Lecture libre · compte gratuit pour contribuerSuccesseur d’Anticars (2000)

Mini Hatch

2001– · 5 générations · 50 défauts documentés · 3 marchés
Générations

Les bulletins techniques (TSB) sont des instructions de réparation que les constructeurs envoient à leurs concessionnaires sur des problèmes connus. Ce ne sont pas des rappels de sécurité, mais ils confirment souvent un défaut.

Année modèle
MarchéTousEUUKNA
Hatch IV (F65/66/67) · 2024–
BulletinModéréAutreNA

Bulletin

An adjusting element installed in the soft-top bow bearing can potentially cause chafing on the convertible top.

NHTSA · bulletin constructeur11028292Années modèle 2025Affiché en anglais d’origine · traduction en attenteVoir le détail →
Hatch III · 2013–2024
BulletinModéréAutreNA

Bulletin

It is possible that the guide stem (aka rotational axis) on the wind deflector can break, upon removal and or during installation.

NHTSA · bulletin constructeur10228446Années modèle 2021Affiché en anglais d’origine · traduction en attenteVoir le détail →
Hatch III · 2013–2024
BulletinModéréAutreNA

Bulletin

Installation of Right-Hand Drive Stering Spindle in Left-Hand Drive Vehicle is No Longerr Required

NHTSA · bulletin constructeur10216773Années modèle 2014Affiché en anglais d’origine · traduction en attenteVoir le détail →
Hatch III · 2013–2024
BulletinModéréAutreNA

Bulletin

ROLLER SUNBLIND RETURN: MINI AG has requested the inspection and return of the following part number - 54 10 9 451 245. Stock should not be sold or installed on any vehicle.

NHTSA · bulletin constructeur10184596Affiché en anglais d’origine · traduction en attenteVoir le détail →
Hatch III · 2013–2024
BulletinModéréAutreNA

Bulletin

MINI PARTS BULLETIN TEC245: Stabilizer Support Inspection BMW AG has requested the inspection of the following part numbers: 31 35 6 778 827. Stock should not be sold or installed on any vehicle until inspection has been completed.

NHTSA · bulletin constructeur10177633Affiché en anglais d’origine · traduction en attenteVoir le détail →
Hatch III · 2013–2024
BulletinModéréAutreNA

Bulletin

MINI PARTS BULLETIN TEC250: Mechanical Belt Tensioner Inspection BMW AG has requested the inspection of the following part numbers: 11 28 8 580 360. Stock should not be sold or installed on any vehicle until inspection has been completed.

NHTSA · bulletin constructeur10177635Affiché en anglais d’origine · traduction en attenteVoir le détail →
Hatch III · 2013–2024
BulletinModéréAutreNA

Bulletin

MINI PARTS BULLETIN TEC228: Control Unit RDC Inspection BMW AG has requested the inspection of the following part number: 36 10 6 868 194 Stock should not be sold or installed on any vehicle until inspection has been performed. Concerned are all parts produced from January 02 2020 to February 16 2020. Please return all affected part(s) to your facing Regional Distribution Center (RDC).

NHTSA · bulletin constructeur10174321Affiché en anglais d’origine · traduction en attenteVoir le détail →
Hatch III · 2013–2024
BulletinModéréAutreNA

Bulletin

MINI PARTS BULLETIN TEC233: Fan Shroud Inspection BMW AG has requested the inspection of the following part number: 17 42 8 742 712 Stock should not be sold or installed on any vehicle until inspection has been completed. Concerned are all parts delivered and shipped so far. Please return all affected part(s) to your facing Regional Distribution Center (RDC).

NHTSA · bulletin constructeur10174322Affiché en anglais d’origine · traduction en attenteVoir le détail →
Hatch III · 2013–2024
BulletinModéréAutreNA

Bulletin

MINI PARTS BULLETIN TEC213 Bowden Cable Inspection: BMW AG has requested the inspection of the following part numbers: 51 21 7 296 459 / 51 21 7 320 309 / 51 21 7 364 596 Stock should not be sold or installed on any vehicle until inspection has been completed. Concerned are all parts delivered and shipped so far. Please return all part(s) to your facing Regional Distribution Center (RDC).

