On certain passenger vehicles equipped with 3800 v6 (l36) engines and certain delphi fuel pressure regulators, the regulators have a much higher than usual rate of fuel leaks. A leak can allow fuel to enter the intake manifold through a vacuum line. If the engine does not start when cranked, the fuel from the leaking regulator and a mistimed spark can cause a backfire.
Under a high resistance load, the in-line fuseable link located in the area of the plastic windshield washer bottle bracket, may melt down and ignite the bracket. This could result in an engine compartment fire without prior warning. Correction: Windshield washer bottle bracket will be replaced on affected vehicles.
Transport Canada26. Aug. 19871987096Modelljahre 1987Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Fahrzeugbeschreibung: Personenkraftwagen mit 4t65e-Automatikgetrieben. Diese Fahrzeuge entsprechen nicht den Anforderungen von FMVSS Nr. 102, "Schalthebel-Sequenz des Getriebes". Eine Halteklammer, die das manuelle Ventil an der Verbindung des Bremshebels des Getriebes befestigt, kann sich bei einer Kombination möglicher Fahrschaltmanöver lösen und die Verbindung vom manuellen Ventil lösen.
Diese Fahrzeuge entsprechen nicht dem C.M.V.S.S.S. 1101 – Emissionsgerät. Eine fehlerhafte Kalibrierung des Antriebsstrangsteuermoduls (pcm) kann zu unkontrolliertem Funkenklopfen, Auslösen einer Funkenanzeige, Fehlzündung, unsanftem Leerlauf, hörbarem Klopfen und/oder möglichem Motorschaden führen. Korrektur: Das Fahrzeug-PCM wird mit neuen Kalibrierungs-Softwear neu geflasht.
Vehicle description: Passenger vehicles manufactured from august 1991 through july 1995. The transmission oil cooler line can separate when the vehicle is operated in low temperatures in combination with high transmission loads.
These vehicles were assembled with a malfunction alarm, lighting and locking (mall) module that can contain a damaged capacitor. If the capacitor is damaged, the "key in the ignition" warning chime and the driver seat belt unbuckled warning chime and indicator lamp may not work. This does not meet the requirements of fmvss no. 114, "theft protection" and fmvss no. 208, "occupant crash protection." in addition, other chime reminder functions, interior lighting controls, and power door locking features are also affected.
A spring in the head lamp portion of the head park lamp switch can fail preventing latching of the head lamp portion of the switch in the "on" position.
NHTSA · USA2. Aug. 199494V138000Modelljahre 1994–1995Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Bei Betätigung kann die Feststellbremshebelbaugruppe einen oder mehrere Zähne lösen, wodurch die Seilzugbelastung der Hinterradbremsen verringert wird.
Fahrzeuge wurden ohne eine Leitung zwischen dem digitalen Kombiinstrument und der Dimmersteuerung gebaut, wodurch nicht mindestens zwei Beleuchtungsstufen bereitgestellt wurden.
Eine kleine Nylonbuchse im Servo-Bail (Halterung) des Tempomats kann aus der Position rutschen, was zu gelegentlichen Drehzahlsteigerungen oder Dieseling führen kann. Dieser Zustand kann auch dazu führen, dass die Servostangenbaugruppe die Kugel abnutzt und an anderen Komponenten hängen bleibt, was möglicherweise zu einem steckengebliebenen Gashebel führt. Dies könnte zum Verlust der Fahrzeugkontrolle und zu einem möglichen Unfall führen. Korrektur: Ein Buchsset wird am Servo-Bail des Tempomatsteuerungs-Servos installiert.
Transport Canada4. Juli 19891989092Modelljahre 1984–1985Automatisch übersetzt · Original: EnglischDetails ansehen →
Eine kleine Nylonbuchse im Servo-Bail des Tempomats kann aus der Position rutschen, was zu intermittierenden und unerwarteten Drehzahlsteigerungen oder Dieseln (Motorlauf mit ausgeschalteter Zündung) führt.
The fuel rollover valve may not have been installed on the affected vehicles. In the event of an accident where the vehicle became inverted, a missing fuel rollover valve assembly could allow fuel spillage in excess of the amount prescribed by c.M.V.S.S. 301 - fuel system integrity. Correction: Fuel sender and pump assembly will be replaced.
Transport Canada2. Sept. 19881988126Modelljahre 1989Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Excessive accelerator cable friction may restrict the cable's free movement between the accelerator pedal and the throttle body. This could prevent the throttle from returning to idle when the accelerator pedal is released and possibly result in loss of accelerator control and a vehicle crash without prior warning. Correction: Vehicles will be inspected and accelerator control cable will be replaced if required.
Transport Canada19. Mai 19881988068Modelljahre 1987Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
These vehicles do not comply with c.M.V.S.S. 1103 - exhaust emissions. - mass airflow sensor failure - note : Vehicles with 3.0 litre and 3.8 litre engines.
Transport Canada27. Jan. 19871987007Modelljahre 1987Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
The left and rear lower control arm ball joint stud to knuckle attachment may be inadequately tightened. This could allow the ball joint stud to loosen at the knuckle attachment. A loose ball joint stud could eventually break and separate from the knuckle. This could result in loss of vehicle control and a crash without prior warning. Correction: Dealers will replace and tighten the left and right rear lower control arm ball joint stud nuts and, if necessary, replace the knuckle(s).
Transport Canada26. Sept. 19861986104Modelljahre 1986Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
The left and right rear lower control arm ball joint stud to knuckle attachment may have been inadequately tightened. Consequence of defect: This could allow the rear lower control arm ball joint stud to loosen at the knuckle attachment. A loose ball joint stud could eventually break and separate from the knuckle. Separation could cause a loss of vehicle control which could result in a vehicle crash without prior warning.
NHTSA · USA28. Aug. 198686V122000Modelljahre 1986Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Certain wire wheel packages were assembled with the incorrect wheel nuts and when installed the wheel nuts may not provide adequate wheel retention. This could result in wheel separation and loss of vehicle control.
Transport Canada15. Nov. 19851985124Modelljahre 1985Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Quellen: NHTSA (USA, gemeinfrei), Transport Canada (Open Government Licence – Canada), DVSA (Vereinigtes Königreich, Open Government Licence v3.0), RappelConso und EU-Safety-Gate (Frankreich, Licence Ouverte 2.0), MLIT (Japan, Public Data License 1.0) und MOLIT (Südkorea, car.go.kr).