On certain passenger vehicles equipped with 3800 v6 (l36) engines and certain delphi fuel pressure regulators, the regulators have a much higher than usual rate of fuel leaks. A leak can allow fuel to enter the intake manifold through a vacuum line. If the engine does not start when cranked, the fuel from the leaking regulator and a mistimed spark can cause a backfire.
Certain passenger, mini vans, and sport utility vehicles have an air bag inflator on the driver's side that could fracture at a weld during a deployment.
NHTSA · USA9. Aug. 200202V222000Modelljahre 2002–2003Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
These vehicles may exhibit a backfire during engine starting that can cause breakage of the upper intake manifold. This can cause a no-start condition and possibly an engine compartment fire. Also, if a person was in the vicinity of the intake manifold when the hood was open, and this backfire condition occurred, it could result in personal injury. Correction: The pcm (powertrain control module) will be reflashed with new programming software.
Transport Canada11. Juli 19961996099Modelljahre 1996–1997Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
The upper transaxle oil cooler hose could pull out of the crimped coupling at the transaxle end of the line assembly. If this coupling were to separate, transaxle oil would spill into the engine compartment and, in the presence of an ignition source, a fire could occur. Correction: Dealers will install a new upper transaxle oil cooler line on all involved vehicles.
Transport Canada14. März 19941994051Modelljahre 1992–1993Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
The brake hydraulic unit mounting bolts on these vehicles may have been undertorqued. This condition could cause increased brake pedal travel and/or poor pedal feel if the attachment loosens. In addition, this condition could eventually lead to separation of the brake hydraulic unit from its mounting brackets resulting in brake loss and a possible vehicle crash. Correction: Hydraulic unit mounting bolts will be replaced on involved vehicles.
Transport Canada19. Apr. 19881988056Modelljahre 1987–1988Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Under a high resistance load, the in-line fuseable link located in the area of the plastic windshield washer bottle bracket, may melt down and ignite the bracket. This could result in an engine compartment fire without prior warning. Correction: Windshield washer bottle bracket will be replaced on affected vehicles.
Transport Canada26. Aug. 19871987096Modelljahre 1987Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Vehicles may have been assembled with a rubber fuel return hose which could allow a slow fuel leak while the engine is running. Under certain conditions this could result in a fire which could spread to the passenger compartment and cause burn unjuries to occupants.
Transport Canada6. Sept. 19841984099Modelljahre 1984Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Die Kraftbrems-Vakuumschläuche können nicht den bundesstaatlichen Kraftfahrzeugsicherheitsstandard Nr. 106, "Bremsschläuche", entsprechen. Das in den Schläuchen verwendete Material erfüllt nicht die Vorgaben. Der Zweck dieser Regelung lautet als "die Reduzierung von Todesfällen und Verletzungen, die durch Druckausfall oder Vakuumverlust durch Rohrbaugruppe entstehen".
Vehicle description: Passenger vehicles. These vehicles do not conform to the requirements of fmvss no. 108, "lamps, reflective devices, and associated equipment." the head lamp adjustment device horizontal adjuster may not move the head lamp reflector when the shaft is rotated in a normal manner during aiming.
On certain vehicles, the inner tie rod nuts may be loose, which could result in separation of a tie rod. Separation of a tie rod could cause unexpected steering input in some maneuvers and could cause a crash without prior warning. Correction: Dealers will check the torque of the inner tie rod nuts and if necessary, adjust the vehicle toe-in and tighten the inner tie rod nuts to the specified torque.
Transport Canada15. Nov. 19991999213Modelljahre 2000Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Certain vehicles do not comply with the requirements of CMVSS 102 - Transmission Shift Control Sequence. A retaining clip which secures the manual valve to the linkage of the transmission detent lever, may become loose and allow the link to become disconnected from the manual valve. If the link disconnects, the driver's indicated 'PRNDL' state may differ from the hydraulic state of the transmission. This does not affect the 'PARK' position, but if a driver selects 'DRIVE' and the transmission is actually in 'REVERSE', a crash could occur without warning. Correction: Dealers will replace the manual valve/link assembly with a replacement manual valve/link kit, featuring a spring-type fastener.
Transport Canada6. Mai 19991999080Modelljahre 1999Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Fahrzeugbeschreibung: Personenkraftwagen mit 4t65e-Automatikgetrieben. Diese Fahrzeuge entsprechen nicht den Anforderungen von FMVSS Nr. 102, "Schalthebel-Sequenz des Getriebes". Eine Halteklammer, die das manuelle Ventil an der Verbindung des Bremshebels des Getriebes befestigt, kann sich bei einer Kombination möglicher Fahrschaltmanöver lösen und die Verbindung vom manuellen Ventil lösen.
Diese Fahrzeuge entsprechen nicht dem C.M.V.S.S.S. 1101 – Emissionsgerät. Eine fehlerhafte Kalibrierung des Antriebsstrangsteuermoduls (pcm) kann zu unkontrolliertem Funkenklopfen, Auslösen einer Funkenanzeige, Fehlzündung, unsanftem Leerlauf, hörbarem Klopfen und/oder möglichem Motorschaden führen. Korrektur: Das Fahrzeug-PCM wird mit neuen Kalibrierungs-Softwear neu geflasht.
Certain vehicles may not comply with CMVSS 209 - Seatbelt Assemblies. Vehicles may have been assembled with one or more incorrect seat belt and/or seat belt buckle ends. If an incorrect part is used, the belt may not latch properly, increasing the risk of injury to the occupant should a vehicle crash occur. Correction: Vehicles will be inspected and incorrect parts replaced.
Transport Canada7. März 19961996045Modelljahre 1997Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
These vehicles were assembled with one or more incorrect safety belt and/or safety belt buckle ends. This does not conform with the requirements of fmvss no. 209, "seat belt assemblies."
NHTSA · USA5. März 199696V044000Modelljahre 1997Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Vehicle description: Passenger vehicles manufactured from august 1991 through july 1995. The transmission oil cooler line can separate when the vehicle is operated in low temperatures in combination with high transmission loads.
Quellen: NHTSA (USA, gemeinfrei), Transport Canada (Open Government Licence – Canada), DVSA (Vereinigtes Königreich, Open Government Licence v3.0), RappelConso und EU-Safety-Gate (Frankreich, Licence Ouverte 2.0), MLIT (Japan, Public Data License 1.0) und MOLIT (Südkorea, car.go.kr).