NHTSA · bulletin constructeur10171508Affiché en anglais d’origine · traduction en attenteVoir le détail →
Hatch III · 2013–2024
BulletinModéréAutreNA

Bulletin

MINI PARTS BULLETIN TEC214 Intake Duct Return: BMW AG has requested the return of the following part number: 17 51 1 524 439 Stock should not be sold or installed on any vehicle. Concerned are all parts delivered and shipped so far. Please return all part(s) to your facing Regional Distribution Center (RDC).

NHTSA · bulletin constructeur10171509Affiché en anglais d’origine · traduction en attenteVoir le détail →
Hatch III · 2013–2024
BulletinModéréAutreNA

Bulletin

BMW Parts Bulletin TEC195 USB Socket Inspection BMW AG has requested the inspection of the following part numbers: 84 10 8 711 938 / 84 10 8 711 939 / 84 10 8 711 940 Stock should not be sold or installed on any vehicle until inspection has been completed.

NHTSA · bulletin constructeur10169477Affiché en anglais d’origine · traduction en attenteVoir le détail →
Hatch III · 2013–2024
BulletinModéréAutreNA

Bulletin

MINI PARTS BULLETIN TEC152 Tank Breather Valve Return. MINI AG has requested the inspection of the following part number: 13 90 7 621 174. Stock should not be sold or installed on any vehicle.

NHTSA · bulletin constructeur10153716Affiché en anglais d’origine · traduction en attenteVoir le détail →
Hatch II · 2006–2013Hatch III · 2013–2024
BulletinModéréAutreNA

Bulletin

"White Wear Marks on Canvas Top. Wear marks appear on the convertible top on the left and/or right side C-pillar areas. A For vehicles produced to December 12, 2011 1. Replace the defective canvas convertible top. Refer to ISTA Repair Instruction 54 34 120, ""Replacing soft top fabric."" Note: The following repair steps must be performed before the new top is installed to prevent a repeat repair for wear marks. 2. With the defective canvas cover removed, the current main pillars must be replaced. Refer to ISTA Repair Instruction 54 34 996, ""Replacing left or right main pillar."" 3. The current locking mechanisms and bump stops must be replaced as well. Refer to ISTA Repair Instruction 54 34 196, ""Removing and installing / replacing both stowage locks."" The repair kit* needed is listed below. 7. Reinstall the removed parts in the reverse order of their removal. 8. Operate the top several times to quality check the repair."

NHTSA · bulletin constructeur10149505Années modèle 2009–2014Affiché en anglais d’origine · traduction en attenteVoir le détail →
Hatch III · 2013–2024
BulletinModéréAutreNA

Bulletin

WIND DEFLECTOR DAMAGED. A rattle may be heard from the wind deflector while driving or, the retaining pins may be broken when installing wind deflector. Retaining pins in wind deflector are broken.

NHTSA · bulletin constructeur10146928Années modèle 2016Affiché en anglais d’origine · traduction en attenteVoir le détail →
Hatch III · 2013–2024
BulletinModéréAutreNA

Bulletin

SERVICE ACTION: RUBBER STRIP ON REAR SIDE WINDOW TRIM IS CRACKED. The rubber strip on the rear side window trim may crack. In some cases a gap may be evident on the rubber trim strip. Results are cosmetic- no water leakage or sound intrusion. Combination of unfavorable materials.

NHTSA · bulletin constructeur10146871Années modèle 2016–2017Affiché en anglais d’origine · traduction en attenteVoir le détail →
Hatch III · 2013–2024
BulletinModéréAutreNA

Bulletin

Water Ingress In Footwell Area From A/C Condensate Drain This Service Information bulletin supersedes SI M64 01 16 dated March 2016.. Damp front foot-well carpet after long period of air conditioning use. Musty odor in the vehicle (moldy, old socks, laundry room). The A/C condensate drain hose is blocked by the heatshield. The A/C condensate drain hose is not attached properly to the housing. The A/C condensate drain hose was damaged during installation or previous repair.

