On affected vehicles The brackets used to secure the fuel pipes to the engine may not be tightened sufficiently. If the engine is repeatedly operated at high speed such as during circuit driving vibrations may cause the fuel pipe to resonate potentially causing the pipe to leak. The fuel leakage may increase the risk of fire.
On the subject vehicles the control logic which monitors the charging control program fails to divert the electrical power away from the capacitor when a fault is detected within the capacitor circuit. This can cause a short circuit inside the DCDC converter and could cause the engine to stall or overheating of the DCDC converter itself which could cause a fire. The fault is accompanied by the �i-ELOOP� warning light being illuminated on the instrument cluster along with the �i-Stop� warning light flashing The engine may in some circumstances stall and fail to restart. In extreme cases the DCDC converter could overheat and cause a fire
The engine control unit of the direct-current converter may be defective. This could result in a short circuit and damage of the converter, which can lead to a fire.
On certain passenger vehicles, the bolt attaching the horn assembly to the steering wheel hub may fail during a driver side front air bag deployment in extremely low ambient temperature.
On certain mini vans and passenger vehicles, the socket holder in the fog lights is installed in the lamp casing using pressure. During operation of the fog light, the heat from the bulb can expand the socket holder. The expansion can force the socket holder rearward. After repeatedly being subject to this expansion, if the fog light is also subjected to vibration during vehicle operation, the socket holder with the bulb holder and the wiring harness may separate from the fog light casing.
On certain vehicles, the front fog light bulb socket was installed improperly. If the vehicle continues to operate with this condition, the bulb socket and the wiring harness may separate from the fog light housing as a result of exposure to vehicle vibration. Should this occur, the bulb socket and the harness can drop inside the bumper and in the worst case, the heat generated can cause the bumper to burn. Correction: Dealer will re-install the bulb socket properly.
Certain vehicles are prone to airbag deployments in minor undercarriage impacts. Correction: Dealers will replace the SAS sensor units to reduce the possibility of unnecessary deployments in low speed undercarriage impacts.
On affected vehicles the Traction Control System (TCS)/Dynamic Stability Control (DSC) indicator light may not illuminate when abnormal yaw rate characteristics are detected due to a software diagnostic programming error. This issue does not affect vehicle drivability or braking performance.
When reversing, the vehicle's screen and warning sound may not properly alert the driver of obstacles or their distance. This can also cause the Smart Brake Support system to malfunction, increasing the risk of an accident and injuries.
Mazda North American Operations (Mazda) is recalling certain 2024-2025 Mazda MX-5 vehicles. The Traction Control System (TCS) and Dynamic Stability Control (DSC) indicator light may fail to illuminate as intended due to a software error. As such, these vehicles fail to conform to Federal Motor Vehicle Safety Standard number 126, "Electronic Stability Control Systems."
On affected vehicles when reversing obstructions may not be detected correctly due to inappropriate software in the parking assist unit which may increase the risk of an accident.
Mazda North American Operations (Mazda) is recalling certain 2016-2023 MX-5 Miata vehicles. A software error in the air bag control module may cause the front air bags to deploy with excessive force during a crash. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 208, "Occupant Crash Protection."
Mazda North American Operations(マツダ)は、2018年式Mazda3、Mazda6、2019年式CX-3、2018~2019年式MX-5、CX-5、CX-9、および2019~2020年式Mazda2の一部車両のリコールを実施しています。低圧燃料ポンプ内部のインペラに亀裂が入り変形するおそれがあり、その結果、燃料ポンプが故障する可能性があります。
出典:NHTSA(米国、パブリックドメイン)、カナダ運輸省(Open Government Licence – Canada)、DVSA(英国、Open Government Licence v3.0)、RappelConso および EU Safety Gate(フランス、Licence Ouverte 2.0)。