ステアリング:ステアリングホイール/ハンドルバー
亜鉛めっき処理を施したアッパーステアリングコラムシャフトのカップリングボルトに水素脆性が生じ、ボルトが破断した。
🔔 無料アカウントを作成して Dodge デイトナ (すべての世代) のメール通知を受け取る
亜鉛めっき処理を施したアッパーステアリングコラムシャフトのカップリングボルトに水素脆性が生じ、ボルトが破断した。
Air bag inflator modules may not contain diffuser holes between the ignitor and propellant chambers.
エンジンのバルブカバーガスケットがずれて(脱落して)、ガスケット部分からエンジンオイルが漏れる場合があります。
低温環境での運転時、エンジンルーム内の燃料供給ホースと、プレッシャーレギュレーターおよびフューエルレールとの接続部から燃料が漏れる場合があります。
On certain vehicles equipped with a 2.2 Litre turbo engine, an inadequately tightened fuel hose clamp at the fuel system pressure regulator could result in fuel leakage and provide the potential for an engine compartment fire.
An engine compartment fuel hose routed to the fuel system pressure regulator may have an inadequately tightened hose clamp. Consequence of defect: The fuel hose could leak and result in an engine compartment fire.
Inadequate weld attachment of the front frame rails to the dash panel may result in cracking of the dash panel around the shock tower and floor pan area. This may compromise the vehicle's impact protection capability. Correction: Dash panel will be secured to the frame rails by adding additional fasteners (nuts and bolts).
The welding attachments of the front frame rails to the floor pan sheet metal may not be properly welded.
The bonded disc brake linings may separate from the shoes due to a bonding deficiency which may allow corrosion degradation of the bond attachment.
Mismatched parking brake cable lengths to the rear wheels reduces braking ability of one of the rear wheels, in violation of fmvss 105.
フロントディスクブレーキキャリパーのガイドピンボルトが十分な力で締め付けられていない可能性があり、緩むおそれがあります。
電動調整式バケットシートを装備した車両では、運転席のシートフレームが4か所の取り付け部のいずれかで破損するおそれがあります。その結果、シートが前後方向または左右方向に動く可能性があります。これにより車両の操縦能力を失い、車両事故につながるおそれがあります。 是正措置:運転席のシートフレームを強化品に交換します。また、パワーアジャスター・クロスメンバーを補強します。
運転席のフレームは、4つのアタッチメントのうち1つ(前部/外側)で疲労故障を起こすことがあります。
これらの車両は、C.M.V.S.S. 1103(排気ガス)に適合していません。チョーク真空遅延バルブの詰まり。注:2.2リットルのキャブレター式エンジンを搭載した車両です。
Battery cap vents may be partially or completely blocked with plastic flashing. Consequence of defect: A build up of internal gas pressure could occur which could result in case rupture, particularly during post charging. Should a person be in the vicinity of the battery when the case ruptures, they may be injured by the released gases and/or acid.
Vehicles may have been built with a potential for the separation of the hood panel from the latch system mechanism. An improper assembly plant repair procedure may have resulted in inadequate structural integrity of the hood latch system attachment to the hood panel. Under certain driving conditions this could result in hood fly-up.
Some hood latch assemblies may have been improperly repaired at the factory, or incorrect fasteners were used. Hood latch attachment will not be strong enough and will likely weaken the inner hood panel.
The owner's manual incorrectly states that the front passenger door cannot be opened from the inside if the door is locked until the lock control handle has been pulled up. On these vehicles, the front passenger door can be opened by the inside door handle even if the door is locked.
Certain Daytona and Daytona Shelby vehicles do not comply with CMVSS 110 - tire selection and rims. (incorrect tire placard)
Incorrect tire pressure placard was installed on cars; does not comply with fmvss 110.
出典:NHTSA(米国、パブリックドメイン)、カナダ運輸省(Open Government Licence – Canada)、DVSA(英国、Open Government Licence v3.0)、RappelConso および EU Safety Gate(フランス、Licence Ouverte 2.0)、国土交通省(日本、公共データ利用規約1.0)、韓国国土交通部(car.go.kr)。