NHTSA · bulletin constructeur10146874Années modèle 2016Affiché en anglais d’origine · traduction en attenteVoir le détail →
Hatch II · 2006–2013
BulletinModéréAutreNA

Bulletin

Mini: Check svs function. On certain vehicles, the voice input system (svs sa 620) does not function. The svs was not installed in the vehicles. *pe

NHTSA · bulletin constructeur10026789Années modèle 2008Affiché en anglais d’origine · traduction en attenteVoir le détail →
Hatch III · 2013–2024
BulletinModéréAutreNA

Bulletin

Coolant expansion tank leaks. Launch up to 01/03 production. *tt

NHTSA · bulletin constructeur10001079Affiché en anglais d’origine · traduction en attenteVoir le détail →
Hatch IV (F65/66/67) · 2024–
BulletinMineurAutreNA

Bulletin

If MINI Personal Assistant is active in the vehicle, once the customer exits the vehicle and a new key cyclestarts, the MINI Personal Assistant is deactivated and no longer available.

NHTSA · bulletin constructeur11034483Années modèle 2025Affiché en anglais d’origine · traduction en attenteVoir le détail →
Hatch IV (F65/66/67) · 2024–
BulletinMineurAutreNA

Bulletin

During vehicle start-up the Secure Element (SE) of the BCP may fail causing communication errors. TheCheck Control message Drive carefully. Driving stabilisation. will appear. In addition, the fault memoryentries below will be stored within 40 seconds of each other. ACSM: 02010A - Coding: Coding data not qualified VIP: 02390A - VIP control unit: Coding data not released, signature IB: 02290A - DSC control unit: Coding data not released, signature HKFM: 020D0A - HKFM: Coding data are not qualified

NHTSA · bulletin constructeur11034472Années modèle 2026Affiché en anglais d’origine · traduction en attenteVoir le détail →
Hatch II · 2006–2013
BulletinMineurAutreNA

Bulletin

Retour PDC de l’unité de contrôle

NHTSA · bulletin constructeur11033151Années modèle 2010–2011Traduit automatiquement · original : anglaisVoir le détail →
Hatch IV (F65/66/67) · 2024–
BulletinMineurAutreNA

Bulletin

During vehicle start-up the Secure Element (SE) of the BCP may fail causing communication errors. TheCheck Control message Drive carefully. Driving stabilisation. will appear. In addition, the fault memoryentries below will be stored within 40 seconds of each other. ACSM: 02010A - Coding: Coding data not qualified VIP: 02390A - VIP control unit: Coding data not released, signature IB: 02290A - DSC control unit: Coding data not released, signature HKFM: 020D0A - HKFM: Coding data are not qualified

NHTSA · bulletin constructeur11029097Années modèle 2025Affiché en anglais d’origine · traduction en attenteVoir le détail →
Hatch IV (F65/66/67) · 2024–
BulletinMineurAutreNA

Bulletin

During vehicle start-up the Secure Element (SE) of the BCP may fail causing communication errors. TheCheck Control message Drive carefully. Driving stabilisation. will appear. In addition, the fault memoryentries below will be stored within 40 seconds of each other. ACSM: 02010A - Coding: Coding data not qualified VIP: 02390A - VIP control unit: Coding data not released, signature IB: 02290A - DSC control unit: Coding data not released, signature HKFM: 020D0A - HKFM: Coding data are not qualified

NHTSA · bulletin constructeur11028930Années modèle 2025Affiché en anglais d’origine · traduction en attenteVoir le détail →
Hatch I · 2001–2006
BulletinMineurAutreNA

Bulletin

Adhesive Film Return

NHTSA · bulletin constructeur11025847Années modèle 2001Affiché en anglais d’origine · traduction en attenteVoir le détail →
Hatch III · 2013–2024
BulletinMineurAutreNA

Bulletin

Gasket Set Return

NHTSA · bulletin constructeur11024734Années modèle 2022Affiché en anglais d’origine · traduction en attenteVoir le détail →
Plus anciens →

Sources : NHTSA (États-Unis, domaine public), Transports Canada (Licence du gouvernement ouvert – Canada), DVSA (Royaume-Uni, Open Government Licence v3.0), RappelConso et Safety Gate de l'UE (France, Licence Ouverte 2.0), MLIT (Japon, licence de données publiques 1.0) et MOLIT (Corée du Sud, car.go.kr).