in denial of vehicle registration for the vehicle in the state of California. A new VECI label must be installed.
NHTSA · bulletin constructeur10224875Années modèle 2015Affiché en anglais d’origine · traduction en attenteVoir le détail →
Cummins Service Engine Replacement This bulletin involves replacing the engine assembly. Remanufactured long block or short block was installed during a prior repair. A new replacement engine will be installed.
NHTSA · bulletin constructeur10224642Années modèle 2012Affiché en anglais d’origine · traduction en attenteVoir le détail →
Service - Joint de carter d'huile en quatre pièces
Véhicules équipés Cummins UNIQUEMENT - Le joint de carter d'huile de remplacement peut être un joint en quatre pièces plutôt qu'un joint d'une seule pièce. Ceci s'applique uniquement aux moteurs Cummins 5.9L et 6.7L. Installation : 1. Nettoyer les jonctions en T du carter d'huile.~ 2. Remplir la jonction en T entre le rail du carter/boîtier d'engrenages et le rail du carter/support du joint arrière avec du mastic. Utiliser du Mopar Silicone Rubber Adhesive Sealant ou un équivalent. 3. Appliquer un cordon de 2 mm [0,063 po] de Mopar Engine Sealant RTV Silicone Rubber Adhesive sur la bride du carter d'huile.~ 4. Les quatre segments du joint doivent être assemblés pour former un joint de carter d'huile complet. 5. Poser le ou les joints de carter d'huile sur la bride du carter d'huile.~ 6. S'assurer que les jonctions des segments du joint de carter d'huile sont correctement alignées. 7. Appliquer un cordon de 2 mm [0,063 po] de Mopar Engine Sealant RTV Silicone Rubber Adhesive sur le dessus du joint de carter d'huile.~ 8. Installer le carter d'huile. En partant du centre et en progressant vers l'extérieur, serrer les boulons du carter d'huile à 28 Nm [21 pi-lb].
NHTSA · bulletin constructeur10223854Années modèle 1998Traduit automatiquement · original : anglaisVoir le détail →
Replace Vehicle Emission Certification Information Label This bulletin involves replacing the Vehicle Emission Certification Information (VECI) Label.Owner may be turned away from Inspection and Maintenance (IM) station or fail IM testing because of missing emission components on VECI label. The customer may notice that some info is missing on their VECI labels.is missing. If information is shown in this area, do not replace the label.All vehicles were built with the correct emission components installed and there is no impact on emission performance or drivability.
NHTSA · bulletin constructeur10223853Années modèle 2015Affiché en anglais d’origine · traduction en attenteVoir le détail →
Description de la pièce : Bloc moteur complet 5.7L
Description du problème : Cet ensemble de bloc moteur complet 5.7L est compatible avec les applications avec et sans EGR. Une plaque d'obturation EGR (53032739AA) doit être commandée lors de l'installation de cet ensemble de bloc moteur complet dans une application sans EGR, sauf si la plaque d'obturation EGR est transférée depuis l'ancien moteur.
NHTSA · bulletin constructeur10223602Années modèle 2003–2008Traduit automatiquement · original : anglaisVoir le détail →
Rear Crank Shaft Oil Seal and Retainer Plate For Cummins equipped vehicles only;~ If you are working on a 2016 vehicle ONLY and are replacing the Rear Main Seal for oil leak, replace seal, retainer and gasket using PNs; 05086755A$, 05086754A$, 05015705A$. Remove the retainer with the seal installed. Please do not disturb seal in retainer when removing from engine. Please refer to detailed repair instructions in DealerConnect TechConnect for oil seal retainer replacement.~ Cummins Engineering is currently investigating the root cause of the oil leak concern and would like to analyze these parts. Please contact Chad Eichbrecht at cell (248) 309-2695 to arrange for part return~ If you do not receive a response within 15 minutes, please proceed with normal repair. ~
NHTSA · bulletin constructeur10220272Années modèle 2016Affiché en anglais d’origine · traduction en attenteVoir le détail →
Oil Pan 2012-2017 Cummins engines with oil pan leaks, please inspect the shallow area of the oil pan for cracks. If cracks are found, please replace as necessary. Cracks are typically found above the cross member area. Please contact Chad Eichbrecht at cell (248) 309-2695 to arrange for part return or email chad.w.eichbrecht@fcagroup.com If you do not receive a response within 15 minutes, please proceed with normal repair.
NHTSA · bulletin constructeur10219836Années modèle 2012Affiché en anglais d’origine · traduction en attenteVoir le détail →
Diesel Exhaust Fluid (DEF) Injector Inspection This bulletin involves pressurizing the Diesel Exhaust Fluid (DEF) injector line to check for a leak during New Vehicle Preparation. The DEF system may not become functional until the vehicle has been driven for 20 miles at one time. This Bulletin will give the steps necessary to ensure DEF system is not leaking. A very small number of vehicles may experience a DEF fluid leak under the vehicle. Upon further investigation the Technician may find that the DEF injector is broke.
NHTSA · bulletin constructeur10218793Années modèle 2014Affiché en anglais d’origine · traduction en attenteVoir le détail →
Diesel Exhaust Fluid (DEF) Injector Inspection This bulletin involves pressurizing the Diesel Exhaust Fluid (DEF) injector line to check for a leak during New Vehicle Preparation. The DEF system may not become functional until the vehicle has been driven for 20 miles at one time. This Bulletin will give the steps necessary to ensure DEF system is not leaking. A very small number of vehicles may experience a DEF fluid leak under the vehicle. Upon further investigation the Technician may find that the DEF injector is broke.
NHTSA · bulletin constructeur10217952Années modèle 2014Affiché en anglais d’origine · traduction en attenteVoir le détail →
Fluid Leak From Washer Reservoir (X44 Warranty Extension 5 Years/100,000 Miles (160,000 KMS)) This bulletin involves inspecting and/or replacing the washer reservoir. A customer may have a condition where fluid is leaking from the washer reservoir. On further inspection the technician may find cracks in the reservoir by the washer pump pocket.
NHTSA · bulletin constructeur10216415Années modèle 2011Affiché en anglais d’origine · traduction en attenteVoir le détail →
Some of the above vehicles equipped with a 6.7L diesel engine may experience a condition where the Noise, Vibration, and Harshness (NVH) engine cover insulates the area on the passenger side of the engine. This could cause engine components under the NVH cover to overheat and possibly ignite.
NHTSA · bulletin constructeur10215827Années modèle 2013Affiché en anglais d’origine · traduction en attenteVoir le détail →
Sources : NHTSA (États-Unis, domaine public), Transports Canada (Licence du gouvernement ouvert – Canada), DVSA (Royaume-Uni, Open Government Licence v3.0), RappelConso et Safety Gate de l'UE (France, Licence Ouverte 2.0), MLIT (Japon, licence de données publiques 1.0) et MOLIT (Corée du Sud, car.go.kr).